swing check valves 中文意思是什麼
swing check valves
解釋
旋啟式止回閥-
Swing check valves prevent reversal of flow through pipe lines
旋啟式止回閥可以防止管路中的流體倒流。 -
Compressed gas cylinder valves ; swing check valves for camping - cylinders
壓力氣瓶閥.野營用儲氣瓶的旋轉止回閥 -
Note : on pump discharge, the preferred check valves are an in - line spring loaded, swing design with lever and weight or lever and spring
注意:在泵的排泄口處,首選的止回閥是管內彈簧負載,旋啟式,配置杠桿和重量或杠桿和彈簧。 -
Velocity equations are included in the technical data section. when sizing swing check valves, the seat port velocity should be controlled within the general ranges specified below
《技術資料》內包括流速公式。在選擇旋啟式止回閥的通徑時,閥座埠的流速應該控制在下列指定的一般范圍內。 -
For best performance swing check valves should operate with fluid velocity sufficient to hold the disc in a stable position off the seat or fully open against the disc stop
為了獲得最好的性能,旋啟式止回閥應該運行在流量速度足夠將閥瓣穩定支撐在離開閥座的位置,或讓閥瓣停止在全開的位置。 -
Correct sizing of swing check valves is important
旋啟式止回閥通徑的正確計算和選擇非常重要。 -
General purpose industrial valves - steel swing check valves
通用閥門鋼制旋啟式止回閥 -
J kind of bronze 0. 5mpa swing check valves
J類青銅0 . 5mpa旋啟式止回閥 -
Swing check valves are best suited for moderate velocity applications
旋啟式止回閥最適用於中流速應用環境。 -
Swing check valves are normally designed for installation in horizontal pipe runs
旋啟式止回閥通常適用於安裝在水平管道上。 -
Swing check valves
旋啟式止回閥 -
Valves may be sized to match existing lines, but swing check and stop - check valves should also be sized according to flow conditions for maximum service life
可以根據現存的相匹配的管線來確定閥門通徑,但是旋啟式止回閥和截止止回閥還應該根據最大限度延長使用壽命的流體狀況來確定閥門通徑。 -
Shipbuilding - cast iron 10k swing check valves
造船.鑄鐵制10k回轉式止回閥 -
Shipbuilding - cast iron 5k swing check valves
造船.鑄鐵制5k回轉式止回閥 -
Shipbuilding - bronze 5k swing check valves
造船.青銅制5k回轉止回閥 -
Most crane swing check valves can be installed in horizontal or vertical, upward flow, piping
大多數美國克雷恩旋啟式止回閥可以安裝在水平或垂直(流向朝上)的管路上。 -
Swing check valves can be adversely affected by turbulence if placed too closely to other piping components such as pumps, control valves, meters, reducers, tees, elbows, etc
如果過于靠近其它管道部件,如泵,控制閥,儀表,收縮管,三通,彎管,等等,旋啟式止回閥可能會被湍流反作用。
分享友人