substrate cycle 中文意思是什麼
substrate cycle
解釋
底物循環-
The ha coating is easily broken off from the substrate because of the interface corrosion, caused by the body fluid, and the cycle load. the preparation of the bg / ha bioactive graded coating on the surface of ti6a14v is an effective way to alleviate the heat stress
在鈦合金表面制備生物玻璃（ bg ） ha梯度塗層，來緩和因熱膨脹系數不匹配而造成的塗層內部過高的熱應力是解決以上問題的有效途徑之一。 -
While the chips are attached to near center or near a edge of subatrate, the mean, deviation and maximum are at the almost same level ; when the chip is attached near a corner, the deviation and the maximum is far larger than those of the above two positions ; during thermal treatment followed, the residual stress demonstrates a regular cycle trend when the chips are attached near center or edge of the substrate and fluctuates in a wide range when the chip is attached near a corner
當晶元粘貼在基板中心和靠近基板邊緣的位置時粘合劑固化后殘余應力的平均值、最大值和數值的分散性皆處于相接近的水平，而當粘貼在基板靠近一角的位置時應力分佈狀況則有很大不同：應力的分散性增大，應力最大值也遠大於粘貼于另外兩個位置時的值。 -
Then based on the principle for pcr, 20 - cycle continuous - flow pcr is designed using cad software. to the designed 20 - cycle continuous - flow pcr chip, a krf excimer laser ( direct write method ) is adopted as the fabrication technology, and the polymethyl methacrylate ( pmma ) is selected as the substrate. so the appearances of pmma surface etched before and after by 248nm excimer laser under different incident fluences are analyzed using sem
為此在應用掃描電鏡和三維形貌分析儀對pmma表面被準分子激光刻蝕前後的形貌、刻蝕粗糙度以及單脈沖刻蝕率等進行詳細分析的基礎之上，總結出了準分子激光刻蝕pmma的宏觀規律和微觀刻蝕機制，提出了一種準分子激光刻蝕pmma的是光熱光化學以及羽輝共同作用的理論解釋。
分享友人