stress factor 中文意思是什麼

stress factor 解釋
應激因子
  • stress : n 1 壓力，壓迫，緊迫，緊張。2 【語音】重音；重讀；【詩】揚音；語勢，著重點。3 重要（性），重點，...
  • factor : n 1 〈英國〉經銷人；（代客買賣收取傭金的）經紀人；代理商；代辦人；〈蘇格蘭語〉 土地經管人。2 要素...
  1. The acoustic emission also shows a decreasing rate, following the drop in stress-intensity factor.

    隨著應力強度因子的下降，聲發射也隨著減少。
  2. By means of bending tests of three - point and four - point, complex fracture experiments were made for cast iron material with crack. the stress intensity factor and breaking direction angle of cast iron material were measured and compared with theoretical values. based on the research some useful conclusions are given for engineering design and application

    通過3點彎曲和4點彎曲實驗方法，對含有裂紋的鑄鐵材料進行復合型斷裂實驗研究，測試鑄鐵材料的應力強度因子、斷裂方向角，將實驗結果與理論值進行分析、比較，找出兩者之間的異同點，得到一些對工程設計及應用具有實際意義的結論。
  3. First, the theory of fretting wear and studies on fretting fatigue were introduced and the parametric method was used in the process of creating the model of dovetail joints in ug software. the elastic contact problem is analyzed in finite element method ( fem ) and is used to the parameters " distribution and contact stress of the joint are obtained on the base of ansys code. with the effect factor of load frequency, the prediction method of fretting fatigue life of dovetail joint under low and high / low cycle complex load is proposed

    本文介紹了微動損傷的機理和微動疲勞壽命的研究方法；利用ug軟體對燕尾榫聯接結構創建了參數化實體模型；基於ansys軟體平臺求解彈性接觸問題，獲得了榫聯接結構接觸應力及接觸狀態量的分佈；在已有微動疲勞壽命預測模型的基礎上，引入載荷頻率影響因子，對低周、高低周復合載荷作用下的燕尾榫聯接結構進行了微動疲勞壽命的預測，與試驗結果對比表明採用本文提出的方法預測榫聯接結構的微動疲勞壽命是有效的。
  4. Utilizing dynamical finite element method based on equipollence linearity model, found the dynamical stress field and the acceleration field, make the foundation for calculated the safety factor of the dam slope with finite element method

    運用有限元法分析壩體穩定的基本原理，根據得到的壩體動應力分佈場計算了壩體的動力穩定安全系數。
  5. Utilizing pseudo - static method theory, calculated the safety factor for the dam slope, give, a primary conclusion. utilizing static finite element method based on duncan - chang hyperhola modelfound the static stress riele, make the foundation for hynamical finite element analysis. utilizing dynamical finite element method based on equipollence linearity model, found the dynamical stress field and the acceleration field, make the foundation for calculated the safety factor of the dam slop with finite element method

    運用擬靜力法的基本原理，對滿拉堆石壩的壩坡穩定進行了分析研究，得出了初步結論；採用duncan - chang雙曲線模型，用計算土石壩應力及變形的靜力有限元程序，對滿拉堆石壩進行了靜力有限元分析，得到了壩體的靜應力場分佈，為動力有限元計算打下基礎。
  6. As found in example 1, the stress concentration factor for the fillets is equal to 1. 78.

    如例1中所求出的，圓角的應力集中系數等於178。
  7. The relatively small reduction in stress intensity magnification factor with increasing stiffness of the stiffener.

    隨著加強肋剛度的增加，應力強度放大因子則相應有所減小。
  8. Atlas of stress distribution and graphs of stress concentration factor ( scf ) were obtained. the atlas and the graphs showed that the scf at the joint crease nonlinearly with the accretion of r / r and the minuet of t / t

    結果表明連接點處有明顯的應力集中，並且這種應力集中是隨著開孔率增大和厚度比減小呈現非線性增長的。
  9. It can give vector of stress, and break factor and direction vector of tensive crack and shearing crack in the special observation planes ( for examples, in a stratal surface which is fluctuant in depth )

    軟體可視化包括：空間應力矢量（大小和方向） 、裂縫性態（張裂縫和剪裂縫發育程度及其方向矢量）在特定觀察面（如沿起伏的地層面）上的展示。
  10. Taking the contact stress, bend stress stiffness and temperature stress as the condition, taking the weight of the kiln tyre as optimization aim function, the redia and the width of the tyre are optimized general optimize methods just consider the affecting of the parameters to aim function, but in fact, structural parameters ( such as structure dimension, interval and so on ), physics and dynamics ( damp factor, conduct factor, friction factor material ' s elastic module strength limits and so on ), which would be changed after used. the difference are called discrepancy robust design ' s basic concept is : all design parameters " discrepancy will affect the aim funct ion and arouse the quality target discrepancy

    一般的優化方法，僅僅考慮了參數對其目標函數的影響，而實際情況下有些參數是變化的，產品的結構參數（如幾何尺寸、間隙等） 、物理和力學參數如阻尼系數、傳導系數、磨擦系數、材料的彈性模量和強度極限等的設計值與製造后和使用中的實際值會有差異，這種差異稱為設計變量和噪聲因素的變差。
  11. Based on the aircraft structure fatigue theory, the article discussed the theoretical basis of methods that are usually used for aircraft structure fatigue crack - forming life estimation, i. e. the stress severity factor approach ( normal stress approach ), the local stress & strain approach, detail fatigue rating approach ( dfr ). also the processes of life estimation of these approaches are studied in the article

    文章在簡要介紹飛機結構疲勞強度理論的基礎上，對目前飛機結構勞疲勞裂紋形成壽命估算常用的應力嚴重系數法（名義應力法） ，局部應力應變法，細節疲勞額定值dfr法的理論依據作了較詳細的論述，同時對這些估算方法進行壽命估算的過程與步驟也作了詳盡的闡述。
  12. The occurrence of high shear stress at the fibre end is a factor which is expected to lead to crack generation.

