turbidity temperature 中文意思是什麼

turbidity temperature 解釋
渾濁溫度
  • turbidity : n. 渾濁,濁度;不透明;混亂。
  • temperature : n. 1. 溫度,氣溫。2. 體溫。3. 〈口語〉發燒,高燒。
  1. The monitoring process is carried out on board a scientific vessel the dr catherine lam which is equipped with state - of - the - art technology. at various locations, scientists measure a range of parameters, such as temperature, ph, salinity, turbidity and dissolved oxygen

    海水監測工作是在設備先進的林蘊盈博士號監測船上進行;研究人員在海上測量各種水質參數,包括水溫、酸鹼度、鹽分、混濁度、溶解氧含量等。
  2. On - site measurements of parameters such as temperature, ph, turbidity and dissolved oxygen are made using the multiparameter water quality measuring probe, and recorded in the data logger. the readings obtained are then compared against the normal ranges from that station, and any unusual readings result in a second set of measurements being made to check the validity of the initial reading

    另外,工作人員利用多參數水質計量儀實地量度多項水質參數,包括水溫酸鹼度混濁度及溶解氧,將測量結果記錄在數據記錄器內,再與該監測站的正常參數范圍比較,核實數據的真實性。
  3. Because of the influences of the turbidity, ph of raw water, current, temperature and the pollutions of raw water, the process of coagulant dosage is a very complex reaction. to find out the automation of coagulant dosage and reduce the cost of the coagulant, many domestic and international scientific research organizations make research into the theory and mechanism of automation of coagulant dosage, such as the streaming current control method ( scd ), the emulation experimenting method in spot, mathematics model, flocculation control device ( fcd )

    由於受到原水濁度、 ph值、配水流量、原水溫度和其他水質污染的影響,投藥絮凝過程是一個非常復雜的反應過程,為實現投藥系統的自動化和降低混凝劑耗率,國內外相當多的科研機構和院校在進行投藥機理和自動化處理的研究,主要有流動電流儀檢測法( scd ) 、現場模擬實驗法、數學模型、顯示絮凝控製法( fcd法)等自動投藥方式的研究和實驗。
  4. Specification for design of water supply treatment of low temperature and turbidity water

    低溫低濁水給水處理設計規程
  5. Water treatment for low temperature and low turbidity by using eddy coagulation process

    微渦旋混凝技術處理低溫低濁水
  6. Pilot - scale experimental results showed that, comparing to conventional gravity filtration, the up - flow filtration has greater capacity in containing removed suspended solid and producing filtrate under the test conditions. coarse media with particle diameter ranging 0. 63 - 2. 00mm were used in order to apply relatively higher backwash rate of 21 l / ( m2. s ) for achieving better media clean - up after a filtration run. under the test conditions, the media thickness ranging 82 - 85 iron, water temperature ranging 6 - 27, and influx turbidity of 30 ntu, it achieved the results of the average filtration rate ranging 16 - 18 m / h, the average effluent turbidity of 1 ntu, and action cycle ranging 14 - 24h

    中試研究結果表明,粗石英砂濾料上向流過濾比傳統的重力流過濾具有更大的含污能力和產水量,為適用較高的反沖洗強度( 21l ( m ~ 2 ? s ) )以便濾料清洗更干凈,採用粒徑范圍為0 . 63 2 . 00mm的粗石英砂濾料,濾層厚82 85cm ,水溫6 27 ,進水濁度為30ntu左右等情況下,能獲得平均濾速為16 18m h 、平均濾后水濁度為1ntu左右、周期達14 24小時的好效果。
  7. However, although prechlorination efficiently removed algae, its effect was directly related to the quantity of algae and was more obvious in the period of algae bloom. with regard to yellow river water in winter with low temperature and low turbidity, it was discovered that preozonation did not result in a substantial removal of total organic carbon ( toc ), but a remarkable uv254. it was further revealed that preozonation changed the characteristics and structure of organic matters and then enhanced removal efficiencie s of them by subsequent processes

    對于夏季高藻期水質,高錳酸鉀預氧化對有機物有一定的去除能力,並能提高后續工藝出水水質;預氯化能顯著去除藻類,但后續工藝出水水質受藻類數量影響明顯,預氯化只有在高藻期才能提高后續常規處理工藝出水水質;對于冬季低溫低濁水,預臭氧化雖不能降低水中有機物濃度,但能顯著提高后續常規處理單元出水水質。
  8. Experimental research on treatment of surface water with low turbidity at low temperature by side - flow floatation sedimentation tank with inclined plates

    新型側向流斜板浮沉池處理低溫低濁水的試驗研究
  9. Effect of pre - oxidation on alum coagulation evaluated through the change of turbidity 、 toc and uv254. the emphasis on some impact factors such as the kind or variety of oxidant and oxidant contact time were studied, with discussing the influence of ph and solution temperature

    試驗中先投加氧化劑,再投加混凝劑,充分沉澱后,檢測出水濁度、 toc和uv254 ,通過這些指標變化來評價預氧化對混凝效果的影響。
分享友人