solidification effect 中文意思是什麼

solidification effect 解釋
滿實效應
  • solidification : n. 團結；凝固；【化學】固體化（作用）。
  • effect : n 1 結果。2 效能，效果，效力，效應，作用，功效；影響。3 感觸，印象；外觀，現象。4 旨趣，意義。5 ...
  1. Abstract : the current status of research work on intermetallic compound dispersoid in rapidly solidified elevated temperature aluminum alloys is reviewed. the dispersoid existing in common elevated temperature aluminum allo ys, effect of rapid solidification processing on the formation of dispersoid and their thermal stability are discribed

    文摘:綜述了快速凝固耐熱鋁合金中金屬間化合物彌散相的研究現狀，介紹了常見耐熱鋁合金中存在的彌散相、快速凝固工藝對彌散相形成的影響和彌散相的熱穩定性及其影響因素。
  2. In experiment, the dsc technique was used to analyze the effect of electric fields on the precipitate kinetic of al - li alloy solutionized with electric fields. the energy spectrum, tem and sem techniques are employed to investigate the elements solution, precipitates, fracture character, conductivity and vickers hardness. also, the solidification of al - cu eutectic alloy was conducted with the influence of electric fields

    在實驗上，利用dsc熱分析技術，分析了電場作用對al - li合金相析出動力學的影響；採用能譜成份檢測，透射電鏡和掃描電鏡等多種微觀檢測手段，對鋁合金的析出相，斷裂特徵、合金電導率和維氏硬度等性能在電場作用下的變化進行了系統的研究，並觀察了al - cu共晶合金在電場作用下的凝固組織。
  3. Directional solidification of zn - 2. 75 cu alloy and the effect of acrt forced convection

    合金定向凝固組織及對流的影響
  4. The effect of solidification rate on eutectic microstructure of high chromium cast iron

    凝固速度對高鉻鑄鐵共晶組織的影響
  5. The effect of solidification rate on the solidified structure, cooperation growth zone and microstructures such as tac rods volume fraction, tac rods average spacing, tac average transverse area and y phase in this eutectic composite were systematically investigated with lmc. the relationship between solidification processing controlling and solidification microstructure was established

    藉助金相技術、電鏡技術、圖象處理技術等多種分析測試手段，考察試樣的界面形態、組織特徵以及共晶形貌等多方面的凝固特性，建立了凝固過程式控制制與凝固組織的對應關系。
  6. Temperature field of hollow ingot solidification is simulated by fem. to different mould, effect of heat transfer coefficient between inner sleeve and cooling medium and thickness of core refractory on final position of solidification, the highest temperature of inner sleeve against cooling medium, and shrinkage cavity and porosity are compared. in addition, change of temperature in typical position of core refractory is also compared

    對空心鋼錠凝固過程的溫度場進行了有限元分析，對不同錠型結構的芯部換熱系數、耐火材料厚度對最終凝固位置、內筒壁最高溫度及縮孔疏鬆的影響進行了對比，並討論了耐火材料典型部位的溫度隨凝固時間的變化。
  7. Abstract : temperature field of hollow ingot solidification is simulated by fem. to different mould, effect of heat transfer coefficient between inner sleeve and cooling medium and thickness of core refractory on final position of solidification, the highest temperature of inner sleeve against cooling medium, and shrinkage cavity and porosity are compared. in addition, change of temperature in typical position of core refractory is also compared

    文摘:對空心鋼錠凝固過程的溫度場進行了有限元分析，對不同錠型結構的芯部換熱系數、耐火材料厚度對最終凝固位置、內筒壁最高溫度及縮孔疏鬆的影響進行了對比，並討論了耐火材料典型部位的溫度隨凝固時間的變化。
  8. Progress in research on phase - field simulations of the effect of convection in solidification

    凝固過程中對流效應的相場模擬研究進展
  9. Effect of electromagnetic stirring on solidification structure of casting

    電磁攪拌對鑄錠凝固組織的影響
  10. The effect of ultrasonic melt pretreatment on the solidification structure and mechanical properties of 7055 aluminum alloy was investigated

    摘要7055鋁合金液相線625以上，對7055銘合金熔體進行超聲波預處理后模鑄，研究超聲熔體預處理對7055鋁合金凝固組織和力學性能的影響。
  11. ( 2 ) quantitively studied the solidification effect of different organic matter content silt, make clear the relationship of organic matter content and solidification effect

    （ 2 ）定量的研究有機質含量不同的淤泥固化效果，明確了有機質含量與淤泥固化效果之間的關系。
  12. Among dredged sediments, quite a portion come from polluted lakes and rivers, because such polluted sediments usually contain some organic matters. although the content of organic matters are much less than silt, but it seriously affected silt solidification effect, and this is a new subject in silt solidification research

    固化技術是疏浚淤泥資源化利用的一個重要途徑，但是在疏浚淤泥當中，有相當一部分淤泥來自污染嚴重湖泊、河道，這些污染嚴重的淤泥當中含有一定量的有機質，這些有機質會對固化效果產生較大的影響。
  13. ( 4 ) as to different organic silt, make use of cement - gypsum compound material as solidification additives for silt solidification, comparatively studied the solidification effect, summarized the improving rule of gypsum to cement and proposed a method for treating high organic matter content silt

    （ 4 ）對不同有機質淤泥，採用水泥?石膏進復合型固化材料進行固化，對固化效果進行了對比研究，對石膏促進固化效果的規律進行了總結，從而提出了大量發生的有機質含量偏高的疏浚淤泥固化問題。
  14. The main works of this paper are as follows : ( 1 ) studied two different organic content silt wuxi wulihu silt and shenzhen dayawan silt through single material ( cement ) solidification experiments. compared the solidification effect of the two silt, through the experiments conferred that organic matter remarkable affect cement solidification effect

    本文的主要工作如下： （ 1 ）對于有機質含量明顯不同的無錫五里湖淤泥與深圳大亞灣淤泥進行了單一水泥的固化試驗，對固化效果進行了比較，指出有機質會對淤泥的固化有效有顯著的影響。
  15. In this paper, the influence of organic matter content on silt solidification effect was focused on. through laboratory experiments, studied the influence causing and degree of organic matter affect silt solidification. disclosed the relationship of organic matter content and solidification effect, and proposed a method for high organic silt disposing

    本文首先通過室內試驗研究有機質對淤泥固化效果的影響，建立有機質含量和固化效果之間的定量關系，初步揭示了有機質含量對淤泥固化效果影響的機理，並通過採用復合型固化材料技術進一步解決了有機質含量較高的疏浚淤泥應當如何固化的問題。
  16. Effect of gas pressure on pore distribution of lotus - type porous magnesium fabricated by unidirectional solidification

    氣壓對定向凝固藕狀多孔鎂的氣孔分佈影響
  17. Effect on structure solidification of q235 small squaresteel blanks continuously casted after electro - pulse inoculatedly modification

    235鋼小方坯凝固組織的影響
  18. Effect of solidification conditions on microstructure of al - fe cast alloy

    凝固條件對鋁鐵合金凝固組織的影響
分享友人
分享到 Line

分享到臉書