stable pair 中文意思是什麼

stable pair 解釋
穩定對
  • stable : adj 1 穩定的;安定的;固定的。2 意志堅定的,有恆心的。adv bly ness n n 1 廄,馬廄,馬棚;〈罕用語...
  • pair : n (pl pair(s))1 一對,一雙,一套,(眼鏡等的)一副;(剪子等的)一把,(褲子等的)一條。 2 一...
  1. The thesis has done the widespread investigation and study to the domestic and foreign ’ s technologies of analogy low voltage and low power, and analyzes the principles of work, merts and shortcomings of these technologies, based on the absorption of these technologies, it designs a 1. 5v low power rail - to - rail cmos operational amplifier. when designing input stage, in order to enable the input common mode voltage range to achieve rail - to - rail, it does not use the traditional differential input pair, but use the nmos tube and the pmos tube parallel supplementary differential input pair to the structure, and uses the proportional current mirror technology to realize the constant transconductance of input stage. in the middle gain stage design, the current mirror load does not use the traditional standard cascode structure, but uses the low voltage, wide - swing casecode structure which is suitable to work in low voltage. when designing output stage, in order to enhance the efficiency, it uses the push - pull common source stage amplifier as the output stage, the output voltage swing basically reached rail - to - rail. the thesis changes the design of the traditional normal source based on the operational amplifier, uses the differential amplifier with current mirror load to design a normal current source. the normal current source provides the stable bias current and the bias voltage to the operational amplifier, so the stability of operational amplifier is guaranteed. the thesis uses the miller compensate technology with a adjusting zero resistance to compensate the operational amplifier

    本論文對國內外的模擬低電壓低功耗技術做了廣泛的調查研究,分析了這些技術的工作原理和優缺點,在吸收這些技術成果基礎上設計了一個1 . 5v低功耗軌至軌cmos運算放大器。在設計輸入級時,為了使輸入共模電壓范圍達到軌至軌,不是採用傳統的差動輸入結構,而是採用了nmos管和pmos管並聯的互補差動輸入對結構,並採用成比例的電流鏡技術實現了輸入級跨導的恆定;在中間增益級設計中,電流鏡負載並不是採用傳統的標準共源共柵結構,而是採用了適合在低壓工作的低壓寬擺幅共源共柵結構;在輸出級設計時,為了提高效率,採用了推挽共源級放大器作為輸出級,輸出電壓擺幅基本上達到了軌至軌;本論文改變傳統基準源基於運放的設計,採用了帶電流鏡負載的差分放大器設計了一個基準電流源,給運放提供穩定的偏置電流和偏置電壓,保證了運放的穩定性;並採用了帶調零電阻的密勒補償技術對運放進行頻率補償。
  2. Feeding system adopts imported linear guide rail pair, hi - precision and long life. air - liquid damping cylinder assures blade feeding is even and running is stable

    進給系統採用進口直線導軌副,精度高、壽命長。氣液阻尼缸保證鋸片進給均勻,運動平穩。
  3. After a long time evolution, the system finally reaches a stable state at which the magnetization and the equal time spin - pair correlation are periodic oscillating functions with the equal period as the external field. numerical simulation shows : when the amplitude of external filed is large, there exits a particular temperature at which the average magnetization and the average spin - pair correlation are almost unaltered with various field amplitude ( i. e. magnetic susceptibility is zero ), and the particular temperature depends on the number of the spin states, cutting down with q increasing

    由數值模擬得到:當外場幅度較大時,存在一個特殊的溫度點(我們稱之t ) ,在這個溫度點,系統的平均磁化強度和平均等時自旋對關聯隨外場幅度的變化幾乎保持不變(即磁化率為零) ,並且這個溫度的大小依賴于自旋態數目q的變化, q越大,這個溫度就越小;而當外場較小時,確信系統存在有限大小的臨界溫度
分享友人