tensile phase 中文意思是什麼
tensile phase
解釋
拉伸帶-
Tensile properties and impact properties measurements were done at room temperature. the volume resistivity of rectangular samples was measured using a zc36 electrometer and a high 240a voltage supply, for samples with a low resistivity level a dt - 9205b digital multimeter was used, silver paint was applied to ensure complete contact between sample and electrodes, namely, to eliminate the contact resistance. the phase morphology of blends was also studied using a jeol jsm - 5900lv scanning electron microscope ( sem )
體積電阻率的測定：當r _ v 10 ~ 8時，製成100 100 4mm板材，用zc36型高阻儀測量；當r _ v 10 ~ 8時，用dt - 9205b型數字式萬用表測試試樣的體積電阻，為了減小接觸電阻對測試的影響，採用銀導電膠將銅片粘接在試樣的兩個端面上，靜置24小時，待銀導電膠凝固，試謝長瓊:熱拉仲對pet / pe / cb復合導電體系形態和性能的影響樣的電阻穩定后再測量。 -
Moreover, rare earth ceo2 can clean the melt and the face of reinforced particles and improve the wettability between the reinforced phase and melt and the property of material. proper additive mg and rare earth can improve the hardness, wear - resisting property tensile - strength, elongation percentage of tic / al, tic / al - si composite
加入適量添加劑mg和稀土ceo _ 2使原位tic al ， tic al - si復合材料的硬武漢科技人學碩1 ：論義度、咐磨性、抗拉強度、延伸率得到很大的提高。 -
There are reverse relationships between room - temperature fracture toughness and tensile ductility with the change of grain sizes in two - phase tial - based alloys. but the essence of the reverse relationships is not clear. in order to solve these problems, it is vital to investigate room - temperature fracture mechanisms of tial - based alloys
另外隨著晶粒尺寸的增加tial基合金的室溫塑性與斷裂韌性呈現相反依賴關系，這種相反依賴關系的本質至今還不是很清楚，要解決這些問題，也必須搞清楚其斷裂機理。 -
Through the characterization of the molecular weights of pam, sem and dsc of composite, the results clarified the change of mechanical properties of composites. the tensile strength and impact strength of pam2 / pa - 6 composite showed that were related to the content of initiator naoh for the polymerization of e - caprolactam. the intrinsic viscosity of pam, sem and the crystallinity of nylon phase carried out the results, which explained the change of mechanical properties of composites
對于pam2 pa - 6體系，復合材料的拉伸強度與沖擊強度隨醛胺摩爾比的變化趨勢與引發劑用量有關，通過pam2分子量、尼龍結晶度、球晶形態、 sem以及dsc等表徵方法對這種變化趨勢的研究表明，復合材料的力學性能與上述因素有密切的關系。
分享友人