voltage breakdown method 中文意思是什麼

voltage breakdown method 解釋
電壓擊穿法
  • voltage : n. 【電學】電壓，電壓量，伏特數。 the working voltage （電氣的）耐壓限度。
  • breakdown : n 1 崩潰，倒塌；破損，損耗；損傷；損壞，故障；失敗，挫折；中斷，停止。2 【航空】下降；【電學】擊...
  • method : n 1 方法，方式；順序。2 （思想、言談上的）條理，規律，秩序。3 【生物學】分類法。4 〈M 〉【戲劇】...
  1. Insulating liquids - determination of the breakdown voltage at power frequency - test method

    絕緣液體.電源頻率擊穿電壓的測定
  2. Standard test method for dielectric breakdown voltage of insulating liquids using disk electrodes

    用圓盤電極測定絕緣液體介電擊穿電壓的標準試驗方法
  3. Standard test method for dielectric breakdown voltage of insulating oils of petroleum origin using vde electrodes

    用vde電極測量源自石油的絕緣油介電擊穿電壓的標準試驗方法
  4. Standard test method for dielectric breakdown voltage and dielectric strength of insulating gases at commercial power frequencies

    在工業用電頻率時絕緣氣體介電擊穿電壓和介電強度的標準測試方法
  5. Test method for dielectric breakdown voltage and dielectric strength of electrical insulating materials under direct - voltage stress

    直流電壓應力下電氣絕緣材料的介電擊穿電壓和介電強度的試驗方法
  6. Test method for dielectric breakdown voltage and dielectric strength of solid electrical insulating materials at commercial power frequencies

    固體電絕緣材料在工業電源頻率下的介電擊穿電壓和介電強度的試驗方法
  7. 10. 01 test method for dielectric breakdown voltage and dielectric strength of solid electrical insulating materials at commercial power frequencies

    固體電絕緣材料在工業用電頻率下的介電擊穿電壓和介電強度的試驗方法
  8. Standard test method for dielectric breakdown voltage and dielectric strength of solid electrical insulating materials under direct - voltage stress

    在直流電壓作用下固體電絕緣材料的介電擊穿電壓及介電強度的標準試驗方法
  9. Standard test method for dielectric breakdown voltage and dielectric strength of solid electrical insulating materials at commercial power frequencies

    固體電絕緣材料在商用電源頻率下的介電擊穿電壓和介電強度的標準試驗方法
  10. The author ' s main contributions are outlined as following : first, the roles of hot electron and hole in dielectric breakdown of ultra - thin gate oxides have been quantitatively investigated by separately controlling the amounts of hot electron and hot hole injection using substrate hot hole ( shh ) injection method. the changes of threshold voltage have been discussed under different stress conditions

    主要研究結果如下：首先，利用襯底熱空穴（ shh ）注入技術分別控制注入到超薄柵氧化層中的熱電子和空穴的數量，定量研究了熱電子和空穴注入對超薄柵氧化層擊穿的影響，討論了不同應力條件下的閾值電壓變化。
  11. Standard test method for dielectric breakdown voltage of insulating oils of petroleum origin under impulse conditions

    在脈沖條件下石油成因的絕緣油的電介質擊穿電壓的標準試驗方法
  12. Standard test method for dielectric breakdown voltage and dielectric strength of solid electrical insulating materials using impulse waves

    用脈沖波法測定固體電絕緣材料的電介質擊穿電壓及抗電強度的標準試驗方法
  13. 10. 02 test method for dielectric breakdown voltage and dielectric strength of solid electrical insulating materials using impulse waves

    用沖擊波測定電氣固體絕緣材料的電介質擊穿電壓和介電強度的試驗方法
  14. Standard test method for verifying the specified dielectric withstand voltage and determining the dielectric breakdown voltage of a membrane switch

    薄膜開關的規定的介質抗電強度的驗證和介質擊穿電壓測定的標準試驗方法
  15. Abstract : the saturation behavior of stress current is studied. the three types of precursor sites for trap generation are also introduced by fitting method based on first order rate equation. a further investigation by statistics experiments shows that there are definite relationships among time constant of trap generation, the time - to - breakdown, and stress voltage. it also means that the time constant of trap generation can be used to predict oxide lifetime. this method is faster for tddb study compared with usual breakdown experiments

    文摘:基於一階速率方程，討論了恆定電壓應力下應力電流的飽和行為.通過對應力電流的擬合，發現存在三類缺陷產生的前身.更進一步的統計實驗顯示，在缺陷產生時間常數、擊穿時間以及應力電壓之間存在著明確的關系.這意味著缺陷產生時間常數能夠被用於有效預測氧化層的壽命.與常規的氧化層擊穿實驗相比，基於缺陷產生時間常數的預測更快、更有效
分享友人
分享到 Line

分享到臉書