tooth deflection 中文意思是什麼

tooth deflection 解釋
齒撓曲
  • tooth : n (pl teeth)1 牙齒。2 齒狀突出,輪齒,鋸齒,耙齒(等)。3 嗜好。4 〈常 pl 〉(像牙齒那樣能咬人...
  1. The equation of pressure angle, width coefficient, and contact ratio are calculated and the influences of these parameters on contact are analyzed. based on ordinary involute gear, the diametral deflection principle of curvilinear - tooth

    最後針對現有文獻的不足,研究了刀具壓力角、齒寬系數和重合度等參數的計算方法,並分析了這些參數對弧齒線圓柱齒輪嚙合的影響。
  2. For cutting the composite lock gear with unequal tooth thickness, a study is made on the design method of gear sharper cutter with nonstandard parameter involute tooth profile and noninvolute tooth profile. the cutter tooth arrangement, the choice of teeth number of the cutter and the basic method of cutter design are discussed ; and a new method of choosing deflection factor by using limited area is presented. and the curve of relationship between rear angle on tooth crest and helical angle on tooth side of the cutter is given so as to give a basis for the gear sharper cutter to choose its parameters. to design nonstandard gear sharper cutter by adopting the method mentioned above will simplify the calculation and will increase the efficiency of design

    研究加工不等齒厚的非標準參數漸開線齒形,與非漸開線齒形復合的鎖閉齒輪插齒刀刀齒的排列、刀具齒數的選擇以及刀具設計的基本方法,介紹用限制區域選擇插齒刀變位系數的新方法,並給出刀具齒頂后角與側螺旋角的關系曲線,為插齒刀參數的選擇提供依據.結果表明,採用上述方法設計非標準復合齒輪插齒刀,可簡化計算和提高設計效率
  3. The paper synthesises the conditions of loaded tooth contact analysis, fully considers all esalstic deflection of gears and support system, the deflection of gears and support system, the deflection of the contact region, therefore, the program may simulate the real work conditions

    本文系統地分析了齒輪加載接觸狀態,充分考慮了齒輪以及支承系統在載荷作用下發生的各種彈性變形、接觸區變形。因此,編制的計算機程序能模擬實際工作狀態。
分享友人