steady-state transfer 中文意思是什麼

steady-state transfer 解釋
穩態傳遞
  • steady : adj 1 穩固的，平穩的，穩定的，不變的（腳步、努力等）。2 堅定的，扎實的，牢靠的（船等）。3 有規則...
  • state : n 1 〈常作 S 〉國，國家；〈通例作 S 〉（美國、澳洲的）州；〈the States〉 美國。2 國務，政權，政府...
  • transfer : n 1 移轉，轉送；調職；調任[轉學]證書；變換。2 （財產；權利等的）轉讓，讓與（證書），移轉，授受；...
  1. For micro - cavity semiconductor laser, station model is proposed in this paper and its steady - state and instantaneous characteristics when the coupling efficiency of spontaneous emission into a lasing mode is equal to 1 are analysised. for current noise, sp noise, noise, p noise, as well as current modulation, sp modulation, modulation and p modulation, using small - signal approximation, we derive the laser ' s corresponding transfer functions. and we calculate their signal - to - noise ratio ( snr ) gain in various parameters through frequency domain analysis in the premiss of large input snr

    本文對于微腔半導體激光器，提出站模型，能夠較直觀簡潔地分析微腔半導體激光器的穩態和瞬態特性，利用此模型對具有重要實用價值的= 1的微腔半導體激光器進行了討論；對于電流i噪聲、自發發射壽命_ （ sp ）噪聲、自發發射因子噪聲、光子壽命_ p噪聲，以及電流調制、 _ （ sp ）調制、調制、 _ p調制，在小信號近似下，得到了相應的激光器的傳遞函數；在大信噪比的前提下，對激光器進行了頻域分析，分別計算了它們在不同參數下的信噪比增益，分析了其抗噪聲性能。
  2. The interior size and the calorific capacity of the borehole are much smaller, moreover the temperature change is slow, so usually we can neglect the influence of calorific capacity but to consider according to the heat transfer in steady state process, thus we can establish one - dimensional and the two - dimensional thermal resistance model in the borehole

    而在鉆孔內部，包括回填材料，管壁和管內傳熱介質，與鉆孔外的傳熱過程相比較，由於其幾何尺寸和熱容量要小得多，而且溫度變化較為緩慢，因此通常可以忽略其熱容量的影響而按穩態傳熱過程來考慮，建立了鉆孔內的一維和二維的熱阻模型。
  3. The explicit finite element method ( fem ) based on the varying time - step was selected to analyse the dynamic roll - pass process ; the nodes on the leading face of the steady - state elements set was extracted and projected onto a plane to give the required mesh, also called the origin mesh ; the implicit fem was selected to analyses the inter - pass transient thermal process ; a geometric part from the mesh was generated and meshed by using the quadrilateral elements, a heat transfer analysis was selected to transfer the node temperature data ; a new model was created by using hexahedral elements, mapping the node temperature and the equivalent plastic strain on the integration points

    利用基於變步長中心差分格式的顯式積分方法分析瞬態軋制過程；提取穩態單元集節點形成截面網格；利用隱式積分方法分析軋制道次間隙瞬態溫度場；對型鋼斷面進行平面四邊形網格劃分並映射節點溫度數據；利用六面體單元構建有限元分析模型，映射單元節點的溫度、積分點的等效塑性應變，進行數值分析。
  4. Solving 2 - d inverse heat transfer problems with multi - variables in steady - state via conjugate gradient method based on second - order sensitivity

    基於二階敏度的共軛梯度法求解多宗量穩態傳熱反問題
  5. Then, a three - dimensional, comprehensive, steady - state mathematical model is described to investigate the fluid flow, heat transfer, species transport and electrochemical reaction in the pem fuel cells

    然後，發展了一個用於研究質子交換膜燃料電池特性的三維綜合的數學模型，模型同時考慮了流體流動、熱量傳遞、電荷傳遞、多組分傳遞和電化學動力學。
  6. The ash fouling online monitoring models are built for furnace, convection heating surface and tri - sectional regenerative air preheater based on the analysis and summarization the researches on the ash fouling monitoring technic and models of boiler. clean factor ( cf ) is chosen to express the effect on heat transfer of ash fouling and is calculated by heat transfer steady - state model

    在分析研究總結現有的鍋爐各類受熱面的各種灰污監測技術和模型的基礎上，建立了鍋爐爐膛、對流受熱面和三分倉空預器的灰污在線監測模型，以清潔因子表徵受熱麵灰污對鍋爐受熱面傳熱的影響。
  7. By using transfer matrix method and corresponding boundary conditions, the steady - state responses of the counter - rotating dual - rotor system were analyzed, and the changing characteristics of the disks ' orbits and the centroids ' locations were studied experimentally, proving the relevant conclusions from calculations

    針對這種結構，應用傳遞矩陣法，結合邊界條件，分析了反向旋轉雙轉子結構穩態不平衡響應的變化規律，研究了內、外轉子盤軸心軌跡和質心的變化特點，並進行了相應的試驗研究，驗證了計算模擬的相關結論。
  8. Two - dimensional steady - state heat - transfer model of

    熱型連鑄過程的二維穩態傳熱模型
  9. In this paper, on the basis of previous research works, the ivth system model is studied, and results are compared with the ii th one, and we get expressions for the transfer probability of the customers pij, the mean number of customers in the steady state m, and the mean detained time of the customers in the system w. so far, the theory foundation of the contention - collision elimination access mode has been established for its application

