temperature calculation 中文意思是什麼

temperature calculation 解釋
溫度計量
  • temperature : n. 1. 溫度，氣溫。2. 體溫。3. 〈口語〉發燒，高燒。
  • calculation : n. 1. 計算，計演算法。2. 推定，預測。3. 深思熟慮，精打細算；慎重的計劃；算計。
  1. The thesis has summarized the development of the oblique - pull bridge, its construction technology and the importance of bridge construction control, then has introduced project general situation, and has narrated detailed regulation, organization construction, the major work and difficult part of this bridge construction control. the following is the key part of this thesis, firstly, it has introduced the experiment work of early stage, structural calculation and its theoretical result : the absolute altitude of each operating mode, the absolute altitude of building mould in each section and the absolute altitude after pouring concrete ; then, it has discussed the method and content of the line shape control of the main beam, actual absolute altitude of building mould is put forward, and it has described the method of structural stress monitoring, how to arrange measure point and collect data, and how to analyze data. it has also narrated the method of rope force detection and structural temperature inspection

    本論文在總結了斜拉橋的發展及其施工工藝，並指出了橋梁施工控制的重要性之後，簡要的介紹了工程概況，敘述了炳草崗金沙江大橋監控細則、組織機構及監控的主要工作和難點部分；論文的核心部分，在介紹了炳草崗金沙江大橋施工控制與監測工作的前期實驗工作和施工各工況標高、各節段支模標高、澆注混凝土后的標高的結構計算和其理論計算結果之後，詳細論述了主梁的標高線形控制方法和內容，實際支模標高的提出，結構應力監控的方法、布點、測讀及其對測讀數據的合理分析方法，索力檢測和結構溫度監測的方法。
  2. Finite element method was used for the calculation of temperature field, temperature gradient and thermal stress of the coal water slurry ( cws ) ceramic nozzle

    摘要採用有限元法對陶瓷水煤漿噴嘴溫度場、溫度梯度及其熱應力進行了分析計算。
  3. Numerical calculative simulation could factually reflect the dynamic characteristics of the whole equipment and inner flow and diathermancy of split - stirling crycooler. through the calculation, the velocity, temperature, pressure and other detailed information of airflow in any position inner the crycooler could be gained ; the distribution of each parameter could be confirmed and reasonable explanation for the experiment result could be made

    數值計算模擬能接近真實地反映分置式斯特林製冷機的整機和內部流動、傳熱的動態特性，通過計算可以得到製冷機內部任一位置的氣流流動的速度、溫度、壓力等詳細信息，確定各參數的分佈情況，並可以對實驗結果做出合理的解釋。
  4. First by estimative calculation the final boundary condition can be gained, then the accurate result of three - dimension temperature field and stress can be gotten through placing accurate boundary condition

    得到了三維溫度場和應力場數據結果。在計算過程中採用了根據實測值反算的思路，使計算得到的溫度場有可靠的實驗依據。
  5. The theoretical calculation and the experimental result indicated that, after temperature compensation, this kind of new hotwire air mass flowmeter still had high measuring accuracy when the environment temperature had wide range change

    理論計算和試驗的結果表明，經環境溫度補償后，這種新型熱線式空氣質量流量計在大范圍環境溫度變化下仍具有較高的測量精度。
  6. At first the finite element theory for temperature analysis is introduced, and then mainly discussed the calculation models of cement hydration heat and the boundary condition under sun radiation

    首先對這一方法的基本原理進行了簡要的介紹，著重探討了計算中的水化熱計算模型、日照邊界條件處理等。
  7. The calculation method using in factory has larger error and is n ' t used in high ignition point oil transformer. in this paper a calculation method, which has been verified by experiment results, is presented based on the fundamental theories and rule equation of heat transfer to calculate the temperature rise of average oil, top oil, coil, core and hot - point. a program has been compiled

    本課題立足於工程實際應用，根據傳熱學基本原理和經典試驗換熱準則式，通過對變壓器發熱冷卻原理進行分析和研究，提出了一套計算變壓器平均油溫升、頂油溫升、繞組溫升、鐵芯溫升和最熱點溫升的計算方法並編制了計算軟體，對影響變壓器溫升的因素進行了分析。
  8. Abstract : the paper established the idea of passive solar houses with zero - auxiliary heating source as well as the calculating method for the design and passive solar house. based on the ratio of radiant temperature difference i. e. thermal design and calculation method for passive solar houses with zero - auxiliary heating source

    文摘:著重介紹零輔助熱源被動式太陽房的概念及以輻射溫差比為設計依據的被動式太陽房熱工設計計算方法零輔助熱源被動式太陽房熱工設計計算方法
  9. Abstract : from the point of theoretical analysis, this dissertation provides the coupling calculation on the hot gas temperature field and ablation in the cavity between stress release boot and insulation of solid motors. through the calculation, some law of the ablation of the stress release boot is found

    文摘:從理論分析的角度出發，通過對人工脫粘層和絕熱層所構成的槽縫燃氣溫度場與燒蝕的耦合計算，得出了人工脫粘層的燒蝕規律。
  10. This system contains four modules, data input, data update, data search and solidus / liquidus temperature calculation, which can achieve managing the thermal physical parameters expediently and efficiently

    系統包括參數錄入、數據更新、數據查詢和液固相線溫度計算模塊，實現了對參數數據的集中有效管理。
  11. Based on developed experimental testing facility, the shading performances of southing horizontal shading devices, vertical shading devices and integrative shading devices of external windows are measured, the performance parameters including indoor temperature, air - conditioned cooling load and shading coefficient as so on. and the shading coefficient of experimental test results and calculation results based on design standard for building energy efficiency are compared, and the windows5. 2 simulation results are compared also. the measured results are consistent with the calculation results of horizontal shading devices and vertical shading devices

