static apparatus 中文意思是什麼
static apparatus
解釋
靜電治療機-
In the research, a set of simulation equipment is developed to examine the drivers " static and dynamic fatigue. recur to the apparatus, contrast and control experiment are made among different ages, workload intension and workload factors group. the endings summarize as following : ( 1 ) driving sensation fatigue investigation ( investigation of psychological and physiologic index and contrast investigation of fatigue ) ; continuous driving load and discrete driving load investigation of fatigue
? ?門）駕駛疲勞平衡穩定性是通過在力檢測臺上描繪人體重心軌跡的方法，提出檢測駕駛員疲勞平衡穩定指數，在不同狀態下（傾斜度15 30 『以及閉目等狀態下）對不同負荷、不同年齡分別進行測試，建立駕駛疲勞客觀測試評價體系； n ）經實驗室研究與現場調查，通過對駕駛疲勞與駕駛時間、駕駛速度等關系的研究，提出了不同年齡、不同條件下的最大連續安全駕駛時間標準，日駕駛時間標準，最大安全行車速度標準等。 -
Saturated sand are testes in the laboratory under the undrained cyclic loading condition with static - dynamic dual purpose triaxial compression test apparatus, which is designed under the cooperation of hohai university and marui co. ltd japan. the results indicate that the stress path approaches from a initial stress point to the failure lines as cyclic loading goes on, and eventually converges on a certain limiting stress path in the vicinity of the failure lines. the stress - strain curve, however, does not converge on a closed hystersis loop ; the shear strain rapidly increases in looser sand or gradually and continually increases in denser sand
利用河海大學與日本圓井株式會社共同研製的新型的多功能靜動三軸儀進行了飽和砂土循環扭剪不排水試驗，研究表明，對于松砂，剪應變幅度快速地由微小增加到百分之幾甚至百分之十幾，對于緊砂，剪應變幅度逐漸地由微小增加到百分之幾甚至百分之十幾；經試驗初步研究表明用初始有效平均正應力歸一化的有效應力路徑很好的一致性。 -
Fire hazard testing - part 6 : guidance and test methods on the assessment of obscuration hazard of vision caused by smoke opacity from electrotechnical products involved in fires - section 30 : small scale static method - determination of smoke opacity - description of the apparatus
著火危險試驗.第6部分:火中電工產品產生的煙霧蔽光性引起的視覺遮蔽危險的評定指南和試驗方法.第30節:小規模靜態試驗法.煙蔽光性的測定.儀器說明 -
In this paper the feasibility of hydrostatic test employed in static pressure test on flameproof electrical apparatus and design and test essentials about instruments used during hydrostatic test are given
闡述了隔爆型電氣設備靜壓試驗採用水壓試驗法的可行性，及水壓試驗工具的設計和試驗要點。 -
It designed a microwave measuring system and built a static and simulative apparatus. furthermore, a large amount of experimental work was carried out and the feasibility of microwave measuring system was proved
完成了微波收發裝置和系統的構成，搭建了靜態模擬的實驗裝置，開展了大量的實驗研究工作，驗證了微波測量系統的可行性。 -
The progress of the development and the electromagnetic contactor expert system is discussed. the system is expert system applied in electrical apparatus design field, and it is an internet application built on applied eletromagnetic contactor technology - expert system technology computer technology and software engineer technology. the main design idea is to combine abundant experts " experience with the ability of analysis and discussion of computer to solve reality problem. the system can run according to contactor design parameter by user ' s input and collect corresponding knowledge from knowledge _ base, then design out contactor ' s various structure parameter, and it can analyze dynamic and static character and optimization design, and in the end all property can achieve best
該系統是專家系統應用於電器設計領域內的一次嘗試，它是集電磁式接觸器技術、專家系統技術、計算機技術和軟體工程技術為一體的應用軟體包。其主要的設計思想是把專家的豐富經驗和計算機的分析推理能力相結合去解決實際問題。本系統可以根據用戶的設計要求輸入接觸器的設計參數，同時從知識庫中提取相應的知識，設計出接觸器的各種結構參數，並對其動靜特性進行分析計算。 -
There are two kinds of ways to measure the railway vehicle wheel tread irreguiarities. one is the static measurement that uses the mechanical ruler, electro - testing apparatus and device equipped with ccd. another is the dgnamic measurement that mainly depends on the technology of ultrasonic and ccd
鐵路貨車車輛輪對踏面擦傷的測量方式可以分為靜態檢測和動態檢測：靜態檢測主要採用機械測量尺、電子測量儀和基於ccd技術的測量裝置；動態測量主要採用超聲波和ccd技術。 -
An experimental apparatus of falling film absorption in a vacillating is set up to check the reliability of theoretical model and to have a deep understanding of heat and transfer of practical falling film absorption ; falling film absorption with tfe / nmp solution in a static vertical tube and that in a vacillating tube are investigated respectively
為驗證理論模型的可靠性並進一步深入了解實際搖擺降膜吸收過程中熱、質傳遞規律，自建了搖擺振動單管吸收試驗臺；分別對靜止和搖擺狀態下tfe / nmp垂直管內降膜吸收進行實驗研究。 -
There are two kinds of way to measure the wheelset geometric parameters. one is the static measurement which uses the mechanical ruler, electro - testing apparatus and device equipped with ccd. another is the dynamic measurement which mainly depends on the technology of ultrasonic and ccd
輪對幾何參數的測量方式可分為靜態檢測和動態檢測：靜態檢測主要採用機械測量尺、電子測量儀和基於ccd技術的測量裝置；動態檢測主要採用超聲波和ccd技術。 -
Astra advanced static test recording apparatus
高級靜態測試記錄器
分享友人