volume cost 中文意思是什麼

volume cost 解釋
單位體積成本
  • volume : n. 1. 卷,冊;書籍;【歷史】書卷,卷軸。2. 〈常 pl. 〉大塊,大量,許多。3. 體積;容積;分量,額;【物、樂】音量;強度,響度。
  • cost : n 1 費用;代價,價格;成本。2 犧牲;損害,損失。3 〈pl 〉訟費。vt (cost; cost)1 值,要價(苦幹...
  1. The cost for the deposition of the waste depends also upon the volume of the storage cavities and the maximum allowable radioactive concentration of the waste.

    廢料處理費用還取決于貯存空穴的容積和允許的廢料最大放射性濃度。
  2. The ratio of strength to cost is introduced to discuss the problem in which whether high volume fly ash can reduce the cost of concrete

    針對摻用大量粉煤灰是否可以降低混凝土成本的問題,本文引入強度成本這個指標作了一些探討。
  3. Cruise missile with many good qualities, such as wide uses, high precision, big power, small volume, doughty charge ability, speedy corresponsive ability, high function - cost proportion. because of the good qualities had by ballistic missile and plane, the cruise missile is a lethal weapon that constitute a weighty threat to enemy states in the modem war

    巡航導彈具有用途廣、精度高、威力大、體積小、突防能力強、反應速度快、效費比高等特點,正是由於巡航導彈兼有彈道導彈和飛機的諸多優長,所以它便成了現代戰爭的「殺手鐧」 ,成為對敵方構成重大威脅的重要武器。
  4. Using the model experiment data, the authors calculate the decreased percentage of water jump length, unit width hydraulic jump volume and the water depth downstream of the jump ; and also calculate the energy dissipation rate of dentoid baffle, it is concluded that the device of dentoid baffle can increase the energy dissipation rate of hydraulic jump theory and decrease the engineering cost

    計算了新增齒墩設施的消能量,同時計算了新增齒墩設施的躍后水深、水躍長度和單寬水躍容積減少的百分數。結果表明,採用齒墩設施,可增進消能作用,並取得顯著的經濟效益,達到附加射流水躍理論所預期的效果。
  5. However, some markets of the automobile will come into comparative satiation before long according to this increasing currentness coupled with the limitations of the city facilities and the cost. the volume of consumerism will decline, the higher and higher quality demand of the consumers will become more important

    但是,照現在的增長勢頭,加上客觀上受到城市基礎設施和使用成本的局限,也許並不需要太長的時間,局部汽車消費市場就會率先進入相對成熟期,汽車消費增長的速度就會放緩,消費者意識將更趨理性化,客戶對于全方位服務的要求也會越來越高。
  6. They can then use predications of future volume levels to identify high - cost and low - cost actions

    然後他們便可以使用未來產量水平的論斷來識別高成本和低成本的行為。
  7. Decision makers can compute the equal - cost volume of cost - driver activity by setting two cost function equations equal to one another and solving for the volume level

    決策者可以計算成本動因作業的等成本產量,通過建立兩個價值函數等式,使其相互相等,進而得到產量水平。
  8. Cost - volume - profit analysis method based on activity - based costing

    基於作業成本法的本量利分析方法研究
  9. Biosorption is a process that utilizes inexpensive active / dead biomass to sequester heavy metals and is particularly useful for the removal of contaminants from industrial effluents. compared with conventional methods such as ion exchange and precipitation with lime, the biosorption process offers the advantages of low operating cost, minimization of the volume of chemical and biological sludge to be disposed of, high efficiency in detoxifying very dilute effluents

    生物吸附技術是環境領域近年來迅速發展起來的處理工業污染廢水的新技術,它以各種生物(菌類或藻類)吸附廢水中的重金屬離子,具有吸附容量大,選擇性強,效率高,消耗少,並能有效的處理含低濃度重金屬離子廢水等優點。
  10. Wood piece is one of the major materials of composition board and papermaking. for the great volume and weight, the cost of transportation and storage increases, but the profits reduces, so it is urgent and necessary to solve the problem

    木片是人造板、造紙業的主要生產原料之一,木片在運輸過程當中,存在著體積大,重量輕的問題,導致運輸費用和倉儲費用等成本加大,使木片原本不大的利潤空間下降得更低。
  11. Cvp analysis has several limitations, for example, it assumes that volume is the only cost driver and that all cost - volume - profit relationships are linear over the relevant range of activi ? ty

    本量利分析有幾個限制條件,例如,他假定數量是唯一的成本動因,所有的本量利關系在相關范圍內都是線性的。
  12. Baf has many advantages, such as small volume, little covering earth and hydraulic retention time ( hrt ), high treatment efficiency and effluent water quality, low investment and running cost etc. baf has been used widely for many years in the world and been used to treat several wastewater in our country. in this paper, baf was studied on guanting reservoir water source treatment with pilot scale and homemade expanded clay as filtration media

