solution opening 中文意思是什麼

solution opening 解釋
溶孔
  • solution : n. 1. 溶解；溶液，溶體，溶劑。2. （補輪胎用的）橡膠水；〈美國〉藥水。3. 解決，解答 （of; for; to）; 解釋；（數學等的）解法，解式。4. 免除，解除。5. 【醫學】消散，消退。
  • opening : n 1 開，開放；開始，著手；開端，開頭；開場，開幕。2 口，孔，縫，洞；空隙；通路。3 空地，空場；〈...
  1. We must take a comprehensive approach to seek a temporary solution and a permanent cure and combine the rule by law with the rule by virtue so as to enable every party official to withstand the test of reform ， opening - up and being in power as well as the test of power ， money and badger games

    我們要積極推行標本兼治，綜合治理的方針，把以法治國和以德治國結合起來，使每個黨員幹部經得起改革開放和執政的考驗，經得起權利，金錢和美色的考驗。
  2. The author considers the legal system of intellectual property right is opening so that the domain name should be included as a kind of independent right. in the following parts of the essay, the author explores the fundamental causes of conflict and re - classifies the types of conflict between domain name and trademark, reanalyzes the similarity and the difference between domain name and trademark, makes comparison between the three major domain name dispute resolutions that have already been provided ( udrp, acpa and the domain name disputes solution of china ), it can provide ground for an effective method for solution. at last, the thesis baldly points out that it should stand an independent legal status in ip law

    故，筆者欲突破在商標及商標法框架下研究域名的思維定勢，重新審視域名法律地位、分析其法律屬性;以域名與商標沖突為典型，研究導致沖突的原因;從平等中立的角度，以貫穿經典案例的方法重新劃分沖突分類:以橫向比較分析的研究方法評介全球具有代表性的沖突解決方案和我國新的域名政策以及司法解釋，為正確提出解決方案建立基礎;探討域名爭議解決的主要原則，分析域名在我國的立法模式;最後，筆者將在全文分析的基礎上，嘗試提出域名權利問題，以期能從根本上尋求解決域名的法律保護以及沖突的公平解決的合理機制。
  3. Adopting rational agent characteristic could add the auditor into corporate contract to educing optimum solution ; opening out the auditor incentive factors in auditing demand theory and the monitor mechanism of auditing. a multi - agent corporate model including the firm owner, the manager and the auditor of the corporate is analyzed in the paper, the conclusions are : educing the optimum solution of model which could prevent the manager and the auditor becoming collusive or skulked ; clarifying the relationship between monitoring of the firm owner and working of the auditor, and illustrating the behavior combination of optimum solution ; further analyzing the relationship among monitoring degree, punishment of auditor and the auditor risk. adapting the model from a single term to serial terms, and adding the non - monetary utility of auditor - - - reputation into the model ; describing behavior of the firm owner in reality and clarifying the necessity of monitoring by the owner and the environment improvements it needs

    論文採用所有者經理人審計師多代理人模型為基礎進行分析，主要成果是：得出能夠防止共謀和不努力工作的模型最優解集合；通過因素分析闡明審計師工作努力程度與所有者監控力度之間的直接關系，以及審計合約最優解的行為策略組合及其制定順序；引申分析所有者監控力度與審計風險、審計師懲罰力度之間的關系；成功的將模型從單一期間擴展到多期間情況，並且將審計師聲譽等非現金收入形式的效用影響加入到模型當中；通過分析審計實務中的所有者行為特徵說明所有者對審計師工作實施監控的必要性，以及實現該監控所需的條件。
  4. Establishing an human spine dynamic model is an significan event to study spine injured biomechanics of pilot " s ejective injury, parachute opening, landing and study the endurance to impact loading on human spine. in this paper, the huston " s method of kane " s equations is developed so that it can be applied to the multibodysystem including translation between the bodyies. the dynamic model of human spine is provided basing on these theories, while the big movement of spine is considered. the deformation of vetebra is far smaller comparing with the intervetebra disc, so the spine is considered into multibodysystem including rigid bodies ( vetebra ) and the flexible bodies ( intervetebra disc ). the computer solution correspond with the results of the large scale human impact test. the rigid coefficient factors and the damping factor of intervetebra joints are obtained

    人體脊柱動力學模型的建立對研究飛行員彈射救生、傘兵跳傘開傘、著陸等脊柱損傷的生物力學以及研究人體脊柱耐受沖擊載荷的極限問題都具有重要意義.首先發展了凱恩方程的休斯頓方法，使其可應用於變形體連接的多體系統，並以此理論為依據建立人體整椎脊柱沖擊動力學模型，此時考慮脊柱的大位移運動，每個椎骨的變形相對椎間盤的變形小得多，把脊柱看成由剛體（椎骨）和變形體（椎間盤）組成的多體系統.並以大型真人坐姿沖擊實驗結果進行了擬合，最後得到腰椎間關節剛度系數因子和阻尼系數因子
  5. Modeling the general solid web continuous box girder and opening - in - web ( open web ) continuous box girder by ansys finite element modeling tool, node stress of governing section and corresponding shear lag values are analyzed. the solution is validated by comparing with variational results and modeling test values. based on the model, the section shear lag induced by dead load, prestress tendons and car loads under the most unfavorable condition and lateral symmetry are also approached. the influence of shear lag effect in double - level continuous box girder is considered with opening - in - web and the web location. the analysis indicates that double - level - load arouses less shear lag effect than one - level - load. when self - weight and prestressed tendons act on together, the shear lag effect on box girder take on a evidently change

