unscrew 中文意思是什麼

unscrew 解釋
vt. 及物動詞 ,vi. 不及物動詞 起[扭松]（…的）螺絲；取下（螺絲）。

  1. Unscrew the bonnet by turning counterclockwise

    反時針方向旋轉擰松閥蓋。
  2. At last they got out the coffin and begun to unscrew the lid, and then such another crowding and shouldering and shoving as there was, to scrouge in and get a sight, you never see ; and in the dark, that way, it was awful

    最後，他們終于把棺材挖掘了出來，並且開始擰開棺材蓋上的螺絲釘，隨后一群群人擠著人，肩擦著肩，推推搡搡，都想鉆進去看一眼，這景象是你見所未見的。而且天又是這么黑漆漆的。
  3. Unscrew the retaining bolt ( see figure 7, # 1 ). hold the element with pliers and remove it using a semicircular motion

    旋下固定螺栓（參閱圖7 ， # 1 ） 。用鉗子握住加熱元件（加熱棒）旋轉半圈拆卸下加熱棒。
  4. While he was in the act of getting his bearings, mr bloom, who noticed when he stood up that he had two flasks of presumably ship s rum sticking one out of each pocket for the private consumption of his burning interior, saw him produce a bottle and uncork it, or unscrew, and, applying its nozzle to his lips, take a good old delectable swig out of it with a gurgling noise

    當他剛站起來時，布盧姆先生曾注意到，他兩邊兜里各露出一瓶看來是水手們喝的那種朗姆酒，為的是暗地裡灌進他那灼熱的胃。布盧姆先生瞧見他這會兒正四下里打量，並從兜里掏出一隻瓶子，拔開或是擰開塞子，將瓶口對準嘴唇，咕嘟咕嘟地痛飲了一通，津津有味。
  5. Do not use check arm as a handle to unscrew

    不要用止回閥臂作為把手來旋轉螺紋。
  6. I can ' t unscrew the bolts. this is gonna hurt

    我擰不開這閂，這會很痛
  7. Ah, we are going to unscrew the chains

    好，我們把鏈條卸下來吧。
  8. The lid of this jam pot won ' t unscrew

    這果醬罐的蓋子擰不開
  9. Unscrew body halves using open end or adjustable wrench on flats provided

    採用預備好的平頭上開口或可調節扳手擰下一半閥體上的螺絲。
  10. Unscrew and remove bonnet assembly

    旋下螺絲，拆卸閥帽組件。
  11. To replace the relief valve disc, hold the upper guide fin and unscrew the diaphragm pressure plate

    要更換安全閥閥瓣，握住上部引導翼，旋下隔膜壓力板上的螺絲。
  12. Unscrew the four bolts to separate the body from the bonnet and control group

    擰松四個螺栓，從閥帽和控制組建之間分開閥體。
  13. Locking the rotation of the laminar coupling ( 2 ) with the reaction lever 99370317 ( 1 ) and using a suitable wrench unscrew the retaining screws ( 3 ), remove the laminar coupling and the flange

    利用止動桿99370317 （ 1 ）鎖定迭片式聯軸節（ 2 ）不讓其轉動，並且使用適用的扳手鬆開固定螺釘（ 3 ） ，將迭片式聯軸節和法蘭卸下。
  14. To clean : inspect or replace worn valve disc, disconnect control pipe and unscrew bonnet from valve body using blunt tool and hammer on bonnet lugs

    清洗：檢查或更換磨損的閥門閥瓣，斷開控制管道，用鈍工具和錘打閥蓋塞頂部，從閥體上旋下閥蓋。
  15. Remove # 1 check assembly by using your hands to unscrew ( turn counter - clockwise ) check and remove through top access port

    通過頂部檢修口，用手按逆時針方向旋轉止回閥螺紋，拆卸1號止回閥總成。
  16. Unscrew # 2 check ( turncounter - clockwise ) by placing along screwdriver across lugs and applying pressure to loosen # 2 check

    將螺絲起子向前插入穿過凸耳桉逆時針方向旋轉2號止回閥的螺紋，並施加壓力松開2號止回閥。
  17. After a month, your elbows or shoulders are so sore you can barely unscrew a bottle of painkillers

    一個月後，你的手肘和肩膀痛到甚至無法打開止痛劑。
  18. Unscrew the bottom. do it

    旋開杯底，快做！
  19. You may have to unscrew the gear ( 3 screws ) to access the right hand latch, but i am not sure of that

    也許你需要松開齒輪（ 3顆螺絲）來卸下右手邊的卡子，不過我不是很確定
  20. Using an appropriate sized wrench, loosen the check valve cover. unscrew the check valve cover and lift it off

    採用尺寸大小適中的扳手鬆開止回閥閥蓋。寧松止回閥閥蓋並將其取出來。
分享友人
分享到 Line

分享到臉書