thermal air convection 中文意思是什麼

thermal air convection 解釋
熱空氣對流
  • thermal : adj. 1. 熱的，熱量的，溫熱的；由熱造成的。2. 溫泉的。n. 【航空】上升暖氣流。adv. -ly
  • air : n 1 空氣，大氣。2 天空，空中。3 微風，和風。4 態度，樣子，風度，氣派；〈pl 〉高傲的架子。5 傳播，...
  • convection : n. 1. 傳送。2. 【物理學】運流，環流；【氣象學】對流，上升氣流。
  1. The complicated behavior and multiple states of indoor air convection are mainly related to the multiple physical processes, such as the thermal buoyancy, the solutal buoyancy and the mechanical ventilation

    室內空氣對流行為的復雜性與狀態的多樣性通常是多種物理過程相互作用的結果，如離散熱源的熱浮升力、離散污染源的濃度浮升力及機械通風等。
  2. Abstract : the in servie tubular heaters built early in refineries and chemical plans have low thermal load and low heat efficiency, therefore measures for technical reform are offered, including ( 1 ) enlarging the surface area of convection tubes to increase the thermal load of rhe convection section ; ( 2 ) increasign the heat interchanging area of radiant tubes ; ( 3 ) changing the height of the chimney ; ( 4 ) using new burner with forced air supply to increase calorific capacityu ; ( 5 ) adding air preheater between the convection section and chimney to enhence the temperature of the air entering the furnace ; ( 6 ) adopting high temperature radiant coating to improve the effect of radiant heat interchanging

    文摘:針對早期建造的煉油廠和化工廠在役管式加熱爐熱負荷和熱效率低的狀況，提出了若干技術改造措施包括，增大對流管表面積以增大對流段的熱負荷；增加輻射管的換熱面積；修正煙囪高度；換用新型燃燒器，變自然通風為強制供風，以增大燃燒器的發熱量，減小過剩空氣系數，節省燃料2 % 3 % ；在對流段和煙囪之間增設空氣預熱器以提高空氣入爐溫度；採用高溫輻射塗料增強輻射換熱效果，從而增加熱源對爐壁的輻射傳熱量和爐管的傳熱量等。
  3. The in servie tubular heaters built early in refineries and chemical plans have low thermal load and low heat efficiency, therefore measures for technical reform are offered, including ( 1 ) enlarging the surface area of convection tubes to increase the thermal load of rhe convection section ; ( 2 ) increasign the heat interchanging area of radiant tubes ; ( 3 ) changing the height of the chimney ; ( 4 ) using new burner with forced air supply to increase calorific capacityu ; ( 5 ) adding air preheater between the convection section and chimney to enhence the temperature of the air entering the furnace ; ( 6 ) adopting high temperature radiant coating to improve the effect of radiant heat interchanging

    針對早期建造的煉油廠和化工廠在役管式加熱爐熱負荷和熱效率低的狀況，提出了若干技術改造措施包括，增大對流管表面積以增大對流段的熱負荷；增加輻射管的換熱面積；修正煙囪高度；換用新型燃燒器，變自然通風為強制供風，以增大燃燒器的發熱量，減小過剩空氣系數，節省燃料2 % 3 % ；在對流段和煙囪之間增設空氣預熱器以提高空氣入爐溫度；採用高溫輻射塗料增強輻射換熱效果，從而增加熱源對爐壁的輻射傳熱量和爐管的傳熱量等。
  4. The experimental results indicate that when the air flow rate is determined, the key problem for energy saving is how to keep the indoor thermal comfort at a suitable level and reduce the difference between the internal and external temperature of the room. a formula is gained for calculating the critical values of air exchange rate. when ventilating rate is greater than the value, radiating heating is the better way for energy saving, or else, convection method in heating is more suitable

    實測還指出，當通風量一定時，如何保證人體熱舒適度不變而減少室內外氣溫差將成為大通風量房間節約採暖能耗的關鍵，本文結合圍護結構傳熱機理，在對三種方式的能耗狀況進行理論分析的基礎上，提出了換氣次數的節能臨界值，若換氣次數高於此值，則輻射供暖是較好的選擇，否則，散熱器供暖是較好的方法。
  5. In the simplified mathematical modeling, fins are taken as equivalent solid layer with nonisotropic thermal conductivity, and heat convection between fins and cooling air is considered as internal source

    對2種飛機環控系統電子設備冷卻用冷板進行了實驗研究，測量了不同雷諾數、不同熱源分佈情況下冷板的表面溫度分佈。
  6. According to thermal comfort theory, adopting radiation directly acting to human ' s body, people can also feel comfortable even if indoor air temperature is relatively higher in summer and relatively lower in winter than that of convection heat - supply which means that it is evident energy - saving as to the traditional convection heat transfer

    根據熱舒適指標理論，採用輻射方式直接作用於人體，在室內空氣溫度較高（夏季供冷工況） 、較低（冬季供熱工況）的條件下，仍可以使人達到熱舒適，與傳統的對流傳熱方式相比具有明顯的節能性。
分享友人
分享到 Line

分享到臉書