    其中競爭?沖突淘汰存取方式類、類、類、類系統模型的數學建模已經完成。本文就類系統模型進行了數學建模，提出了顧客轉移概率p _ ij 、平穩狀態下系統平均隊長（ ? ） 、顧客平均等待時間w等的算式。
  10. The quasi steady state analytical method is used to calculate the temperature in the heat structure. in normal condition, the heat transfer modes included the convection and boiling conditions

    用集總參數法來計算熱傳導；在正常的工況下，用含兩個傳熱區的兩相對流傳熱模型，計算流體與管壁間的換熱。
  11. According to the theory of engineering thermodynamics and phase change, heat - transfer process of the special working fluid heat - pipe stove is analyzed. some hypotheses are postulated and with the help of equation of mass - conservation, energy - conservation, the dynamic concentrative parameter model is built, the change of each parameter is prescribed at any stage from starting to stopping. with the thermodynamic calculation of burnable process, the parameter of device, such as heat - transfer coefficient / thermal efficiency etc, are achieved under steady state ; based on theoretic calculation, observing the actual running circumstance of the heating stove in person, with some performance comparison between the new and the old, the high efficiency and reliability of heat - pipe stove is proved, the project which expend it in the oil - filed is feasible

    對充入該工質的熱管加熱爐，本文根據工程熱力學和相變傳熱學及相關知識，對其進行了傳熱分析，經過適當假設，運用質量守恆和能量守恆定律，建立了裝置動態集中參數模型，描述了加熱爐從開機到穩定運行這一動態過程各參數的變化情況，同時對燃燒過程也進行了熱力計算，最終得到了穩態工況下裝置的換熱系數、熱效率等熱力參數；在理論計算的基礎上，親赴現場觀察該爐的實際運行情況，通過與原有的加熱爐的各項性能進行對比，最終證明新爐的高效性和可靠性，為其在油田中推廣的可行性提供了依據。
  12. The cryogenic performance of scq and ssm superconducting magnets are investigated both at steady operation state and at unsteady state in detail, including flow and heat transfer characteristics of cooling medium, and electromagnetic, mechanical characteristics of magnets

    本文以bepc中關鍵部件scq 、 ssm超導磁體為主要研究對象，研究了超導磁體在低溫下的穩態與非穩態工作特性中的若干問題，包括冷卻介質的流動特性、傳熱機理，磁體的冷卻結構、電磁與機械性能等。
  13. The dq equivalent circuit model of three - phase three - switch boost type power - factor - correction is proposed firstly, the completely dc steady - state analysis and ac small - signal analysis are done and the dc operation points and ac transfer functions are acquired

    3 .首次提出三相三開關boost型功率因數校正的dq等效電路模型，並對其進行了完整的直流穩態和交流小信號分析，得到直流工作點和交流傳遞函數。
  14. A kinetic characteristics algorithm of furnace combustion based on steady state is established, and a dynamic mathematical model of 450t / h cfb boiler made in china is developed in this paper. the model not only integrates the update theories and results of previous studies on the partial aspects, but also considers the main process in cfb boiler including flow, coal distribution, devolatilization of coal, char combustion, heat transfer and so on, and further improve the existing model of combustion kinetic characteristics

    本文以國產450t h循環流化床電站鍋爐為研究對象，在前人對循環流化床內部各種單獨過程及模型化研究成果的基礎上，深入考慮了燃煤粒徑分佈、流動、揮發分釋放和燃燒、焦炭燃燒、傳熱等循環流化床內部進行的主要過程，進一步完善了爐內燃燒動態特性的數學模型。
  15. Standard test method for steady - state heat transfer properties of pipe insulation

    管絕緣材料穩態傳熱特性的標準試驗方法
  16. The system ' s transfer function is acquired according to the step response curve. the influence of the system ' s pressure balance time affected by the steady and unstable state ' s increasing is discussed, the conclusion has practice meaning

    深入客觀地探討了不同的加壓速率利加壓幅值以及分階段加壓對卸荷閥性能測試系統壓力平衡時間的影響，獲得了有實踐指導意義的結果。
  17. Compared to heat transfer in the external region of borehole, mass and heat capacity of materials inside the borehole are insignificant and negligible. thus, heat transfer inside the borehole is approximated as steady - state heat transfer except for analyses of short times ( a few hours )

    與鉆孔周圍區域傳熱過程相比，由於鉆孔內材料的熱容量較小，因此除了討論短時間（數小時）的瞬變傳熱問題以外，可以忽略鉆孔內材料的熱容量，把該部分的傳熱近似作為穩態傳熱處理。
  18. The experiment plans and regulations are proposed. the research on date handling method of the experiment is done. the factors causing temperature rising and the distribution of steady - state temperature field of swing movable teeth reducer are analyzed with the heat transfer theory

    選用合適的儀器和實驗方案，設計了擺動活齒減速器傳動效率實驗臺，制定了擺動活齒減速器傳動效率實驗的實驗規程，並對實驗數據的處理方法做出了研究。
  19. The thermal network model of steady - state temperature field of swing movable teeth reducer is set up. the calculation models for power losses, heat transfer and thermal resistance of swing movable teeth reducer are established. the thermal network figure of swing movable teeth reducer is drawn

    運用傳熱學理論對擺動活齒減速器的發熱機理和穩態溫度場分佈進行了研究，建立了擺動活齒減速器的穩態溫度場的熱網路模型、功率損失計算模型、熱傳遞計算模型及熱阻計算模型。
  20. Solving inverse heat transfer problems with multi - variables of boundary conditions in steady - state via conjugated gradient method

    共軛梯度法求解穩態傳熱組合邊界條件反問題
分享友人
分享到 Line

分享到臉書