stirring rate 中文意思是什麼
stirring rate
解釋
攪拌速度-
Some main results of testing research were as fellows : i. in the course of testing of leaching zinc dross, leaching zinc dross by sulfuric acid was researched and the effects on the leaching rate of the zinc dross were analyzed by author, the optimum conditions of leaching testing of zinc dross were determined as fellows : liquid - solid ratio 6 : 1, stirring ratio 250r / min, granularity 120 mesh, the soaking time 5h, the concentration of sulfuric acid of 30 %, and under these conditions, the rate of leaching zinc is above 92. 0 %. ii. in the course of testing of purification, on the basis of comprehending and comparing all present methods of the manganese - removal and iron - removal, the oxidizing method of manganese - removal in zinc sulfate solution using ammonium persulfate was put forward and the oxidizing method of iron - removal in zinc sulfate solution using the goethite process and oxidation - hydrolysis process was adopted
研究的主要結果具體如下： 1 、研究了硫酸浸出鋅浮渣並分析了影響浸出率的各種因素，確定了浸出鋅浮渣的最佳條件為：液固比為6 ： 1 ，攪拌速度為250r min ，粒度為- 120目，酸浸時間為5 . 0h ，硫酸濃度30 ，鋅浮渣的浸出率大於92 . 0 ； 2 、在綜合和比較了目前除錳和除鐵的各種方法基礎上，提出了過硫酸銨氧化除錳方法和選擇了針鐵礦-氧化水解聯合法除鐵方法，並分析和討論了影響除錳率和除鐵率等各種因素，確定了除錳的條件為：溫度90 ， ph值5 . 4 ，反應時間3h ，過硫酸銨達到理論值的1 . 2倍，除錳率超過99 . 86 ；聯合法除鐵的條件為：氧化反應時間1 . 5小時、溫度控制在90 92 、 ph值5 . 2 5 -
Their properties have been investigated by using scanning electronic microscopy ( sem ), differential scanning calorimetry ( dsc ), x - ray diffraction ( xrd ), thermogravimetry - differential thermal analysis ( tg - dta ), infrared spectroscopic analysis ( ir ), and gas chromatography ( gc ), etc. the effects of the mulser ' s stirring rate and the emulsifier concentration on the properties of encapsulated pcms have been systematically studied, and nanopcms have been obtained by increasing the stirring rate or the emulsifier concentration. the influences of different nucleating agents on micropcm performances have also been investigated in detail to search for a suitable nucleating agent to prevent micropcms from super - cooling
首先，系統研究了乳化機轉速和乳化劑濃度對膠囊性能的影響，並通過提高轉速或乳化劑濃度獲得相變材料納膠囊；其次，系統研究了不同成核劑對微膠囊性能的影響，找到合適的成核劑抑制了相變材料微膠囊的過冷現象；再次，詳細研究了環己烷對膠囊性能的影響，並通過添加適量環己烷提高了相變材料微膠囊及納膠囊的耐熱溫度。 -
At the same time, the intrapartical diffusion and liquid internal mass transfer can been enhanced by ultrasound field, owing to additional stirring, the increasing rate of intraparticle diffusion coefficient is enhanced, while that of the liquid film mass transfer coefficient is reduced under ultrasound field
模型研究表明： freundlich ?兩相阻力模型計算得到濃度與實驗測定值非常吻合，超聲場能有效地強化浸取粒內擴散與液膜傳質，攪拌作用下超聲強化液膜擴散的的能力降低，強化粒內擴散的能力增強。 -
As the stirring rate increasing, the average diameter of capsules decreases exponentially and its distribution turns narrow, but its polydispersity index increases
隨著轉速的增加，膠囊的平均粒徑呈指數關系減小，分佈變窄，多分散指數卻增加。 -
2. the mulser ' s stirring rate has no effect on the core content of capsules
2 、乳化機轉速對囊芯含量基本沒有影響。 -
The shell thick is linear with the average diameter of capsules while the weight proportion of the shell to the core is constant. the shell thick decreases with the increase of the stirring rate
在囊壁囊芯比例固定的條件下，囊壁厚度與膠囊粒徑呈線性關系，且隨轉速增加而減小。 -
According to the characteristic of fermenter, we designed the control system based on single chip computer and personal computer, realizing the measurement and control over do, ph, temperature, pressure, ventilating rate and the speed of the stirring motor
根據發酵罐的特點，本文基於單片機和pc機結合，設計了發酵過程自動控制系統，實現do 、 ph 、溫度、罐壓、通氣量和攪拌電機轉速的測控以及發酵液的粘度的在線測量。
分享友人