voltage gain 中文意思是什麼
voltage gain
解釋
電壓增益-
The input signals pass through the prepositive circuit which transforming the measured signals ( voltage or current ) into small voltage signals, the signal adjust circuit consist of programmable - gain amplifier and filter, and digital signal processor tms320lf2407 for data acquisition and processing in turns. provide the measuring results on lcd module. and also can transfer data to the pc ’ s rs232 for farther analyse
採用前置電路將被測信號（電壓或電流）變換為小電壓信號，經過信號調理電路對信號進行程式控制放大和濾波后，通過tms320lf2407實現信號的數據採集、信息處理和計算，將測量結果通過液晶模塊顯示，還可經過rs232介面與計算機進行數據傳輸，做進一步的分析和應用。 -
Only transformer coupling can contribute to the voltage gain of an amplifier by virtue of a stepup turns ratio.
只有放大器耦合方能通過開壓匝數比提高變壓器電壓增益。 -
From the model, we can solve and gain the values and change orders of charging current, charging voltage, discharging current, discharging voltage and inductive current. after that, the electromagnetic fields can be created from two circuits " currents, and their magnetic rector and flux can be simulated from ansys solver
用ansys multiphysics模塊求解出充電電流、充電電壓、放電電流、放電電壓和感應電流以及這些參數隨時間變化的規律：然後利用兩個迴路的電流耦合出電磁場，並模擬出磁矢量、磁通密度。 -
At last, control circuit of one cycle controlled bridge switching power amplifier is improved with the basic idea of one cycle control. the simulation results show that the amplifier of improved control circuit not only solve the question of output dc offset, but also keep the voltage gain lowered by voltage compensation technique
最後，根據單周控制的基本思路，改進了單周控制的全橋開關功率放大器的控制電路。模擬結果表明，改進控制電路后的系統不但解決了輸出直流偏置問題，而且解決了電壓補償方法所造成的放大器增益下降問題。 -
As the microbolometer which is voltage biased express some characters different from other infrared detectors under the effect of electric heat and infrared radiation together, the computing method of parameters, such as responsivity, noise, noise equivalent temperature different ( netd ), noise equivalent power ( nep ), optical gain, detectivity and so on is given in this paper. some of these parameters are particular compared with other detectors, and some have difference between microbolometer and other detectors
由於微測輻射熱計在施加偏置電壓的情況下，電熱效應與紅外輻射的共同作用使它表現出與其他紅外探測器完全不同的一些特徵，文中給出了響應率、噪聲、噪聲等效功率、噪聲等效溫差、光學增益、探測率等參數的計算方法，這些參數中的部分是微測輻射熱計獨有的，或者與其他的紅外探測器的同一參數有所區別。 -
A novel parallel - serial type cttfc ( combined two - transistor forward converter ) with coupled inductor is present in this paper, and the performance of three parallel - serial type cttfcs is studied and compared. the performance of cttfc with coupled inductor is similar to the other two cttfcs while coupling coefficient is less than one and the converter working ccm ( continuous current mode ), and input - to - output voltage gain increase one times while coupling coefficient is one
本文提出了一種耦合電感並?串型雙管正激組合變換器，並對三種並?串型組合變換器的特性作了比較：耦合系數小於1且耦合線圈電流連續時，三種並?串型組合變換器特性相類似：耦合系數為1時，組合變換器輸入輸出電壓增益增大一倍。 -
This paper simulates the effect of voltage fluctuation inspection through the tool of matlab. and proves the filters ' s stability. in the part of self - checkout, pi ( proportional integral ) control arithmetic is put forward to check the gain k and the calculated results show the method ' s effectiveness. then many comparements toward pst are done in different realization methods such as different interpolation points classification number and sample frequency. though simulation and calculation we can see the designed flicermeter can meet our country ' s standands
文中利用matlab對電壓波動的檢測效果進行了模擬；並對涉及到的濾波器的穩定性做了證明；在自校驗部分提出了將pi （比例、積分）演算法用於數字濾波器增益k值的確定，取得了不錯的效果；然後分別從取不同插值點、不同分級數和不同采樣頻率這幾個方面出發，對計算出的p _ （ st ）值進行了比較。 -
On the one hand, the design uses low voltage cascode op framework to improve its gain ; on the other hand, it applies self - bias and cascode structure to the whole sensing circuit. by using the improved method, we have successfully obtained low power consumption, low offset, high linear and high psrr ptat current generator under low power supply
在電路設計上一方面改進運放結構，採用低壓共源共柵結構以提高其增益，另一方面整體傳感電路採用自偏置結構和共源共柵電流鏡結構，在低電源電壓下成功設計了低功耗、低失調、高線性度和高電源電壓抑制比的ptat電流產生電路。 -
And the simulation on the nonlinear beam - wave interaction of two - cavity gyroklystron is made. the influences of the drift length and beam voltage and current and the velocity ratio of the electron beam and et al. on efficiency and gain are analyzed in detail
並對34ghz兩腔迴旋速調管的注?波互摘要作用進行了大量的數值模擬研究，分析了漂移區長度、電壓、電流、速度lhq值、磁場k ， ； 、注入波功率等多種因素對互作用電子效率及增益的影響。 -
Lateral high - voltage power device ldmos has advantages of high - voltage, large gain, wide dynamic range, low distortion and compatibility with low - voltage circuit process
橫向高壓功率器件ldmos有耐高壓、增益大、動態范圍寬、失真低和易於和低壓電路工藝兼容等特點。 -
