split ratio 中文意思是什麼

split ratio 解釋
分流比
  • split : n 斯普利特〈前南斯拉夫港市〉。vt (split;splitting)1 劈開,切開,割裂,扯裂;剖分。2 使分裂,使...
  • ratio : n. (pl. ratios)1. 比,比率,比值;比例;系數。2. 【經濟學】復本位制中金銀的法定比價。vt. 1. 用比例方式表達;求出…的比值;使…成比例。2. 將(相片)按比例放大或縮小。
  1. A hundred and ninety - four test pieces are tested which involved six kinds of slenderness ratios and five cubic contents, and studies are done on the influence of cubic content and slenderness ratio to compressive strength, split strength and flexural strength of concrete, which lays the foundation of further study

    完成了涉及6種長徑比和5種體積摻量的194個試件的試驗,對短切玄武巖纖維體積摻量、長徑比等因素對混凝土抗壓、劈拉、彎拉強度的影響進行研究,積累了大量的數據,為進一步研究奠定了基礎、積累了經驗。
  2. The 3 batches with 7 groups of prism concrete test specimens and the 3 batches with 22 groups of cube ones were used in mechanical properties test, and a series of parameters of rpc was acquired such as prismatic strength, the cubic strength, split and pull strength, deformation module, peak strain, poisson ' s ratio

    進行三批7組稜柱體試件和三批22組立方體試件的力學性能試驗,測定了rpc200稜柱體抗壓強度、立方體強度、劈拉強度、彈性模量、峰值應變、泊松比等參數,並建立了變形模量和峰值應變的擬合公式。
  3. The effects of operating parameters such as split ratio and feed flowrate on separation efficiency were analyzed

    並考察了油滴直徑、進料流量及溢流比的變化對分離效率的影響。
  4. Some conclusions are drawn as following through analysis and research : 1. through rectifying finest sand character and concrete mix ratio test, anti - split capability of structure concrete is strengthen ; 2. heighten ratio of fly ash in finest sand concrete is beneficial to temperature control of huge volume concrete

    本文通過分析研究,得出以下成果: 1 .通過混凝土配合比試驗及特細砂混凝土改性研究,特細砂混凝土強度達到普通混凝土強度,且混凝土28天齡期極限拉應變為1 . 10xl0一4 ,高於普通混凝土29 . 4 % ,具有良好的抗裂性能。
  5. Because of the limitation of the measuring condition, in the thesis we had only measured some characteristics of the phase modulator : channel waveguides " loss coefficient is 0. 22db / cm, the split - ratio is 52 / 48 and half - wave voltage is < 5v

    由於條件所限,論文中僅測量了直波導損耗系數、相位調制器的半波電壓和輸出分束比。經測量,半波電壓小於5v ,直波導損耗系數為0 . 22db cm ,輸出分支比為52 48 。
  6. Two - order enhanced un - split finite volume euler method for multi - fluid flow, which combines the roe approximate riemann solver, is developed to simulate the multi - fluid interactions, such as the fluid described by polynomial eos, stiffen gas eos, jones - wilkins - lee ( jwl ) gaseous explosive eos, cochran - chan ( cc ) solid explosive eos and hom shock wave eos, etc. numerical results of the id, 2d and 3d multi - fluid interaction examples show that the high - resolution method and interface capturing equations can resolve the multi - fluid flow correctly and successfully. a simple fluid - mixture type ppm algorithm for multi - fluid flow, which is based on vof interface capturing method and resolved by langange / remap two steps, is developed to simulate the high density or high pressure ratio flow at both sides of the interface

    本文提出了實用於多介質流體的增強型二階精度有限體積歐拉數值計算方法,採用roe方法近似求解riemann問題,可以適用於多項式狀態方程、 「 stiffengas 」狀態方程、 jones - wilkins - lee爆轟產物狀態方程、 cochran - chan固體炸藥狀態方程以及hom狀態方程等,並對多介質流體相互作用的一維、二維、三維問題進行數值計算,數值驗證了本文給出的高精度差分格式和界面捕捉方法的正確性,兩種方法耦合形成的多介質流體數值計算方法是成功的。
  7. By assigning a " split ratio value " on the singular node, the singular equation in the network can be preserved

    另外為避免移除奇異方程式所造成的問題,在本研究中提出兩種解決之方法。
  8. The flow field and pressure drops in the hydrocyclone were calculated numerically based on the k - e model modified for anisotropy and simple algorithm. the effects of operating parameters such as split ratio and feed flowrate on pressure drop were analyzed. the calculate results was compared with those obtained in experiment

    因此,本文採用各向異性-模型及simple ( semi - implicitmethodforpressure - linkedequations )演算法對水力旋流器內流場及壓力降進行了數值模擬,分別考察了溢流比、進料流量及溢流管幾何尺寸等對壓力降的影響,並把得到的數值計算結果與實驗值比較,證明本文的計算結果是可以接受的。
  9. This thesis performs the research how to analyze and design lithium niobate optical modulator in i - fog. the analysis concentrates on those performance parameters of a modulator : half - wave voltage, single mode performance, quasi te / tm polarization, loss, bandwidth and split - ratio

    這些都是圍繞調制器的性能參數來研究的,它們包括:半波電壓,單模特性,偏振特性( te和tm模之間的輸出功率比值) ,損耗,帶寬及分支比等。
  10. The branch split - ratio is decided by practical fabrication process, so we have n ' t discussed it

    另外,分支比是由版圖和光刻工藝實現的,所以沒有進行詳細討論。
分享友人