static simulation 中文意思是什麼

static simulation 解釋
靜態模擬
  • static : adj 1 靜止的，靜態的，靜力的。2 【物理學】天電的，靜電的。3 【無線電】靜態特性。4 固定的，不活潑...
  • simulation : n. 假裝；模擬；裝病，裝瘋；【生物學】擬態，擬色。
  1. Finally, the controller working based on the combination of rbf neural networks and traditional pid control was applied to in aclinic kinetic machinery and lifting machinery of tower crane. the simulation of this controller was made using matlab, and the simulation results showed that the control system has some merits, such as quick response, little overshoot, well anti - jamming capacity, and little steady - state error, etc. both the dynamic property and static characteristic of this controller are better than traditional pid controller, and meet the tower crane

    應用matlab對塔機的變幅和起升機構的運動控制進行模擬，模擬結果表明基於rbf神經網路整定pid的控制系統具有響應快、超調小及穩態誤差小等優點，其動、靜態性能優于單一pid控制，從而提高了塔式起重機工作機構的工作性能。
  2. In chapter 4, the principle drawing of the system is presented after adding a constant - pressure - drop valve. the operating principal of the valve is briefly introduced. the static mathematical model is built up and study is carried out by means of simulation under the circumstance of matlab, then the static working point is obtained

    對定差減壓閥作了簡要的介紹，根據系統工作原理圖建立靜態數學模型進行模擬研究，由模擬結果分析系統靜態工作特性，得到靜態工作點；然後，建立系統動態模型，對其動態特性進行非線性模擬研究，並就環境因素變化對系統工作特性的影響作了詳細分析。
  3. In the research, a set of simulation equipment is developed to examine the drivers " static and dynamic fatigue. recur to the apparatus, contrast and control experiment are made among different ages, workload intension and workload factors group. the endings summarize as following : ( 1 ) driving sensation fatigue investigation ( investigation of psychological and physiologic index and contrast investigation of fatigue ) ; continuous driving load and discrete driving load investigation of fatigue

    ? ?門）駕駛疲勞平衡穩定性是通過在力檢測臺上描繪人體重心軌跡的方法，提出檢測駕駛員疲勞平衡穩定指數，在不同狀態下（傾斜度15 30 『以及閉目等狀態下）對不同負荷、不同年齡分別進行測試，建立駕駛疲勞客觀測試評價體系； n ）經實驗室研究與現場調查，通過對駕駛疲勞與駕駛時間、駕駛速度等關系的研究，提出了不同年齡、不同條件下的最大連續安全駕駛時間標準，日駕駛時間標準，最大安全行車速度標準等。
  4. The result of simulation is applied to develop the static model, and a 3d model of residual oil distribution in different period is obtained

    將模擬結果返回到靜態模型中進行循環建模，從而建立了不同時期的剩餘油定量分佈的三維模型。
  5. The thesis built the relation between containing water and the properties of trail dam ' s soil by geomechanical properties of trail dam ' s soil ; analysed the seep rule of water in the trail dam ' s field and the change of soakage line. the thesis applied the limited element to analyze the trail dam of baogang by the engineering item in production. it calculates the dynamic and static response about the dam using the numerical simulation method

    本文通過大量的尾礦土物理力學性質試驗資料，建立了含水量與尾礦土性質之間關系曲線；分析了水在尾礦壩區的滲流規律和不同標高時浸潤線的變化情況，為分析尾礦壩的穩定性提供依據；結合生產上的工程項目，從包鋼尾礦壩的穩定性研究入手，應用有限元法，通過數值模擬分析了水對尾礦壩的靜力、動力穩定性影響。
  6. Basing on the analysis about the reason that how the superabundant torque appears, direct torque control strategy is used to realize the servo control of two asynchronous motors and load system ' s simulation. the measure method of superabundant torque of the system, the valid method of static state torque and the benchmark of dynamic torque are given by testifying the system ' s speediness through experiments

    在具體分析加載系統中多餘力產生原因的基礎上，採用直接轉矩控制策略，實現了兩臺異步電動機伺服控制和加載系統的負載模擬實驗，通過實驗驗證了系統的快速性；給出了系統多餘轉動慣量的測量、靜態轉矩的校驗和動態轉矩基準的實驗的基本方案。
  7. 3. the static aerodynamic characteristics of the projectile are computed using the software of cfd, the results of the numerical simulation are agreement with the engineering calculation, this verifies that the results of the static aerodynamic characteristics of waf from engineering calculation are satisfactory

    3 .應用cfd軟體對彈靜態氣動特性進行數值計算，數值計算結果與工程估算結果吻合較好，說明卷弧翼的靜態氣動特性可以通過平板翼進行估算。
  8. On the base of the numerical simulation of unsteady viscous flows, the characters of the static aeroelastics and flutter for the wings are researched. some examples, simulating the steady and unsteady transonic ( and subsonic ) viscous flows around onera m6 wing, are given in this paper

    以oneram6機翼為算例，分別對其亞、跨音速定常及非定常粘性繞流狀態進行了數值模擬，並運用b - l和j - k兩種湍流模型計算結果和實驗數據進行了對比。
  9. The simulation results show the mras - based field oriented control system has good static and dynamic performance

