water annealing 中文意思是什麼

water annealing 解釋
水冷退火
  • water : n 1 水;雨水;露;〈常作 pl 〉 礦泉,溫泉;藥水。2 〈常 pl 〉水體;水域;水道;海;湖;河;海域;...
  • annealing : 熱處理
  1. The main contributions are as follows : ( 1 ) de ( differential evolution ) algorithm is proposed to invert the ocean acoustic parameters in shallow water in order to get faster and more accurate results than ga ( genetic algorithm ) and sa ( simulated annealing algorithm ). also a posteriori probability analysis method is applied to evaluate the uncertainty of inversion results. ( 2 ) maximum likelihood objective functions for broadband mfi are derived according to different conditions

    ( 2 )根據不同的前提條件,採用似然比的方法推導了寬帶匹配場反演的最大似然目標函數;深入地研究了寬帶匹配場處理中的相干與非相干問題;在分析參數反演的敏感性之後,提出了淺海環境參數寬帶匹配場反演的多步優化策略,並與全參數反演方法進行了性能上的模擬比較。
  2. The soi is of crystal quality and the box is uniform in thickness, with the interfaces of si / sioa / si smooth and sharp. we have systematically studied the dependence of the formed soi structure on the process parameters, such as ion energy, implantation dosage, substrate temperature, as well as the annealing temperature. with xtem, sims, srp, rbs, ir, raman, aes, xps and other characterization tools, it was found that a dose window at fixed energy for water plasma ion implantation to form high quality soi structure similar to the conventional simox process exists

    本論文還系統地研究了不同注入劑量、注入能量、注入時基底溫度以及退火溫度對所形成soi結構性能的影響,藉助xtem 、 sims 、 srp 、 rbs 、 ie 、 raman 、 aes 、 xps等測試分析手段,我們發現,與傳統注氧隔離( simox )技術類似,存在著「劑量窗口」形成優質的soi材料,但在水等離子體離子注入方式中soi材料結構質量對劑量變化更為敏感,隨著注入劑量的增大, soi材料的埋層厚度增大而表層硅厚度減小。
  3. Standard guide for in - service annealing of light - water cooled nuclear reactor vessels

    輕水冷卻核反應堆容器在運轉中逐漸冷卻的標準指南
  4. Xps showed that there were much chemical absorbing water on the ti _ ( 2 ) film surface which mainly existed in form of - oh, and the contents of - oh was increasing with the annealing temperature. hydrophilic property became better with the annealing temperature ; the essential relation between the changing of contact angle and light - induced - electrons and light - induced - cavities was studied in details. the photocatalysis of samples without heat treatment was very bad, but that of samples after heat treatment was much better

    Xps的分析表明:試樣的表面含有大量的化學吸附水,主要以羥基的形式存在,隨著熱處理溫度的升高,吸附羥基的含量在增加;親水性能測試表明:隨著氧氣分壓的變化,其親水性能變化不大,隨著熱處理溫度的增加,試樣的親水性能在變好,並從理論上解釋了親水性能光照前後變化和光生電子?空穴對之間的本質關系。
  5. Abstract : with simulated annealing approach based on simple method, the dynamic system of some submarine - launched missile carrier s water trajectory is identified, and the effects of no - modeling uncertainty and dimension of parameters to be identified on overall identification precision are investigated

    文摘:運用基於單純形的模擬退火演算法對某潛射導彈運載器水彈道動力學系統進行了辨識,並探索了未建模不確定性及待辨識參數矢量的維數對辨識精度的影響。
  6. An ion implanter without ion mass analyzer was applied to simulate the phi procedure to fabricate soi materials by implantation of water plasma ions. thin soi structure was successfully fabricated by the implanter using 50 ~ 90kev water plasma ion implantation with the dose ranging from 2 - 6. 5 + 017cm - 2 and, subsequently, the high temperature annealing

    我們使用無質量分析器的離子注入機,模擬等離子體離子注入過程,成功地在該注入機上用水等離子體離子注入制備出了界面陡峭、平整,表層硅單晶質量好,埋層厚度均勻的薄型soi材料。
  7. The optimal design of water supply networks is an important task of town water supply engineering. it has been broadly and deeply studied by many domestic and foreign scholars and many representative optimal theories and design methods have been advanced such as enumerating method, liner programming method, dynamic programming method, genetic algorithms ( ga ) and simulated annealing ( sa ) and so on

    給水管網優化設計是城鎮供水工程的一項重要工作,國內外許多學者都對此做了廣泛、深入的研究,提出了很多具有代表性的優化設計理論與方法,例如枚舉法、線性規劃法、動態規劃法,還有遺傳演算法和模擬退火演算法等。
  8. The optimal design of water supply networks has been broadly and deeply studied by many domestic and foreign scholars because of its important status in water supply engineering. the scholars advanced many kinds of optimal methods, such as tabu search method, simulated annealing method, genetic algorithms method, artificial neural networks method

    由於給水管網優化設計在給水工程中佔有重要地位。國內外學者對其進行了廣泛而深入的研究,提出了多種優化方法,諸如禁忌搜索、模擬退火、遺傳演算法和人工神經網路演算法。
  9. The contact angle with water is 64 ? for the thin film without annealing. after 650 ? annealing treatment, the contact angle becomes 0. with proper sno2 doping, the hydrophilicity of tio2thin film will be also improved

    ( 3 )沒有經過熱處理的tio _ 2薄膜與表面水滴的接觸角為64 ,經過650熱處理后薄膜與水滴的接觸角為0 ,摻雜sno _ 2對tio _ 2薄膜的親水性有所改善。
  10. Optimization of water supplying station with simulated annealing algorithm

    基於模擬退火演算法的運梁車輛轉向機構優化
  11. It carries out hydraulic computation and analysis of water supply networks and constructs the computation programs for the optimal designing of urban water supply networks using annealing and genetic algorithm. some improvements have also been achieved in the algorithm suitable for network optimal design

    通過對給水管網水力計算分析、管網優化設計的研究,用模擬退火演算法及遺傳演算法編制了城市給水管網優化設計的計算程序,並作了適合管網優化設計的演算法改進。
分享友人