The main work can be summed up as follows : firstly, we studied the thermal - field properties of vcsels, and analyzed the influences of current spreading, material parameters and operating conditions on the temperature distributions. secondly, we began with the electrode voltage and calculated the equipotential s distributions, compared the distributions of voltages and current densities in different depths of vcsels, and then studied the influences of the oxide - confining region with different position or thickness, and the different sizes of the gain - guided aperture and emitting window on the distributions of the injected current density, carrier concentration and temperature in the active region. thirdly, we realized the coupling of electricity, optical and thermal - fields, worked out the threshold voltage, calculated the distributions of the injected current density, carrier concentration and temperature under different offset voltages, and analyzed the impacts of temperature profile and carrier density on the refractive index, fermi levels and optical - field
具體工作可以概括如下：首先，研究了vcsel的熱場特性，分析了電流擴展，材料參數和工作條件對于溫度分佈的影響；其次，從電極電壓入手，計算出激光器中的等勢線分佈，並對不同深度處的電壓和電流分佈進行比較，研究了高阻區的不同位置和不同厚度、限制層和出射窗口半徑的大小對電流密度、載流子濃度和溫度分佈的影響；再次，實現了電、光、熱耦合，求出了閾值電壓，計算了不同偏置電壓下的電流密度分佈、載流子濃度分佈和熱場分佈，分析了溫度和載流子濃度變化對折射率、費米能級和光場的影響；最後，給出了考慮n - dbr和雙氧化限制層時激光器中的等勢線分佈，分析了n - dbr和雙氧化限制層對vcsel電流密度、載流子濃度、溫度和光場分佈的影響。 -
Two cold - test parameters determine the working voltage, frequency band, efficiency and gain of twt. they are dispersion and interaction impedance of the slow - wave structures ( sws ) in twt, which are very important targets for twt
行波管慢波結構的色散和耦合阻抗是行波管設計中兩個非常重要的冷參量，它們決定了整支管子的工作電壓、頻帶寬度、工作效率和增益。 -
The thesis has done the widespread investigation and study to the domestic and foreign ’ s technologies of analogy low voltage and low power, and analyzes the principles of work, merts and shortcomings of these technologies, based on the absorption of these technologies, it designs a 1. 5v low power rail - to - rail cmos operational amplifier. when designing input stage, in order to enable the input common mode voltage range to achieve rail - to - rail, it does not use the traditional differential input pair, but use the nmos tube and the pmos tube parallel supplementary differential input pair to the structure, and uses the proportional current mirror technology to realize the constant transconductance of input stage. in the middle gain stage design, the current mirror load does not use the traditional standard cascode structure, but uses the low voltage, wide - swing casecode structure which is suitable to work in low voltage. when designing output stage, in order to enhance the efficiency, it uses the push - pull common source stage amplifier as the output stage, the output voltage swing basically reached rail - to - rail. the thesis changes the design of the traditional normal source based on the operational amplifier, uses the differential amplifier with current mirror load to design a normal current source. the normal current source provides the stable bias current and the bias voltage to the operational amplifier, so the stability of operational amplifier is guaranteed. the thesis uses the miller compensate technology with a adjusting zero resistance to compensate the operational amplifier
本論文對國內外的模擬低電壓低功耗技術做了廣泛的調查研究，分析了這些技術的工作原理和優缺點，在吸收這些技術成果基礎上設計了一個1 . 5v低功耗軌至軌cmos運算放大器。在設計輸入級時，為了使輸入共模電壓范圍達到軌至軌，不是採用傳統的差動輸入結構，而是採用了nmos管和pmos管並聯的互補差動輸入對結構，並採用成比例的電流鏡技術實現了輸入級跨導的恆定;在中間增益級設計中，電流鏡負載並不是採用傳統的標準共源共柵結構，而是採用了適合在低壓工作的低壓寬擺幅共源共柵結構;在輸出級設計時，為了提高效率，採用了推挽共源級放大器作為輸出級，輸出電壓擺幅基本上達到了軌至軌;本論文改變傳統基準源基於運放的設計，採用了帶電流鏡負載的差分放大器設計了一個基準電流源，給運放提供穩定的偏置電流和偏置電壓，保證了運放的穩定性;並採用了帶調零電阻的密勒補償技術對運放進行頻率補償。 -
Closed - loop voltage gain
死循環電壓增益 -
The system can simulate the transfer process of photo - thermal and thermal - electric at a given parameter setting of structure, environment and circuit. on the basis of circuit structure, the calibration, parameter adjusting and signal readout can be simulated, the vary process of readout circuit, readout voltage, optical gain, optical gain rate, and uniformity can be given. in addition, all kinds of character parameters of device can be forecasted
本論文根據umbirfpa的原理，建立它的軟體模擬系統，它可以根據給定的結構、環境、電路設置等參數首先模擬光熱、熱電轉換過程，並可根據電路結構，模擬校準、參數調節並讀出信號，給出讀出電流和電壓、光學增益、光學增益比、非均勻性等各特徵量的定量變化過程，預測製成后器件的各種性能參數。 -
Finally, the influence the radius of the electron beam, current of the electron beam, the acceleration voltage and the geometrical dimension of the slow - wave structure on small signal gain are discussed
研究表明：對應最大的增益，有一飽和電壓存在；小信號增益隨電子注電流的增大而增大；也隨電子注半徑的增加而增大。 -
The common detector output pulse signal scope is several dozens millivolts, but the multichannel pulse analyzer input pulse amplitude request is 1 - 15v, therefore the pulse linear amplifier must have the certain voltage gain, about ten times to several times
一般探測器輸出脈沖信號幅度為幾十毫伏，而多道脈沖幅度分析器輸入脈沖幅度要求為1 - 10v ，所以脈沖線性放大器必須具有一定的電壓放大增益，為數倍到上百倍。 -
Closed loop voltage gain
閉環電壓增益 -
Open - loop voltage gain
開環電壓增益 -
Open loop voltage gain
開環電壓增益
分享友人