solving linear equation 中文意思是什麼
solving linear equation
解釋
坐標幾何學-
In the self - calibration scheme, the thesis emphasizes the accuracy of camera intrinsic and extrinsic parameters. we presents an accurate f method based on corresponding point adjustment. the method adjusts coresponding points according to the fixedness of projective transformed cross ratio, then calculates f matrix accurately through linear and non - linear methods. when computing intrinsic parameter, a matrix, we simplify the step, and stress on the two important parameters of a. the result will be getten through solving kruppa equation based on svd decomposition. in order to compute extrinsic parameters, we use linear method to get initial r and t, then apply non - linear method to accurate them
提出了基於匹配點調整的f求精方法，先根據攝影交比不見性對手工選擇的匹配點進行調整，再用線性、非線性結合的方法求精f矩陣；在計算內部參數a中，進行了一定的簡化，把重心放在a中重要的兩個參數上，用svd分解法計算kruppa方程；在計算外部參數時，首先用線性法求解r 、 t ，然後再用非線性法迭代求精。 -
The thermodynamic free energy on mixing and the spinodal equation in ternary homopolymer blends were obtained by making plausible approximation based on flory ' s equation of state theory. because of the non - linear behavior of the spinodal equation, a numerical solution approach was used and succeeded in solving the problem. spinodal of polystyrene ( ps ) / poly ( vinyl methyl ether ) ( pvme ) / poly ( 2, 6 - dimethyl - 1, 4 - phenylene oxide ) ( ppe ) were simulated over a wide temperature range and the calculated result was coincidence with that of the literature
將上述方法用於已知狀態方程參數的二元均聚共混體系聚苯乙烯（ ps ） /聚甲基乙烯基醚（ pvme ） ，三元均聚共混體系聚苯乙烯（ ps ） /聚甲基乙烯基醚（ pvme ） /聚2 ， 6 -二甲基1 ， 4 -苯撐氧（ ppe ） ，得到一系列不同溫度下的spinodal相圖，預測結果與文獻報道吻合，在此基礎上進一步研究了聚合物的分子量對體系相行為的影響。 -
By reformulating the kkt system as a constrained equation, the algorithm generates the search direction by solving a linear equation at each iteration
通過將問題的kkt系統轉化成一個約束方程，演算法在每步迭代只需解一個線性方程組即可得到搜索方向。 -
In solving the helmholtz equation in the acoustical waveguides with a curved bottom, slow convergence may occurs when the linear local orthogonal transformation is adopted. in this paper, a class of nonlinear local orthogonal transformations ( nlot ) is proposed. it is an approach to improve the slow convergence mentioned above
本文嘗試通過在深度方向選取非線性局部正交變換，將曲底求解區域化為平坦求解區域，然後求解helmholtz方程的辦法，來改善用線性（深度方向）局部正交變換時，步進求解時會出現的局部收斂慢的問題。 -
Established the system of coordinates of roll testing, getting the parameters of equation of tooth face by solving the non - linear equations set ; according to the differential geometry and meshing principle, deduce the curvature parameters of tooth face and tooth profile, and get the parameters of instantaneous contact ellipse. emulate the contact trace and contact area of the working tooth face, and drawing the instantaneous drive ratio error curve
建立了克林貝格擺線齒錐齒輪嚙合分析的對滾模型，通過對非線性方程組的迭代求解，得到齒面方程的各個參數;由微分幾何和切齒嚙合原理推導了齒面上齒廓和齒線方向的曲率參數，得到了瞬時接觸橢圓的參數。根據設計參數和機床調整參數繪制了工作齒面的接觸軌跡和接觸區圖形，並求得了瞬時傳動比的誤差曲線。 -
Basing on the statistical inaming t ' heory ( slt ), the thesis discusses the svm problems in linearly separable case, lineariy non - separable case and non - linear separable case, and induces a convex quadratic programming ( qp ) problem with an equation constrain and non - equation constrains. then one program on solving the op problem is proposed
概述了統計學習理論的主要內容，推導了支持向量機方法在文本線性可分、線性不可分和非線性可分情況下實現分類的數學公式，將學習問題轉化為一個在等式約束和不等式約束下的凸二次優化問題，總結了求解的過程。 -
According to the computation process of the fem and assumption, associating of the fem mesh that have separated and the grouting stress diffusion equation, the integral stiffness matrix and the load matrix can be formatted, then the displacement of the nodal point can be got after solving the simultaneous linear equations. and then the grouting parameter can be computed and analyzed
然後，依據有限元法的計算步驟和所作的假設，結合已經離散化了的網格、灌漿壓力擴散衰減公式，形成整體剛度矩陣、荷載矩陣，經求解后得到結點的位移，並依此計算分析灌漿參數。 -
