turbulent heat flow 中文意思是什麼
turbulent heat flow
解釋
湍寥通量-
Regressed the experimental date with linear use minimal dual multiply method. got the empirical equation of heat transfer and flow resistance in laminar, transitive and turbulent zone
Reb隨肋高h 、肋軸向間距pt的增大而減小，隨肋寬的增大而增大。 -
By comparing the results with relative experiment data, it is shown that rng k - is more exactly than the other turbulent model. 2 ) the influences of axial inflow position, radial outflow size, rotating reynold number, non - dimensional mass flowrate and axial inflow angle on the flow and heat transfer characteristics were numerically investigated for a typical rotator - stator cavity with axial inflow, radial inflow and radial outflow. the correlations for average nusselt number vs rotating reynold number or non - dimensional mass flowrate were established
（ 2 ）針對一典型的徑向、軸向進氣，徑向出氣的轉-靜盤腔結構，系統研究軸向進氣位置、徑向出口大小、旋轉雷諾數、無量綱質量流量和軸向垂直預旋進氣等對盤腔內流動和換熱的影響，整理出轉-靜盤腔內轉盤平均努謝爾數與旋轉雷諾數無量綱質量流量之間的準則關聯式。 -
Based these researches acquired and using a mathmatical model, this thesis tries to research the contaminant concentration distributions of three - dimention indoor turbulent flow by means of computational fluid dynamics and heat transfer, and then works out the ventilation efficiency
本文企圖在前人的基礎上，通過建立相應的數學模型，用流體流動數值計算方法來模擬室內三維的紊態氣流中的污染物濃度分佈，進而分析計算室內的通風效率，得出通風效率較好的室內氣流組織形式。 -
In arbitrary curvilinear coordinate systems, three dimensional turbulent combustion flow fields of the three kinds of turbofan engine afterburner with the longitudinal heat shield 、 outer cold flow and the jet nozzle are simulated. the three - dimensional body - fitted grids are generated by an elliptical grid generation procedure and zone method
本文在任意曲線坐標系統下對三種帶有縱向隔熱屏、外冷卻通道和尾噴管的渦扇發動機加力燃燒室的三維紊流燃燒流場進行數值模擬。 -
Research on turbulent pipe flow heat - transfer characteristic of urban wastewater as a cool and heat source
城市原生污水冷熱源圓管紊流換熱特性 -
The experimental results of the flow characteristics of the mmc heat sink indicate that the critical reynolds number signifying the transition from laminar flow to turbulent flow is in advance ; under the same experimental conditions, the variation in entrance direction of the microchannel inlet and outlet has little effect on the microchannel ; the experimental values of the friction factor of the de - ionized water in a microchannel agree well with those calculated using the theoretical laminar formula ; furthermore, a comparison of the experimental results and simulation results shows that navier - stokes equation and rng - turbulence model can be used to model the laminar and turbulence flow regions in a microchannel ; meanwhile, the correlations of the flow resistance in the turbulent flow regions for the de - ionized water as the working fluids are obtained from experiments
對歧管式單通道熱沉流動特性的研究結果表明，微通道內流體流態由層流向紊流轉變的臨界雷諾數提前;改變流體的進出口方向對熱沉總壓降造成的影響很小;摩擦系數的實驗值與理論值較接近;數值模擬結果能夠與實驗值較好吻合;並由實驗給出了紊流區流動阻力的實驗關聯式。此外，選用十二烷基硫酸鈉（ sodiumdodecylsulphate ， sds ）以及烷基多糖苷（ alkylpolyglycoside ， apg ）作為減阻添加劑，研究了表面活性劑添加對微通道流動特性的影響。 -
Study on mechanism of turbulent flow and heat transfer in rotating passages
旋轉狀態下蛇形通道內流動與換熱的機理研究 -
The numerical analysis indicates that that the multi - longitudinal vortex flow in tubes can markedly enhance both the laminar and turbulent heat transfer with less additional increase of flow resistance
結果表明，管內多縱向渦對層流和湍流換熱的強化效果顯著而流阻增加較少，具有優良的綜合強化換熱性能。 -
The type of heat transfer inside the pipes belongs to single - phase compulsive turbulent flow of inner pipe. inner trachea is a kind of special pipe compared by smooth pipe, which can strengthen heat transfer inside pipe
空預器煙氣側的換熱類型是管內單相強迫紊流換熱，論文在查閱了相關文獻的基礎上，比較了幾種不同的管內強化換熱措施，在其中選擇內螺紋管代替光管，來改造管式空氣預熱器。 -
The coupled turbulent flow field and temperature field are simulated by finite element method ; the influence of casting speed on the turbulent flow field and temperature field in the melting bath and the interaction between those two field are analyzed ; the variation tendency of the heat flux intensity between the melting bath and casting roll and law of variation with changes of casting speed in the process of solidification are given ; a comparison between the simulation results and experimental results demonstrates their good agreement ; and the mechanism of the heat flux variation is identified by analysis on the temporature gradient and development of solidification within the melting bath and its influence on the variation of the heat flux intensity
採用有限元法模擬了雙輥鑄軋不銹鋼過程的流熱耦合問題;分析了鑄軋速度對熔池內流場、溫度場的影響以及流場與溫度場之間的相互影響;給出了凝固過程中熔池與鑄軋輥之間的熱流密度變化趨勢及隨鑄軋速度的變化規律，並把此模擬的結果與試驗的結果相比較，吻合較好;通過熔池內溫度場及溫度梯度分析了熔池內凝固的發展及其對熱流密度變化的影響。 -
Direct numerical simulation of turbulent flow and heat transfer in square duct with steady natural convection in cross section
具有截面自然對流通道內湍流換熱的直接數值模擬 -
In the laminar flow regime, a analytical mathematical model is obtained by analyzing the film flowing in the wavy wall tube. in the turbulent flow regime, mathematical model almost ca n ' t be obtained directly because the turbulent flow in wavy wall tube is very complex, the model is obtained by quoting some results which are theorized by other studiers. in the part of experimental study, the flow form in the wavy wall tube is observed by transparent quartz glass wavy wall tube apparatus, the evaporation experiments are carried out in a 3 meters steel wavy wall tube, using glucose as the medium, heat transfer is invested, the heat transfer correlations of wavy wall tube evaporator are obtained
數學模型的建立過程中，對于液膜層流流動，直接對波形管內的降落液膜進行理論分析，得出液膜層流流動下數學模型的解析式；對于液膜湍流流動，由於湍流流動的復雜性，再加上所採用的波形管對湍流流動的影響，直接對降落液膜進行理論分析建立數學模型是極其復雜的，通過採用以前一些研究者得到的理論分析與實驗結果，並引入與波形管的形狀特徵參數有關的修正系數k ，建立液膜在湍流流動下的數學模型。
分享友人