testing pressure 中文意思是什麼
testing pressure
解釋
試驗壓力-
This paper discusses the designing and making of the dynamic testing systems of engine electronic control system. base on the construction and operation principle of santana 2000gsi m3. 8. 2 engine electronic control systems, design and manufacture led circuit of dynamic testing and fault imitating electronic control unit. on the inspect board, design and equip with motronic 3. 8. 2 ecu i / o measuring joints, design and set up obd - ii diagnostic communication link, design and install fuel pressure inspecting meter. depend on the obd - ii diagnostic communication link and ecu i / o measuring joints, this dynamic testing system can inspect engine electronic fuel injection system, distributorless ignition system, idle speed control system and evaporative emission control system, and can inspect m3. 8. 2 sensors, ecu and actuators, and can interrogate fault memory and erase fault memory ; and can analyse data stream ; and can carry out fault imitating. besides, this paper analyses sensors and actuators typical fault w aves
2電控單元電路連接器設計製成輸入輸出電子控制檢測端子，並在檢測面板上布置了obd -診斷插座和燃油壓力表。使該動態測試系統能實現對電噴發動機的燃油系統、直接點火系統、怠速控制系統和燃油蒸氣排放控制系統的動態檢測；並通過obd -診斷座、 ecu輸入輸出檢測端子和故障模擬處理單元實現對電噴發動機電控系統各傳感器、電控單元、執行器進行故障碼讀取與清除；動態數據讀取和波形測試和故障模擬等。此外，本論文還分析了傳感器和執行器典型故障波形。 -
In view of bearing capacity of the elastoplastic theory analysis, the author made a comparison between the achieved bearing capacity limit load pi / 4 of round base ( space problem ) and the limit load pi / 4 of bar groundwork foundation design ( plane problem ) from soil mechanics at home and abroad as well as foundation criterion, and explained why the value of formula in present design criterion from soil mechanics is inclined to be conservative. in the light of the author ' s many years experience of vibration test on the spot and the research work of relevant projects, the author worked over the dynamic pile testing of the bearing capacity of foundation and batholith, and gathered the parameter of dynamic analysis and testing. the author also talked over the difficult point of pile foundation design criteria in present batholith engineering world, i. e. the confirmation of batholith bearing capacity of pile end, from the following aspects : a ) confirmation of single axis counter - pressure strength of rock in house ; b ) f. e. m calculation of elastoplastic model ; c ) calculation of soil mechanics ; d ) deep well load test
然後，對巖土工程領域至今尚未解決，甚至不為人注意的考慮地基變形的地基承載力問題進行了實用化的探討，提出了考慮地基變形的地基承載力上程計算方法；對基於彈塑性理論分析的地基承載力國內尚未見報道的空間問題得到了圓形基礎（空間問題）的承載力界限荷載p _ （ 1 / 4 ） ，並與國內外土力學專著及地基基礎設計規范中的條形基礎（平面問題）的界限荷載p _ （ 1 / 4 ） ，進行了對比，從而定量上解釋了目前設計規范引用土力學承載力公式值偏於保守的這一情況；根據本文作者多年從事現場地基工程振動試驗及相關課題的研究工作，本文以截頭錐模型模擬地基，對地基（巖基）承載力的動測法進行了研究，為各類地基（包括巖基） ，匯總了動力分析和檢測川的參數：針對日前巖土工程界應用樁基設計規范中的難點? ?樁端巖基承載力的確定問題，從巖石室內單軸抗壓強度確定、基於彈塑性模型的有限單元法計算、土力學計算及深斤載荷試驗四方面進行了深入討論；本文作者根據多年現場載荷試驗的工程實踐，對深井荷試驗裝置的核心部分? ?反力裝置，設計了側壁支撐反力加載系統，該加載系統具有實用、簡便、穩定及安個等優點。 -
And rock triaxial serve testing system is used, through model test involving bedded planes and a set of joint normal to the bedded planes in rock mass, multiple sliding failure affected by properties of joints and confining pressure is analysed, the condition triggering multiple sliding failure and characteristics of failure plane are given, under the co - action of inclination of connective joints ( bedded planes ), interlocking conditions of critical joints and confining pressure
