spool valve 中文意思是什麼

spool valve 解釋
短管閥
  • spool : spool SPOOL= simultaneous peripheral operation on line 【計算機】聯機同時外部操作,假脫機操作技...
  • valve : n 1 【機械工程】閥,活門,舌門;汽門。2 【解剖學;動物學】瓣,瓣膜;(貝)殼瓣;【植物;植物學】...
  1. Then pid flow rate control algorithm is introduced. all experiments made in this chapter are about measuring the valve parameters according to spool positions, single actuator flow rate control by the calculated flow rate feedback control method, free flow rate dividing control under the sufficient pump discharge flow rate situation, proportion flow rate dividing and flow rate dividing based on meter - in flow rate feedback control method under insufficient pump discharge flow rate situation. the results of all experiments proved that the method presented in this thesis is an effective way to overcome the unreasonable flow rate dividing when simultaneously operating multi - actuators with different inertia loads

    第四章介紹了多執行器復合控制實驗系統和實驗方法;介紹了實驗採用的流量控制的pid演算法;並測定了執行器控制閥和閥芯位移相關的系數;做了單個執行器計算流量反饋流量控制、流量足夠情況下多執行器流量任意分配、流量不足情況下多執行器按比例調節流量分配和多執行器進油側流量反饋分流控制實驗;通過實驗說明了論文提出的分流控制方法能實現大小慣性負載復合操作時的合理分流。
  2. Combination sliding and rotary spool valve

    又移動又旋轉的圓柱滑閥
  3. Effect of alignability of three - position reversal spool valve on internal leakage flowrate

    三位液壓換向滑閥對中性對其內泄漏量的影響
  4. In order to overcome the disadvantages of servo valves and the spool valves, the fast hydraulic system controlled by the fast on - off valve is researched which uses the on - off valves as the pilot valves. they are used to control the opening and closing of the logic valves, thus they can control the pressure and the flow. so they can control the movement direction and the velocity of the piston

    為了克服伺服閥和滑閥的不足,本文所研究的基於快速開關閥的快速液壓系統採用快速開關閥作先導閥,控制邏輯閥的開啟和關閉,從而控制液流的通斷和壓力的高低、流量的大小,以實現對活塞運動方向、速度的控制。
  5. Spool shut - off valve

    滑閥式截止閥
  6. Spool valve type

    滑閥式轉向控制器
  7. Centre spool valve

    中心柱形閥
  8. Check valve and butterfly valve combinations are very popular ; normally a short spool piece is required between the valves

    止回閥和蝶閥組裝是很常見的,通常需要在閥門之間增加一段短管。
分享友人