voltage breakdown test 中文意思是什麼

voltage breakdown test 解釋
電壓擊穿實驗
  • voltage : n. 【電學】電壓,電壓量,伏特數。 the working voltage (電氣的)耐壓限度。
  • breakdown : n 1 崩潰,倒塌;破損,損耗;損傷;損壞,故障;失敗,挫折;中斷,停止。2 【航空】下降;【電學】擊...
  • test : n 1 檢驗,檢查;考查;測驗;考試;考驗。2 檢驗用品;試金石;【化學】試藥;(判斷的)標準。3 【化...
  1. The lightning impulse breakdown and steep - front impulse breakdown test of silicone rubber are also performed, which give a reference for other so lid materials. the result of this research also will give a reference to revises the standard of steep - front wave impulse voltage test

    為了配合本課題的研究還做了硅橡膠材料的雷電沖擊耐受強度和陡波沖擊耐受強度試驗,這兩個試驗對了解其它固體材料的雷電沖擊系數和伏秒特性也具有參考價值。
  2. Insulating liquids - determination of the breakdown voltage at power frequency - test method

    絕緣液體.電源頻率擊穿電壓的測定
  3. Standard test method for dielectric breakdown voltage of insulating liquids using disk electrodes

    用圓盤電極測定絕緣液體介電擊穿電壓的標準試驗方法
  4. Standard test method for dielectric breakdown voltage of insulating oils of petroleum origin using vde electrodes

    用vde電極測量源自石油的絕緣油介電擊穿電壓的標準試驗方法
  5. Standard test method for dielectric breakdown voltage and dielectric strength of insulating gases at commercial power frequencies

    在工業用電頻率時絕緣氣體介電擊穿電壓和介電強度的標準測試方法
  6. Test method for dielectric breakdown voltage and dielectric strength of electrical insulating materials under direct - voltage stress

    直流電壓應力下電氣絕緣材料的介電擊穿電壓和介電強度的試驗方法
  7. Test method for dielectric breakdown voltage and dielectric strength of solid electrical insulating materials at commercial power frequencies

    固體電絕緣材料在工業電源頻率下的介電擊穿電壓和介電強度的試驗方法
  8. 10. 01 test method for dielectric breakdown voltage and dielectric strength of solid electrical insulating materials at commercial power frequencies

    固體電絕緣材料在工業用電頻率下的介電擊穿電壓和介電強度的試驗方法
  9. Standard test method for dielectric breakdown voltage and dielectric strength of solid electrical insulating materials under direct - voltage stress

    在直流電壓作用下固體電絕緣材料的介電擊穿電壓及介電強度的標準試驗方法
  10. Standard test method for dielectric breakdown voltage and dielectric strength of solid electrical insulating materials at commercial power frequencies

    固體電絕緣材料在商用電源頻率下的介電擊穿電壓和介電強度的標準試驗方法
  11. The result of the test for dynamic breakdown characteristics reveal that breakdown voltage increases as the lengths of the pulses applied to the gate and drain electrodes increase. this could be mainly due to the influence of surface states

    Gaasmesfet動態擊穿特性測試結果表明, gaasmesfet的擊穿電壓隨柵極與漏極上所加脈沖電壓寬度的增大而增大,這主要是因為表面態的原因。
  12. The paper studied withstand voltage level, influence factors, breakdown process and breakdown mechanism of covered with snow or ice through some theory calculation results, many test data and phenomena. the paper got the conclusions that withstand voltage strength of insulator covered with snow or ice descended largely, and the amount of ice or snow build - up, number of flashover, string length, environment temperature and leak current etc had obvious effects on flashover voltage values of insulators

    通過大量的試驗數據和現象研究冰雪條件下絕緣子的耐壓水平、影響因素及其擊穿機理,如串長的影響、環境溫度、絕緣子形狀及冰的干濕程度、閃絡次數、冠雪量和積冰量的影響、雪的密度、氣壓和濕度的影響等,並對試驗結果與理論分析結果進行了對比,分析其是否一致。
  13. Standard test method for dielectric breakdown voltage of insulating oils of petroleum origin under impulse conditions

    在脈沖條件下石油成因的絕緣油的電介質擊穿電壓的標準試驗方法
  14. Standard test method for dielectric breakdown voltage and dielectric strength of solid electrical insulating materials using impulse waves

    用脈沖波法測定固體電絕緣材料的電介質擊穿電壓及抗電強度的標準試驗方法
  15. 10. 02 test method for dielectric breakdown voltage and dielectric strength of solid electrical insulating materials using impulse waves

    用沖擊波測定電氣固體絕緣材料的電介質擊穿電壓和介電強度的試驗方法
  16. Standard test method for verifying the specified dielectric withstand voltage and determining the dielectric breakdown voltage of a membrane switch

    薄膜開關的規定的介質抗電強度的驗證和介質擊穿電壓測定的標準試驗方法
分享友人