supplied load 中文意思是什麼
supplied load
解釋
饋電負載容量-
The problem of energy saving of water systems in the operating condition of part load is studied. the aim is to get a more reasonable control method. using this method, the supplied flux of chilled water can meet the needed flux of the building during the operating times of part load, the on / off condition of pumps and chiller can be decided reasonably and it has the advantage of saving energy in pumps and chiller
本論文主要研究空調水系統在部分負荷下輸送的節能問題，其目的在於尋求一種較合理的控制方法，使冷水機組和水泵在空調部分負荷下運行時，輸送的冷量與實際建築物所需冷量相匹配，以決定水泵和冷水機組的啟停，最大限度地節約水泵輸送能耗及冷水機組的製冷能耗。 -
The results of the experiments has shown : the lpg / diesel dual fuel engine has kept its high power performance and reduced its emissions, especially the soot and nox after the fuel - supplied system has been set up ; the fuel economy performance has been improved at some degree when high load ; however, when lpg ratio increased, the engine showed the trend of violence for high compression ratio
試驗結果表明：在採用了自行設計的聯動式燃油供給系統后， lpg柴油雙燃料發動機在保持原機高功率的同時，排放量，尤其是碳煙和no _ x有大幅度的降低；在高負荷時，其燃油經濟性也有相當的提高。但當lpg的摻燒比加大到50以上時，會出現工作粗暴的傾向。 -
The conventional connection circuit as the figure shows for two - wired transmitter : handhold terminal palm computer and external communication interface or mainframe communication circuit cannot directly bridges in the ends of power source. but may either meet on field ends a and b or meet on the ends of load resistance b and c. in the above - mentioned case, the circuit are supplied by power source
對兩線制變送器來說，傳統的連接電路如圖所示：手持終端掌上電腦和外接通訊介面或主機通訊電路不能直接跨接在電源兩端，但既可接于現場兩端a ， b上，也可接在負載電阻兩端b ， c ，兩種情況下，電路都要通過電源來供電， hart規范允許負載電阻為2301100 。 -
Using dynamic load that applied by the simulation above, the dynamic analysis and lighten - weight optimization of spider were done. getting stress history supplied testing data for its service life analysis
利用剛柔耦合模擬得到的動載荷對十字軸進行了動力學分析和優化減重，並提取了十字軸的應力時間歷程曲線，為十字軸的疲勞壽命分析提供了有效的試驗數據。 -
Four computer teachers form an it team to carry out the it pilot scheme. a supplied teacher was hired to ease their teaching load
由四名老師組成資訊科技小組，執行資訊科技先導計劃另額外聘用一名輔助老師分擔該等老師的教學工作 -
Firstly, the input three - phase ac is converted into dc after it passes rectifier and filter circuit. secondly, the dc is changed into three - phase ac which frequency and value can be continuously adjusted. lastly, the output three - phase ac is supplied to load
該實驗單元首先把輸入的三相交流電經整流濾波后變成直流電，然後把直流電逆變成頻率和電壓大小可調的三相交流電，供給三相對稱負載。 -
Load is supplied to rubber or spring and weighted by measurement of displacement ( distance ), which method requires obvious dimensional change and is not a good choice of starting torque compensation
載荷重量施加在橡膠或彈簧上，通過測量位移（即距離）變化來間接稱重，間接稱重一般需要有比較明顯的尺寸變化，間接稱重方式一般不適合做起動力矩補償 -
( 4 ) reliability indexes of system and load point are analyzed, such as lolp ( loss of load probability ), flol ( frequency of loss of load ), dlol ( duration of loss of load ), lole ( loss of load expectation ), edns ( expected demand not supplied ) and eens ( expected energy not supplied )
對全網及各負荷點的可靠性指標如系統失負荷概率lolp 、失負荷頻率flol 、失負荷持續時間dlol 、失負荷期望lole 、電力不足期望edns 、供電量不足期望eens等進行了計算分析。 -
Dr. fu you developed paractivf +, which has enhanced the functions of dynamic load balaneing, and parallel zed the programs supplied by. the school of energy and power engineering, xian jiaotong university
付游博士將paractive擴充了計算負載動態平衡的功能，開發成功了paractive + ，對西安交大能源動力工程學院提供的程序實現了并行化。 -
In the power transmission system, reactive capacity and active power is closely related to each other, at feeding power load required active power and reactive capacity. if a mount of reactive capacity could be supplied by far location but no local station, a great deal of reactive capacity and active power would be wasted, and its voltage be descended
在電力傳輸系統中，無功功率和有功功率是密切相關的，在輸送電力負荷所需要有功功率的同時必須消耗一定量的無功功率，同時輸送無功電力也需要消耗有功功率。如果大量的無功電力不能就地供應，靠長途輸運，就會產生較大的無功和有功損耗及電壓降落。 -
This type of configuration requires a much higher power supply voltage, since the power supplied to the output stage is supplied through this load resistor
這種結構需要一個很高地電源高壓，因為輸出級的高壓需要通過負載電阻。 -
This method, adopting admittance model in load bus and using the activities supplied by pss / e, can compute the voltage stability limit effectively. the difficulties connected with the singular load flow jacobian matrix are overcame in this algorithm
該方法通過調用pss e的潮流計算模塊，採用負荷導納模型，有效地克服了臨界點附近常規潮流雅克比矩陣奇異所帶來的收斂困難，且簡單易行，計算速度快，概念明確。 -
Introduces a method to calculate the equipment capacity of ice - storage air conditioning system in the condition that the cooling load of buildings is sometimes less than that supplide by the chiller operating compltely and this load is thus supplied by the chiller operating under - capacity
介紹了冰蓄冷空調設計中建築物某些時刻的冷負荷小於製冷機的全額供冷量而由製冷機減負荷運行供冷的設備選擇計算方法。
分享友人