toughness test 中文意思是什麼
toughness test
解釋
沖擊韌性試驗-
Standard test method for toughness and tenacity of bitumen
瀝青粘韌性試驗法 -
Test method for jic, a measure of fracture toughness
Jic -破裂韌性的試驗方法 -
Metallic materials - standard test method for jic, a measure of ductile fracture toughness
金屬材料延性斷裂韌度jic試驗方法 -
In the same time, according to the fracture test results, the influence mechanism of aggregate size on fracture toughness of adherence of new and old concrete is discussed and analyzed, which is verified by manse of the fractal theory
同時根據新老混凝土粘結斷裂試驗結果，分析了粗骨料最大粒徑對新老混凝土粘結斷裂韌度的影響機理，並用分形理論對影響機理進行了驗證。 -
The method for measuring the plane strain fracture toughness klc has been introduce to high polymer bonded explosives ( pbx ) by systematically studying technologies concerning the shape of specimen, the depth and its machining of crack, the loading rate, the measurement of critical fracture load, and the computation of klc, etc. the method has been used to test and study klc of three typical high polymer bonded explosives which are j2, jl, j3 respectively both at normal temperature and unmoral temperature
本文以高聚物粘結炸藥為研究對象，對測試高聚物粘結炸藥的平面應變斷裂韌度所涉及的樣品形狀、裂紋深度及裂紋制備、加載速度、臨界斷裂載荷p _ q的確定及平面應變斷裂韌度k _ （ ic ）的計算等方面進行深入研究，建立了較為完善的炸藥平面應變斷裂韌度測試方法。 -
A charpy test is usually much less expensive to perform than a fracture toughness characterization experiment.
夏比（沖擊）試驗通常要比斷裂韌性試驗的費用低得多。 -
First, the basic mechanical capability and creep were proceeded on the material test system with the modified three point bending creep fracture test. the modulus and fracture toughness and tensile strength was attained and creep curve in 200 temperature was also presented. applying basic damage mechanical theory, thermal damage analyses were performed induced in fracture toughness and modulus, the practical formula of damage factors varying with temperature and time was given
首先利用改進的三點彎曲試驗在mts實驗機上進行了巖石力學性能和蠕變測試，得到了花崗巖在溫度影響下的彈性模量和斷裂韌度以及抗拉強度變化規律，並得到了200下北山花崗巖蠕變全過程曲線。 -
In order to use the strength and toughness index for design and apply of sfrc unified theoretical calculation formula of reinforcing and toughening of sfrc is given. experiments on bending toughness, breaking toughness and cube strength test results are carried out in connection with various kind of deformed steel fiber
初步給出建立鋼纖維混凝土增強、增韌統一理論計算公式思想，為鋼纖維混凝土強韌雙重指標在設計、選用鋼纖維混凝土中的應用打下基礎；針對不同種類異形鋼纖維進行了彎曲韌性、斷裂韌性、立方體抗壓強度等試驗。 -
Standard test method for lashing toughness of domestic ceramic
日用陶瓷沖擊韌性測定方法 -
Standard test method for short rod fracture toughness of cemented carbides
硬質合金短桿斷裂韌度的試驗方法 -
Test method for plane - strain fracture toughness and strain energy release rate of plastic materials
塑料平面應變裂縫強度和應變能量釋放速率測試方法 -
After chemical and physical test, on conveyor chain material, it is concluded that the composition and various mechanical properties can meet the standard, except impact toughness at room temperature
摘要對圓環鏈母材進行理化檢測，證明化學成分和各項力學性能指標均符合要求，只有常溫沖擊韌性不符合要求。 -
Evaluation of fracture toughness of three - point bend specimen from the instrumented impact test based on the local approach
基於局部法由示波沖擊試驗對斷裂韌性的預測 -
Combining the fracture toughness test results of rcc specimens with the existed size effect formula for fracture toughness of common concrete, the suitable size effect formula fur fracture toughness of rcc was gotten on the comparative of results of the computation models
將碾壓混凝土斷裂韌度試驗結果與已有的普通混凝土斷裂韌度尺寸效應公式結合，通過對幾種模型的計算結果的分析比較，得到了碾壓混凝土所適用的斷裂韌度尺寸效應公式。 -
Toughness test of link chains - impact test method of chain links
扁節鏈的硬度試驗.鏈節的沖擊試驗方法 -
Prefabricating original cracks in refractory specimens for fracture toughness test using high temperature static fatigue method
高溫靜疲勞法預制耐火材料斷裂韌性試件原生裂紋 -
Using the modal taking into effects of the notch width., this paper also compute the stress intensity factor of ccnbd suggest by isrm for rock fracture toughness test. and some conclusions have been made in this research
本文還對國際巖石力學學會（ isrm ） 95年方法推薦的ccnbd斷裂韌度試樣採用考慮切槽寬度的模型進行了計算，得到一些有意義的結論。 -
5 plasticity - on the basis of observations made during he toughness test, describe the plasticity of the material in accordance with the criteria given in table 11
5塑性-在韌性試驗過程中，開始觀察時，按照表11中的標準描述這種材料的塑性 -
According to analyze experimental data of flexural toughness test of synthetic macro - fiber reinforced concrete, based on astm and jsce method, a new flexural toughness evaluating method is first proposed, it may well and truly reflect toughen and crack arrest of synthetic macro - fiber
通過對粗合成纖維混凝土抗彎韌性試驗數據的分析，基於美國astm及日本jsce方法，提出了粗合成纖維混凝土抗彎韌性新評價方法，該韌性評價方法能夠準確地反映粗合成纖維的阻裂增韌效果。 -
Therefore, interlayer toughened composites are the excellent candidate materials for primary structure of aircrafts. in this paper, composites modified with particle - interlayer were fabricated. based on the aims of improving compression strength after impact ( cai ) and evaluate damage resistance and damage tolerance, mode ii fracture toughness test and quasi - static indentation test ( qsi ) were conducted
本文採用層間顆粒增韌技術制備試驗件，基於提高沖擊后壓縮強度（ cai ）和考察損傷阻抗、損傷容限的目的，試驗測試了型層間斷裂韌性g _ （ c ） 、準靜壓痕（ qsi ）試驗的分層起始能量和接觸力?凹坑深度關系。
分享友人