    基於所建立的有限元模型，本文分別對實腹和腹板開孔兩種箱梁在恆載、車載、預應力荷載作用時，各主要截面的剪力滯效應進行分析，通過施加縱向最不利的和橫向對稱的車輛荷載，研究實腹連續箱梁和空腹連續箱梁在承受雙層荷載和單層荷載時引起的剪力滯效應，並考慮腹板開孔及開孔位置對于連續箱梁剪力滯效應的影響。分析表明，雙層車載對于箱梁引起的剪力滯系數比單層車載的影響要小，對于箱梁中存在引起的剪力滯后現象有一定的改善作用。
  6. Lesson 1 : opening and examining the tutorial solution

    >第1課：打開並測試「教程」解決方案
  7. Based on the fundamental solution of two perfectly bonded elastic halfspaces, and using the boundary integral equation method and the finite - part integral concepts, the problem is reduced to a hypersingular integral equation in which the unknown function is the crack opening displacement discontinuity

    首先根據雙材料空間的彈性力學基本解，使用邊界積分方程方法，在有限部積分的意義下導出了以裂紋面位移間斷為未知函數的超奇異積分方程。
  8. In this paper are introduced how to increase detect efficiency and clear efficiency of foreign matter detecting and clearing device, give some solution of foreign matter detecting, think that foreign detecting and clearing device installed in opening and picking process combine electronic clearer with foreign matter detecting function in winding process can increase detecting efficiency and clearing efficiency

    摘要敘述了如何提高異纖檢出機的檢出率和排除率問題，提出了幾種解決方案，並認為開清棉工序的異纖檢測機和絡筒工序的帶異纖檢測功能的電子清紗器結合使用可有效提高異纖檢測率和清除率。
  9. It consists of two part, the one is hardware : integrating the system of the arc welding robot ' s hardwares and its working principles, separating and extracting the original system ' s control signals, designing the control system openly and its working principles, constructing the structure and principle of the motion card based on dsp, designing the telecontroling teaching box or control panel of touching screen based on usb interface, applying for some software and hardware measures on control system ' s anti - jamming ; the other is software : putting forward the three levels opening software structure model of arc welding, comparing the opening of software structure model between osaca and ours, putting forward the solutions of the pri and communication among the threads of software system ' s modules, using the dll ' s techniques to solve software ' s module design and putting forward the frame codes, bringing forward the path planning software ' s realization by cp + ptp mode, discussing the real time of windows2000 operating system and advancing its solution

    具體包括，硬體部分：弧焊機器人硬體整體系統集成及其工作原理，原系統控制信號的分離和提取，控制系統的開放式設計及組成原理，基於dsp的運動控制卡結構和原理，基於usb介面的觸摸屏式遙控示教盒控制面板的設計，系統抗干擾的軟、硬體措施；軟體部分：提出了弧焊機器人的三層開放式軟體結構模型，軟體結構模型與osaca的模型進行開放性比較，給出軟體系統各模塊線程間優先級和通訊的解決方案，使用動態鏈接庫技術實現軟體模塊化設計並給出了框架代碼，給出了cp + ptp方式的軌跡規劃軟體實現過程， windows2000操作系統實時性問題的討論及解決方案。
  10. With the opening - up reform and economic development, the radio is increasing sharply, frequencies spectrum resource of radio are hi short day, radio interference takes place frequently, take that the radio monitors is more and more heavier the construction of the monitoring system of rsadio is problem which is in need of solution in front of the managements organization of radio at all levels

    隨著改革開放和經濟的發展，無線電設臺激增，無線電頻譜資源日益緊張，無線電干擾時有發生，無線電監測的任務也愈來愈重，無線電監測系統的建設是擺在各級無線電管理機構面前亟待解決的問題。
  11. The " quick fix " solution ? opening the cabinet doors ? allowed dirt to enter the cabinets and created a potential safety hazard

    過去，只有一個的解決辦法：就是打開屏櫃的門散熱，這樣就勢必造成了灰塵進入屏櫃，而又成為更大的安全隱患。
  12. A choice of significance is initiated in the paper that active pushing of the opening of power sales market as a solution in the present unification of transmission, distribution and sales in such enterprises

    本文針對當前電網企業輸配售一體化的格局，提出積極推進售電側市場放開，應是當前電網企業深化改革的重要選擇。
  13. Reverse - engineering or opening a web service project enabled with web services enhancement settings from within a solution containing an application diagram will lock the diagram if wse is not installed

    如果未安裝web服務增強（ wse ） ，則從包含應用程序關系圖的解決方案中打開啟用wse設置的web服務項目或對其進行反向工程將鎖定該關系圖。
分享友人
分享到 Line

分享到臉書