    本文利用研製的建築遮陽性能檢測裝置，對南向水平遮陽板、垂直遮陽板和綜合遮陽板外窗的遮陽性能（包括室內溫度、空調耗冷量和遮陽系數等）進行了實驗測試，並對遮陽系數的實驗測試結果與節能設計標準的計算值以及windows5 . 2軟體的模擬結果進行了比較分析，測試結果表明水平遮陽板和垂直遮陽板外窗的遮陽系數與計算結果比較一致，相對誤差分別為2 . 5 %和4 % ，而綜合遮陽板外窗的遮陽系數與計算結果的差值比較大，相對誤差達到10 %以上。
  12. Comparison of calculation methods of limit of superheat temperature of liquid helium

    液氦極限過熱度計算方法比較
  13. Influence of earth temperature gradient on ground stress calculation in underground mines

    地溫梯度對地下礦山地應力計算的影響
  14. The temperature distribution on the high temperature side of an electric tunnel furnace is analysed and simulated on the basis of the principle of thermal radiation by the way of thb ( thermal heat balance ). the heated silicon carbon sticks are decomposed into innumerable tiny heating faces, which exchange the heat with the heated materials. a numerical model based on the radiation intensity law is constructed to calculate the energy absorbed by the heated materials and simulated by a computer. the results showed that the even distribution of temperature can be obtained by optimizing the arrangement of the silicon carbon sticks according to the calculation results to make the structure design more reasonable. these calculation results have been used in the practical designs and the expected objectives achieved

    利用熱輻射原理，採用熱平衡法對電熱隧道窯的高溫恆溫區溫場進行了分析和模擬.計算中將發熱棒分解為無數微元發熱面與燒結體進行熱交換，依據輻射強度定律，建立了燒結體接收能量的數學模型，並用計算機進行了模擬計算.結果表明，依據模擬結果來優化硅碳棒的排布，可使結構設計更加合理，進而可以獲得分佈均勻的恆溫區溫場.計算結果已在窯爐設計中應用，實踐效果良好
  15. Mathematical model for temperature distribution calculation during wheel quench heating process is established and used in the simulation of a certain type wheel

    摘要根據馬鋼車輪淬火加熱爐的實際狀況，建立了車輪淬火加熱過程溫度場計算模型。
  16. This paper establishes a model simulating dam actual placing process and considering the non - continuity of initial temperature on the boundary of new and old concrete, daily air temperature change, concrete - placing temperature, hydration heat, heat insulation on boundary, water - storing process, placing intermission and curing with water. the calculation of stress field considers the concrete weight, static water pressure, thermal stress, different autogenous volume change between rcc and normal concrete, change of elastic modulus of concrete with age and creep action

    考慮了乞今最為全面的初始條件和邊界條件，包括模擬壩體的實際升程過程，考慮了新老混凝土接觸面上的初始溫度不連續，逐日的氣溫變化，混凝土的入倉溫度，水化熱溫升，邊界保溫，水庫蓄水過程，澆築間歇以及灑水養生等因素；應力場的計算考慮了混凝土的自重，靜水壓力，溫度應力，常態混凝土與碾壓混凝土不同的自生體積變形，混凝土的彈性模量隨齡期的變化以及徐變的作用。
  17. The calculation method of the enamel glaze baking temperature

    搪瓷燒成溫度計算方法
  18. After the temperature measurement system is scaled by the black body furnace, we use least square method and neural network to calculate the temperature respectively according to the images taken from both the black body furnace and the common coal furnace. through comparison the calculation data with the result of thermocouple, an improved method of neural network is proposed. this method is more practical and precise

    根據標定結果，本文用最小二乘和神經網路兩種方法分別對黑體爐和普通煤爐的圖像進行了溫度計算；通過比較熱電偶輸出的溫度值和計算的結果，提出了一種改進的神經網路方法，該方法更適用於工程實際，其測溫精度較高。
  19. This temperature calculation method avoids the non - correspondence between the flow rate and heat flux, which may exists in that used by boiler manufactures, and was employed to calculate the tube temperature of dangerous position that concerns with the retrofit scheme of superheater 1 of tower type coal - fired 330 mw once - through boiler in pucheng power plant for 100 % and 50 % operation load

    針對蒲城電廠330mw塔式燃煤直流鍋爐1號過熱器的改造方案，利用本文提出的方法與電廠鍋爐常用的壁溫計算方法分別計算了100 %與50 %鍋爐運行負荷下危險部位的壁溫。
  20. According to the thermodynamics theories, reaction free energy and adiabatic temperature in zro2 - b _ 2o _ 3 - mg system have been theoretically calculated and analyzed. results of adiabatic temperature calculation showed that the adiabatic temperature of zro2 - b _ 2o _ 3 - mg system without diluent was 3093k, and it reduced with improvement of diluent content. when the diluent mgo content was 0 ~ 45 %, or the diluent zrbb2 content was 0 ~ 62 % the shs process would occer

    絕熱溫度計算表明:稀釋劑含量為零時， zro _ 2 - b _ 2o _ 3 - mg體系的絕熱溫度tad為3093k ，隨著稀釋劑含量的增加絕熱溫度呈現逐漸降低的趨勢，得出了稀釋劑mgo含量在0 45 % ，稀釋劑zrb2含量在0 62 %之間的所有組分的體系均有足夠的熱量來完成燃燒合成反應的結論。
分享友人
分享到 Line

分享到臉書