    對系統的模擬實驗表明，基於模型參考自適應系統的矢量控制系統具有較好的靜態和動態性能。
  10. Circuit simulation demonstrated that the dynamic and static performances of buck converter controlling by sliding mode are better than that of pwm converter

    電路模擬表明，滑動模控制的buck變換器的許多動態性能和靜態性能都優于pwm控制的buck變換器。
  11. In the second place, based on the asu of buggenum igcc plant in netherlands, both static and dynamical model for distillation tower of the asu are created and some valuable conclusions are gained as well. finally, a compartmental simplified model is created for distillation tower of the asu, in order to reduce the simulation time and increase the simulation efficiency. the new model will be helpful to the further simulation and on - line optimal control for the asu of the igcc plant

    其次，本文以荷蘭buggenum電站的空分系統為原型，基於matlab建立了空分系統精餾塔的半圖形化動、靜態數學模型，並通過模擬，得出了一些有價值的結論：當空分系統的壓力變化時，氧氣產品濃度的響應時間常數為兩小時左右，說明空分系統是igcc電站最大延遲環節；而且雖然氧氣濃度最後會穩定在igcc電站所要求的范圍之內，但在過渡過程中會超出限制，這些都為igcc電站的安全運行及控制系統設計提供了有價值的信息。
  12. Static and dynamic simulation for natural gas pipe network and natural gas load forecasting is an important work of natural gas management system

    天然氣管網系統穩動態模擬及其負荷預測是天然氣管理系統中的一項重要工作。
  13. This thesis is concerned with two problems : static and dynamic simulation for natural gas pipeline network and short - time natural gas load forecasting

    本文主要研究了天然氣管網系統穩動態模擬和天然氣短期負荷預測兩個問題。
  14. In chapter 5, by number value simulation calculation and experiment of one simple support beam, we will compare the magnitude of the coupling static and dynamic stress at each point on the girder under harmonic excitation, and so find conclusions such as : ( 1 ) there are so much correlations between structure damage and environmental effect and exterior excitation leads dominant effects in structure damage that we should consider static and dynamic stress together. ( 2 ) new intension design rules should be set up, according which the range of structure possible damage position should be estimated in advance

    得到以下結論： （ 1 ）結構的破壞和環境的影響密不可分，外部激勵在結構破壞中發揮了重要的作用，應該將結構所受的靜力和動力一起考慮； （ 2 ）應該建立新的強度設計準則，並以此作為依據，對已知結構的可能損傷位置有預先的范圍估計，從而為損傷識別的準確定位提供理論依據。
  15. An approach of static simulation of altitude measurement using a kgw - xx radio altimeter installed in a target drone model is introduced, experimental data are presented, and testing results are analyzed in theory

    摘要介紹某型拖靶使用的kgw - xx型無線電高度表靜態模擬測高試驗方法，給出了試驗數據，並對試驗結果進行了理論分析。
  16. On the basis of theory research, software and hardware design, the system experiment simulation in matlab toolbox is given, and the simulation results are analyzed and explained. the simulation results show the system has good static and dynamic performance

    在無速度傳感器直接轉矩控制系統理論研究和軟硬體設計的基礎上，利用matlab模擬工具箱完成了整個系統及各個部分的模擬，並對模擬結果進行了分析和說明。
  17. The validity of the subsection simulation method is proved, in which postprocessing technology is widely used. the sixth, the static simulation is neces sarily to find out the dynamic system ' s initial state for dynamic simulation. the gun is looked upon as a hyper - equilibrium structure, and a so - called " parallel projection method " is brought forward for the gun ' s static simulation

    提出了一種求解線性方程組的方法?平行投影法，針對adams對超靜定系統靜態分析不力的情況，研究了求解全炮靜態問題的途徑和方法，並應用平行投影法求解車體懸掛的初始平衡力，求得了較符合客觀事實的解，從而完成了火炮發射前的靜態分析。
  18. There are two important points in static simulation research work, one is static regulation range, and the other is dead - zone. in dynamic simulation research, variable parameters and optimum simulation research work for the integrated valve are made

    穩態模擬主要就影響集成閥工作死區和調節范圍的參數進行了分析；動態模擬主要對集成閥進行變參模擬，考察一些參數對集成閥時域特性的影響，實現了參數優化。
  19. The optics propagation characteristics of lcd for realizing static simulation of lcd are calculated and analyzed by 2x2 extended jones matrix methods. the factors impacting display quality of lcd are discussed and some improved processes control and designing methods are presented too

    詳細推導了在研究液晶材料及器件光學性質中廣泛應用的2 2jones延伸式矩陣法，計算了液晶顯示器件的光學傳播特性，為實現液晶顯示器件的靜態模擬提供了理論依據。
  20. By practical simulation, the results show that the arithmetic has a higher precise in static simulation

    通過實例模擬表明利用這種演算法得出的計算結果具有較高的精度。
分享友人
分享到 Line

分享到臉書