strain at failure 中文意思是什麼
strain at failure
解釋
破壞應變-
Tensile tests of carbon filament yarn shows at high strain rate that the mechanical behavior of carbon fiber bundles are insensitive to strain rate, i. e., the failure stress strain and elastic modulus are not increased with the rising of strain - rate. however, the fractograph of carbon fiber is rate - dependent. the fractograph of carbon will become smooth from coarse as the strain rate increases
通過對碳纖維束的沖擊拉伸試驗表明，雖然碳纖維束的力學性能與應變率基本上是不相關的，即隨著應變率的增大，碳纖維束的初始模量、破壞應力及其失效應變都變化不大，但碳纖維束的破壞斷口與沖擊拉伸實驗的應變率密切相關。 -
Abstract : based on the fundamental principle of hypothesis strain equivalence, itwas investigated a physical concept of high strength concrete at minus temperature ( hscmt ) freezing damage parameter, the elastic modulus of frost concrete with anti freeziug admixture and without antifreezing admixture built and it was analyzed their variate process and the condition adaptated. it is purpose to judge hscmt frost failure process
文摘:從應變等效性假說的基本原理出發，研究了負溫混凝土凍結損傷參數? ?彈性模量法中受凍后測試的損傷混凝土彈性模量的物理概念，從而分析了摻防凍劑混凝土及不摻防凍劑混凝土受凍后的彈性模量變化過程及其選用該參數的適應性條件，為判斷負溫高強混凝土材料凍結失效過程提供保證。 -
Advanced technical ceramics. ceramic composites. methods of test for reinforcements. determination of distribution of tensile strength and tensile strain to failure of filaments within a multifilament tow at ambient temperature
高技術陶瓷.陶瓷成分.增強的試驗方法.環境溫度下多纖維牽引內纖維斷裂拉伸強度和拉伸應變分配的測定 -
Advanced technical ceramics - ceramic composites - methods of test for reinforcements - determination of distribution of tensile strength and of tensile strain to failure of filaments within a multifilament tow at ambient temperature
高級工業陶瓷.陶瓷復合材料.增強纖維的試驗方法.室溫下復絲束中長絲斷開時的拉伸強度和拉伸應變分佈的測定 -
Advanced technical ceramics - ceramic composites - methods of test for reinforcements - part 5 : determination of distribution of tensile strength and of tensile strain to failure of filaments within a multifilament tow at ambient temperature
先進工藝陶瓷.陶瓷復合材料.增強纖維的試驗方法.第5部分:周圍溫度下復絲束中長絲拉伸強度的分佈和斷裂拉伸應變的測定 -
At first, development of various cracks carefully recorded and strains on both the rebars and the stirrups were measured in detail, together with the deflections of the beam. in such a way, correlation between the measured strain profiles of the reinforcement and the observed cracking development of each specimen was pursued. principal factors contributing to the cracking pattern and failure mode were figured out as a result
首先，通過單調靜力加載試驗研究，對梁的裂縫延伸和開展、縱筋應變、箍筋應變、梁的撓度等指標進行了細致的量測，試圖追蹤每一試件在裂縫發展及破壞過程中縱筋應變狀態的變化和裂縫發展程度的相關性，進而總結出有腹筋約束梁裂縫開展及鋼筋應力分佈的一般規律。 -
Through comparing and analyzing of bearing capacity, development of crack and strain of reinforced, the results show that the load - deflection plots f or specimens from the finite element analysis agree well with the experimental data, and choosing the rightful stress - strain relationship, utilizing ansys program, the test process can be well simulated. at the same time, making used of the program, the traditional shear wall is analyzed. it shows that comparing with the traditional shear wall, the hollow shear wall ' s cracking load drop 16 %, yield load and failure load drop 13 %, stiffness drop 13 % ~ 22 %