並在室內利用巖石三軸剛性伺服機，通過模型試驗對巖體的層面和一組與層面正交的節理的情況進行模擬研究，分析了結構面性狀和圍壓對復合式滑移破壞的影響，給出了在貫通性結構面（層面）傾角、非貫通性結構面以及圍壓等因素共同作用下，節理化巖體發生復合式滑移破壞的條件以及破壞面特徵。 -
Testing study on concrete carbonization influenced by wind pressure
風壓影響混凝土碳化試驗研究 -
Code for initial pressure testing of collapsible soils
濕陷性土起始壓力測試規程 -
The system can automatically fill in fresh air for dehumidify and prevention of negative pressure higher than designed in the cabin when testing
為了除濕和防止試驗時艙內產生大於設計要求的負壓，能自動補償新鮮空氣。 -
Differential pressure testing method of titanium welded tubes
鈦焊接管的分壓試驗方法 -
Coal - fired water - heater with storage boiler, without pressure for test pressure of 1 atmosphere ; terms employed, construction, quality, capacity and testing
1個大氣試驗壓力的裝有無壓力貯水鍋爐的燒煤的水加熱 -
Auxiliary pressure and temperature measurements make the multifrequency phase fluorometer an ideal choice for luminescence sensor design, testing and calibration
輔助壓力和溫度測量讓多頻相位熒光計是發光探測傳感器設計、測試和校準的理想選擇。 -
Dynamic behavior of reactive powder concrete in split hopkinson pressure bar testing
試驗對活性粉末混凝土動力性能的研究 -
Metal tubes - hydrostatic pressure testing
金屬管液壓試驗方法 -
The result is that this gas pool has simple structure, only forms a little nose - like structure at the district of fenghuangshan ; this pool belongs to delta front sub - facies sedimentary model, the underwater distributary channel and mouth bar is the better sedimentary microfacies ; the physical property of the reservoir is poor, the type of pore of the reservoir rock mostly are intergranular pore, intergranular solution hole and little are intercrystalline micropore ; the influential factors of pore structure and physical property are lithofacies, lithologic character and diagenesis ; the off - take potentia of all the testing well are deadly shortness, the wells have the worth of industrial recovery only under the condition of going through sand fracturing, and in the early of binging into production, the oil and sheath pressure drop rapidly, the production of the well drop rapidly
研究認為該氣藏構造簡單，只在鳳凰山形成了一個小型的鼻狀構造；屬於三角洲前緣亞相沉積模式，水下分流河道和河口壩是有利的沉積微相；儲層物性差，儲層巖石的孔隙類型主要有粒間孔、粒間（內）溶孔及少量晶間微孔；影響蓬萊鎮組氣藏儲層孔隙結構及儲集性的因素有巖相、巖性條件及成巖作用；所有測試井自然產能都極低，必須經加砂壓裂后才有工業開采價值，且投產初期，油套壓下降較快，氣井產量下降迅速。 -
Test method for pressure testing of assemblies of rubber - lined fire hose and rubber booster hose in service on interior standpipes
室內儲水管用橡膠襯里的消防軟管和橡膠增強軟管的組合件的壓力試驗方法 -
Methods of testing plastics. other properties. determination of the gas transmission rate of films and thin sheets under atmospheric pressure manometric method
塑料的試驗方法.第8部分:其他性能.試驗方法821a :在大氣壓力條件下薄片和薄膜透氣率的測定 -
Testing method of cryo - insulation pressure vessels leak and outgassing rate measurement
低溫絕熱壓力容器試驗方法漏放氣速率測量 -
The newly established air data test center for testing pressure, leak - out, and
等各項指標進行檢測，該實驗室的測試系統及測試儀器即將獲得國 -
Non - destructive testing - leak testing - pressure change method
無損檢驗.泄漏檢驗.壓力變化方法 -
Strengh testing pressure
強度試驗壓力 -
In the pressure characteristic test, a new method of testing pressure difference is brought out. with an entire bridge circuit and two pressure sensors, the structure is simple but the result is of high precision
電液伺服閥壓力特性實驗中，提出利用兩只壓力傳感器通過全橋電路測量差壓的新方法，該方法硬體結構簡單，測試精度高。 -
Seat testing pressure
壓力氣密封試驗壓力
分享友人