    曝氣生物濾池( biologicalaeratedfilter ,簡稱baf ,或biologicalfiltrationoxidizationreactor ,簡稱biofor )工藝具有體積小、容積負荷高、水力負荷大、水力停留時間短、所需基建投資少、處理出水水質好等特點,國外已廣泛應用,國內也在多個行業的水處理中成功應用。
  13. The numerical algorithm of solving the adjoint equations for different design cases have been developed by using finite volume methodology which is usually used to solve the flow governed equation. it includes the some important aspects, such as flux formulation, wall and far - field boundary treatment methodology, dissipative term formulation, etc. after the solution of the adjoint equations is obtained, the derivatives of the cost function with respect to all the design variables can be evaluated with the same operation. this can yields a significant saving over the other gradient - based techniques when there are many design variables

    ( 3 )進行了應用控制理論和三維歐拉方程的機翼氣動反設計研究,以及有升力約束情形下機翼跨音速減阻問題研究,分別推導了相應的共軛方程及邊界條件數學表達形式,研究與發展了三維共軛方程的有限體積數值求解方法,及相應梯度公式的數值求解方法,通過對計算網格生成、流場計算、共軛方程數值求解、梯度求解和優化演算法等多方面的有效結合,成功發展了三維機翼的氣動反設計和跨音速減阻優化設計程序,成功地進行了多個設計算例研究。
  14. When confirming the location of logistics distribution center by using gravity method, it is limited in the actual application, because the location selection method only takes into account traffic cost rate and freight traffic volume

    摘要採用重心法確定物流配送中心的位置,由於選址因素只包括運輸費率和貨運量,在實際應用中受到很大限制。
  15. The author has done much research work in examining the functions of raw materials, as well as making graph analysis of the raw material. as a result, achievement have been made : ( 1 ) making sure of the standard factor and t he best mixture proportion, ( 2 ) finding out the best way of measuring the index of the high performance concrete, ( 3 ) the endurance of this high performance concrete and the volume stability have been experimented ; ( 4 ) the great economic and social benifit are obtained by cost analysis

    其主要工作進行了各種原材料的性能檢驗並做出相應圖表分析;對摻超細礦渣粉末的高性能混凝土進行正交試驗,確定了主要水平因子和最佳配合比;通過對高性能混凝土的耐久性試驗及高性能混凝土的體積穩定性試驗,確定檢測高性能混凝土耐久性指標的最佳方法及高性能混凝土的熱脹冷縮率和體積穩定性;通過對高性能混凝土的成本分析,確定摻超細礦渣粉的高性能混凝土其經濟效益和社會效益非常顯著。
  16. Using ordinary modem, the data transmission speed under the current existing twisted pair access copper telephone lines network for voice communication is limited to 56kb s, which is totally inadequate for high volume data transmission. even using the adsl technology, the maximum transmission speed can only be increased up 6mb s. to surmount this problem by providing optical network access directly to all users ? home and offices not only involve very high cost but also extremely time consuming engineering work

    現存原來用作話音通訊的雙絞銅線電話固網,在利用現時普通的modem情況下,數據傳送速度僅為56kb s即使利用較先進的adsl技術,其最高速率亦只有6mb s ,不足以應付高容量資訊的傳輸然而要做到光纖入戶,不但成本高昂,而且工程所需之時間漫長。
  17. Using ordinary modem, the data transmission speed under the current existing twisted pair access copper telephone lines network for voice communication is limited to 56kbs, which is totally inadequate for high volume data transmission. even using the adsl technology, the maximum transmission speed can only be increased up 6mbs. to surmount this problem by providing optical network access directly to all users ? home and offices not only involve very high cost but also extremely time consuming engineering work

    現存原來用作話音通訊的雙絞銅線電話固網,在利用現時普通的modem情況下,數據傳送速度僅為56kbs ;即使利用較先進的adsl技術,其最高速率亦只有6mbs ,不足以應付高容量資訊的傳輸;然而要做到光纖入戶,不但成本高昂,而且工程所需之時間漫長。
  18. Both the qualitative approach regarding the role of logistics in a company as well as its logistics capability and empirical methods like the theory of economies of scale and the volume - cost - profit analysis model are utilized in the paper to explain the choice of self - conducting logistics or outsourcing logistics

    既從物流在企業中所佔地位和企業物流能力等定性方面進行分析,又用規模經濟的理論,借鑒量本利分析的模型,來解釋商業企業是採用自營物流還是採用外包物流。
  19. Assist to manage process to secure and update information on volume, cost requirements, supplier capability and competitive intelligence on supply chain issues

    協助監控產品生產、報價、供應商產能及競爭優勢等供應鏈管理的相關過程信息。
  20. Since grinding media are always consumed in a great volume, cost and durability become the most important characteristics sought

    研磨材料有大量消耗的特性,因此成本一向是最大的考量因素,我
分享友人