transconductance amplifier 中文意思是什麼

transconductance amplifier 解釋
跨導放大器
  1. The factors limiting the frequency band of the wide - band amplifier are introduced. through analyzing the effects of the intrinsic parameters and parasitical on the frequency characteristics, a method of improving fr of mosfet by using short channel device and making mosfet work at the saturation region through raising vgs is put forward ; the effects of different kinds of circuit configurations on the frequency characteristics and the junction voltage on the voltage pattern circuit, current pattern circuit and frequency characteristics are analyzed. according to the linear theory of transconductance which is applied in the bit circuit, the current pattern amplifier circuit, current transfer circuit and output circuit which consist of mosfet and the wide - band amplifier composed of them are put forward

    介紹了限制寬帶放大器頻帶寬度的因素，通過分析mosfet的本徵參數、寄生參數對頻率特性的影響，提出了採用短溝器件、使mosfet工作在飽和區、抬高柵源電壓等提高mosfet特徵頻率的方法；分析了不同電路組態對放大器頻率特性的影響、節點電壓對電壓模電路、電流模電路頻率特性的不同影響，根據應用於雙極晶體管電路的跨導線性原理，提出了採用mosfet構成的電流模放大電路、電流傳輸電路、輸出電路以及由它們所組成的寬帶放大器，獲得了良好的頻率響應。
  2. Operational transconductance amplifier

    運算轉導放大器
  3. Detail specification for electronic components. semiconductor integrated circuit - cf3080 type transconductance operational amplifier

    電子元器件詳細規范.半導體集成電路cf 3080型跨導運算放大器
  4. The innovation of the dissertation is indicated as follows : in the discussion of the ctrl _ gm sub - block, the transconductance stability of operational transconductance amplifier is deeply studied

    本論文的創新之處在於:在對ctrl _ gm模塊的論述中，論文對運算跨導放大器（ ota ）的跨導穩定性進行了較為深入的研究。
  5. The thesis has done the widespread investigation and study to the domestic and foreign ’ s technologies of analogy low voltage and low power, and analyzes the principles of work, merts and shortcomings of these technologies, based on the absorption of these technologies, it designs a 1. 5v low power rail - to - rail cmos operational amplifier. when designing input stage, in order to enable the input common mode voltage range to achieve rail - to - rail, it does not use the traditional differential input pair, but use the nmos tube and the pmos tube parallel supplementary differential input pair to the structure, and uses the proportional current mirror technology to realize the constant transconductance of input stage. in the middle gain stage design, the current mirror load does not use the traditional standard cascode structure, but uses the low voltage, wide - swing casecode structure which is suitable to work in low voltage. when designing output stage, in order to enhance the efficiency, it uses the push - pull common source stage amplifier as the output stage, the output voltage swing basically reached rail - to - rail. the thesis changes the design of the traditional normal source based on the operational amplifier, uses the differential amplifier with current mirror load to design a normal current source. the normal current source provides the stable bias current and the bias voltage to the operational amplifier, so the stability of operational amplifier is guaranteed. the thesis uses the miller compensate technology with a adjusting zero resistance to compensate the operational amplifier

    本論文對國內外的模擬低電壓低功耗技術做了廣泛的調查研究，分析了這些技術的工作原理和優缺點，在吸收這些技術成果基礎上設計了一個1 . 5v低功耗軌至軌cmos運算放大器。在設計輸入級時，為了使輸入共模電壓范圍達到軌至軌，不是採用傳統的差動輸入結構，而是採用了nmos管和pmos管並聯的互補差動輸入對結構，並採用成比例的電流鏡技術實現了輸入級跨導的恆定;在中間增益級設計中，電流鏡負載並不是採用傳統的標準共源共柵結構，而是採用了適合在低壓工作的低壓寬擺幅共源共柵結構;在輸出級設計時，為了提高效率，採用了推挽共源級放大器作為輸出級，輸出電壓擺幅基本上達到了軌至軌;本論文改變傳統基準源基於運放的設計，採用了帶電流鏡負載的差分放大器設計了一個基準電流源，給運放提供穩定的偏置電流和偏置電壓，保證了運放的穩定性;並採用了帶調零電阻的密勒補償技術對運放進行頻率補償。
  6. The chip is accomplished in the full cooperation with other team members, the author pays particular attention to the analysis of the whole chip architecture and three sub - block design : transconductance amplifier ( ota ), voltage reference and current reference. based on existed technologies, a new high order temperature compensated voltage reference and a creative current reference with high order temperature compensation are shown respectively. the author simulated all the sub - block and whole chip by hspice

    該晶元的設計是由小組成員共同完成，本人主要負責了總體電路的分析、聯合模擬驗證及以下三個子電路的設計: 1 、跨導放大器，詳細分析了bandgap跨導放大器輸入級的動靜態特性及其優缺點，並結合系統要求，設計了一種與cmos工藝相兼容、可替代bandgap跨導放大器的低壓共源共柵跨導放大器。
  7. The 2 - stage differential transconductance amplifier is used in the design to achieve high gain. in the design of amplifier, a resister and a miller capacitor is used to deal with the stability and frequency compensation

    系統中採用差分跨導運算放大器的設計，為了保證其具備高增益與高穩定性，選用二級結構，並且增加了補償電容和電阻。
分享友人
分享到 Line

分享到臉書