Then each. cable - strut - membrane unit is analyzed by adopt the non - linear finite element analytical method. according to virtual work principle, the equation of solving is formed, from the timid displacement principle, derive and happen to ask the equation of solving. through the whole n - r method, cooperative form - finding of the cable - strut - membrane structure will be realized
然後，採用非線性有限元分析方法，對各個單元進行分析，由虛位移原理，推導出求解方程，通過全n - r法迭代，實現索桿膜結構的協同找形。 -
The new method of solving special integral of n order linear inhomogeneous differential equation with constant coefficients
階常系數線性一般非齊次微分方程特解公式 -
To assure astringency, some technologies have been used such as iterative penality function methods, assemblage mass matrix, reduced integration algoritlun, newton iteration method with parameters for non - linear equation set, introducing relax factors and double steps solution and so on, and an algorithin for solving the nonlinear equation set of flow field by fem has been presented
基於有限元法建立了流場求解列式，為保證其收斂性，採用了迭代罰函數法，集中質量矩陣，縮減積分計算，帶參數的newton迭代求解，引入松馳因子及雙層解法等技術，提出了一套適合流場有限元方程計算的非線性方程求解方法。 -
( 1 ) equation is deduced when input is complete correlation, frequency response function has not solution ( order of numerator of polynomial need not be defined ). we can directly use superposition principle of linear system to obtain response without solving frequency response function
（ 1 ）當輸入部分相關時，輸入矩陣為非對角矩陣，其頻響函數不能直接求得，本文推導了解決此類問題的公式。 -
This paper pointed out and demonstrated the mistake and one - sidedness of huang jia - ying ' s and wang hua - yi ' s theories about gain solution between non - input nodes and other arbitrary nodes and put forward general methods of solving the problem by using linear equation system and mason ' s gain formula according to the equivalence relation of topography and linear equation system
摘要指出了黃家英和王劃一兩位先生在討論非輸入結點與任意結點間增益時存在著的錯誤性、片面性；並利用拓撲圖與線性方程組的等價關系，得出運用線形方程組求解的一般性方法，同時對兩位先生出現的問題作了證明；最後又給出了用梅遜公式求解的一般性方法。 -
Preprocessing of smoothing often brings about blurred image. in this paper, we add linear masks to the minutia preserving smoot - hing algorithm which based on solving a nonlinear diffusion equation. compared with other existing methods, this improved algorithm has better performance preprocessing of noisy images
一般的平滑演算法往往因過度平滑使得圖像細節特徵模糊，針對這一情況，在傳統的基於偏微分方程的演算法中，加入對大麴率邊界點進行線性模板匹配的改進，對比現存的保邊界平滑演算法，實驗結果表明，改進的演算法優于其他演算法。 -
The method of undetermined coefficients is the general method of solving a linear differential equation with constant coefficients of the second order
摘要二階常系數線性微分方程可用常規方法待定系數法求解。 -
The solving theorem of second order linear parabolic equation changeable into ordinary differential equation
二階線性拋物型方程可變換為常微分方程求解定理 -
Its contents include results on the finite element method for the dynamics equations, the lumped mass finite element methods and error estimations for solving the parabolic problem, fourth order nonstationary elliptic equation, the nonstationary stokes problem and bingham fluid problem, the finite element methods and error estimations for solving linear and nonlinear the hyperbolic equations
內容包括關于求解工程力學方程有限元方法的最新結果。解拋物問題、非穩態四階橢圓方程、 stokes問題以及管道bingham流的質量集中有限元方法及其誤差估計，解線性與非線性雙曲型方程的有限元方法及其誤差估計。 -
By using the lagrange multiplier approach, the design procedure is formulated as solving the linear equation iteratively to obtain the desirable prototype filter coefficient vector
使用拉格朗日乘數方法，演算法通過迭代求解線性方程來獲得期望的原型濾波器系數矢量。 -
One is to derive the optimal prediction and the other is to find its necessary and sufficient conditions. there is, however, a more design matrix in this model than is in multivariate linear model, which has caused difficulties such as solving a exceptional unlinear matrix equation groups especially when deriving the optimal prediction
但是因為一般增長曲線模型比多元線性模型多一個設計陣，這就給研究帶來了很大的困難，特別是在求解模型的最優預測時，遇到了一類特殊的非線性矩陣方程組，所以在一般情況下我們既無法求出模型的最優預測，也無法找到存在最優預測的充要條件 -
Solving non neat sequense linear equation by removing constant term
消去常數項法解非齊次線性方程組 -
Solving a kind of 2 - order linear differential equation with variable coefficients
二階線性齊次微分方程的一個可積定理
分享友人