tension zone 中文意思是什麼

tension zone 解釋
張力帶
  • tension : n 1 拉緊;伸張。2 (精神、局勢等)緊張。3 【物理學】張力,拉力,牽力;(彈性體的)應力;(蒸氣等...
  • zone : n 1 【地理】(地)帶。2 區域,范圍,界。3 〈古、詩〉(腰)帶。4 圈,環帶。5 【數學】(球面)帶;...
  1. Abstract : based on the data obtained from field observations and deformation monitoring, this paper deals with the deformation and failure of a double - decked slope composed of soft rock strata in its lower part and hard - brittle rock strata in its upper part. it is demonstrated that the deformation of this kind of slopes is always initiated by the non - homogeneous rheological compression of the lower soft rock strata, leading to the tension fracture and toppling of the upper hard rock strata, and at last the sliding of the whole deformed body will be caused by the shear failure along the stress - concentration zone in the lower soft rock mass under the actions of the gravitational loading and infiltration water

    文摘:以現場考察和變形監測資料為依據,探討一個下部有軟弱基座,上部為硬脆性坡體的「二元結構」邊坡的變形破壞問題,揭示這類邊坡的變形總是以下部軟弱巖體的不均勻壓縮流變為先導,進而引起上部硬脆性坡體的拉裂與傾倒,最終通過滲入水的作用,使下部承載狀況已進一步惡化了的軟弱巖體,沿剪應力集中帶發生剪切破壞而導致整個變形坡體的下滑。
  2. In other words, the process of analyzing relaxation zone related to one safety factor can also be regarded as the process of searching potential slide surface related to the same safety factor. elastic wedge model is used for analysis of relaxation zone of cutting homogeneous slope. on the basis of elastic plane - strain theory, the relaxation zone can be calculated according to mohr - coulomb or drucker - prager law and single tension intensity principle which are both related to one safety factor after three - dimensional stress field of the cutting slope is got

    提出均質邊坡開挖鬆弛區可以用彈性理論中的楔形體理論分析,在平面應變問題的基礎上得到開挖坡體的三向應力場之後,可運用考慮安全儲備后的強度條件(主要為摩爾?庫侖或德魯克?布拉格強度準則和單軸抗拉強度準則)解析坡體分步開挖過程中的鬆弛區范圍,給出了具體的計算步驟,並通過算例較詳細地說明了操作過程。
  3. The main causes, which have effects on redistribution of internal force in the prestressed frame, including the relative height compressive zone of section, secondary moment and types of load applying are taken into account. the horizontal braces force which results from the tension of the prestressing steel, reduces the pre - compress stress is analyzed

    並且探討了各影響因素對框架梁截面延性的影響和由於柱的抗側剛度在預應力鋼筋張拉時約束梁的軸向變形,從而影響預應力在梁中的建立所造成的梁中軸向預壓力的損失。
  4. For the cantilever beam, the theoretical stiffness and limited capacity are slightly less than the test ones if considering only the steel beam and the reinforced bars in the negative moment zone with the concrete in the tension zone ignored

    結果表明:簡支組合扁梁,忽略彈性中和軸以下受拉的混凝土的影響,採用等效換算截面方法計算所得的剛度和極限承載力與試驗結果比較吻合;懸臂梁只考慮混凝土板中配置的負彎矩鋼筋,忽略混凝土,計算所得的剛度和極限承載力比試驗結果略微偏小,但相差不大。
  5. After excavation, there are concentration phenomenon of stress at the corner or the shiplock room, and the tension zone lies in half of the middle part as well as the part of the two slopes to the lower part of the upright wall. finally the analysis results are compared with site monitoring data in period of construction as well as the feedback reports, the result of all comes to meet with each other very well

    開挖完成後,在閘室拐角處存在不同程度的應力集中現象,中隔墩上部1 2的巖體及南北邊坡至直立墻頂部平臺以下的部分巖體為拉應力區。在兩側邊坡及邊墻的塑性區出現在損傷區和部分卸荷影響區內,中隔墩大部分區域的巖體都進入了塑性狀態,閘室底板處的塑性區基本上與損傷區一致。
  6. A minimum tension is exerted on the fabric during transportation in the chainless dwelling zone

    在此直輥反應區織物能以最小的張力運行。
分享友人