其次在試驗的基礎上，將試驗手段、有限元數值模擬方法和理論分析結合起來，利用有限元程序ansys對其中的兩片墻板進行非線性有限元分析，並對前後的承載性能，裂縫發展、鋼筋應變進行了比較和分析，結果表明有限元節點模型分析的荷載-位移曲線和試驗測得數據符合良好，選用合理的材料本構模型，利用ansys可以較好的模擬試驗過程；同時利用有限元模型對比分析了普通剪力墻和空心剪力墻，空心剪力墻與普通剪力墻對比，其開裂荷載下降16 ，屈服荷載、極限荷載下降13 ，剛度下降13 22 ，開裂至屈服、屈服至極限荷載階段的剛度衰減規律與普通剪力墻基本一致，空心剪力墻的後期剛度比較穩定。 -
The load - deflection curve, the load - strain curve, earth pressure and distribution of sub - grade contact pressure under concentrated load, moving load and load at the side of the coal unloading chute respectively are obtained and discussed ; the whole process from cracking to failure are studied
分別對其在集中荷載、移動荷載及堆載等作用下的側向土壓力、基底反力的分佈情況以及結構構件的荷載?應變規律、荷載?撓度變化規律和結構從開裂到破壞的全過程進行了試驗研究和理論分析。 -
The pseudo - dynamic test of 1 / 3 - scale model six - story building assembled with hollow shear wall with seams. the internal forces, the deformation and the failure mechansm of the building under earthquake are studied. the rules of frequency, damping and response spectrum are studied. the characters of earthquake response such as structure displacement, interstory drift, action of earthquake, the amplificatory coefficient of acceleration and the rule of strain are discussed. at last, this paper presented the design method of this structure based on the aseismic style and put forward the construction
進行了帶縫空心剪力墻結構六層樓房的1 3模型的擬動力試驗，研究了結構在水平地震作用下的受力特點、變形特徵、破壞形態等力學性能；得到了結構在不同受力階段的頻率、阻尼、反應譜等動力特性變化規律；討論了結構各樓層的水平位移、層間位移、地震力、加速度放大系數及構件應力分佈規律等結構地震反應特徵；指出了結構的抗震類型、薄弱層及薄弱部位；提出了多層帶縫空心剪力墻結構的第一階段設計方法和相應構造措施。 -
Fractal character of fault surface is studied and analyzed with fractal theory n catastrophe theory and similar material modeling fem numerical simulation. at the same time the effect of fault surface on the failure regularity of rock masses is discussed. stress - strain distribution regularity of rock masses with different fractal fault in mining condition is analyzed
本文運用分形、突變理論及相似材料模擬實驗、有限元數值計算等手段，研究、分析了斷層面的分形特徵，探討了斷層面的存在對于巖體移動規律的影響，分析了含有不同分形維數斷層面的煤巖體在采動條件下的應力應變分佈規律。 -
Abstract : a previously proposed approximate quasi - static theoretical method is employed herein to examine the deformation and perforation of a simply - supported circular plate struck by a flat - faced projectile at normal incidence. based on the principle of virtual work, static load - displacement relationships are first obtained and then used to predict the energy - absorbing capacity of the plate subjected to relatively low speed impact. it is shown that good agreement is obtained between the theoretical predictions and the available experimental data, provided that adiabatic shear plugging failure does not occur, but the influence of strain rate sensitivity is taken into account
文摘:採用準靜態近似理論方法分析簡支圓板在平頭彈丸正撞下的變形和穿透.首先基於虛功原理得到了靜態荷載位移關系，並將其用於預測低速沖擊下圓板的能量吸收能力.當考慮了材料的應變率敏感性，並且不發生絕熱剪切沖塞破壞的前提下，理論預測和實驗結果吻合良好 -
For the cyclic deformation under a given strain at room temperature, cyclic softening is usually displayed till to failure in the lower range of strain ; however, cyclic hardening is displayed in the early stage in the higher range of strain, subsequent cyclic softening in the later stage and till to failure
對于室溫下恆應變幅的循環變形，在應變幅較低時表現為循環軟化直至疲勞破壞;在應變幅較高時，循環變形的初期為循環硬化，隨后是循環軟化直至疲勞破壞。
分享友人