    在纖維端部存在高切變應力視為導致產生裂縫的因素。
  13. The content of this thesis, through the deformation destruction process of th e typical nanlidu landslide along the national highway 318, uses the finite unit a nalysis of computation, revealing the elastic, plastic stress and displacement of each joint inside the slide area pointing out the distribution range of the tension stress and the plastic deformation range, computering the stability safety factor of the slide area, gaining the fixed quantity, quota that evaluates the stability of the slide area, revealing the position of the slide area which is most likely to los e its stability, thus, it can provide theoretic proof for the programs which renova te landslides

    本文的研究內容是通過318國道南里渡典型滑坡的變形破壞過程，採用有限元計算分析，揭示滑體內部每個節點上的彈、塑性應力及位移，找出拉應力分佈區和塑性變形區，計算滑體穩定安全系數，得出衡量滑體穩定的定量指標，揭示滑體最可能失穩的部位，從而為滑坡整治方案提供理論依據。
  14. To validate the formulated transition element for the calculation of the hot - spot stress and stress concentration factor in the welded components by experimental results, the stress concentration factor of the experimental welded specimens carried out in the research group is calculated by using the developed plane - transition element. the calculated stress concentration factor in the two types of tested welding components agrees well with that obtained from the experimental result. and the calculated result on the tendency of hot - spot stresses agrees well with that from the measured result

    為了驗證文中構造的過渡單元模型用於分析焊接節點附近的應力集中問題的正確性和有效性，進一步又對過渡單元模型進行實驗結果驗證，採用平面過渡單元模型計算了本課題組進行的兩類焊接構件的應力集中系數，並與根據實測方法得到的應力集中系數進行了比較，計算結果與實驗測試得到的應力集中系數和相應的熱點應力變化趨勢比較吻合，為本文建立的過渡單元的實際應用提供了初步的基礎。
  15. Effect of electroacupuncture on gastric mucosal intestinal trefoil factor gene expression in the rat of gastric mucosal injury induced by stress

    電針對應激性胃黏膜損傷大鼠胃黏膜腸三葉因子基因表達的影響
  16. While cyclic deformation experiment under constant strain control is performed in 400, the material shows the continuous hardening until cyclic invalidation. ( 3 ) back stress attained by kwl " s method is used to analyse the bauschinger effect during an incremental step cyclic test and cyclic deformation test under constant strain control, it is shown that back stress increases with increasing plastic strain and the numbers of cycle, and the back stress is uniform, regardless of tension or compression conditions. ( 4 ) as far as recrystallized zircaloy - 4 plate is concerned, the back stress in transverse direction is higher than that in rolling direction due to the higher schmid factor in rolling direction

    對于再結晶狀態的zr一4合金板材試樣來說， t方向（橫向）試樣的背應力要高於r方向（軋制方向）的背應力，原因在於r方向的schmid因子高於t方向的schmid因子; 400下， zr一4合金的背應力要明顯低於室溫下的背應力;含氫200pg / g的zr一4合金的背應力大小與無滲氫的zr一4合金背應力相比，無明顯區別;固溶處理后， zr一4合金的背應力大小發生了變化，在較高塑性應變下，背應力均高於固溶處理前的背應力。
  17. According to the minimum principle in energy, we analyze the microcosmic mechanism of magnetic domain construction and the main factor that affect the shape, size and connecting of the magnetic domain etc. from the microcosmic mechanism of ferromagnet, we analyze how stress influence the magnetic domain and magnetic domain wall, and discover the increase of stress energy and magnetism elasticity energy which destroy the balance of system energy make up the influence of magnetic domain structure, then set up basic disciplinarian between stress and characteristic of magnetism

    同時根據能量最小原理，從理論上分析了磁疇結構存在的微觀機理以及影響磁疇結構運動、變化的主要因素，得出了應力的存在將影響磁疇的形狀、大小和搭配方式等結論。從鐵磁晶體的微觀機理出發，研究了應力對磁疇和磁疇壁的影響，發現應力影響磁疇結構的本質是由於應力的作用使得鐵磁晶體增加了應力能和磁彈性能，體系為了達到新的平衡，導致了磁疇結構變化，並研究了應力與鐵磁晶體磁特性之間的基本規律。
  18. The sole stress factor of alkaline salt is its high ph value

    堿性鹽所獨有的脅迫因素是高ph值。
  19. Cellular membrane is the possible action site for elf - emf, and the related studies confirmed that the receptors on cell membrane could be clustered by physical stress factor, and the receptors transduced the signal into cells via cellular signal pathway

    細胞膜是電磁場信號的可能耦合位點，相關研究也證實了細胞膜受體在細胞轉導物理性應激因子中的作用。
  20. Wind stress factor

    風壓系數
分享友人
分享到 Line

分享到臉書