wear ring 中文意思是什麼

wear ring 解釋
承磨環
  • wear : vt (wore ; worn )1 穿著,戴著,掛著,佩著,帶著。2 留著(胡須等);有著(記憶等)。3 帶著(某...
  • ring : n 1 圈,環,輪;戒指,指環,耳環,鼻圈,鐲子(等);【運】吊環。2 輪狀物;【植物;植物學】年輪;...
  1. A 、 head wear, plastron and trinket serial products with all kinds of material and novel design ; finger ring and necklace serial products ; foot ornament, adornment and article decoration serial products ; ear ring and waist decoration products ; chain ornament franchise store ; decoration accessories ; tie clip ; mobile phone decorations ; eyeglasses ; related machinery equipments etc

    各類材質設計新穎的頭飾、胸飾、手飾產品系列;戒指、項鏈系列產品;腳飾、佩戴飾和物飾系列;耳環、腰飾產品;飾品連鎖加盟店;飾品配件;領帶夾;手機飾品;眼鏡;相關機械設備等。
  2. 1. 5 m in diameter ) were dispersed in n46 engine oil with different concentrations using ultrasonic respectively in order to study their tribological properties. the tribological experiments were carried out by mq - 800 four - ball tribometer and mm - 200 ring - on - block tribometer, in which extreme pressure properties, wear scan diameter, friction coefficient and wear volume loss were measured. the results showed that oil containing mos2 nanoparticles had a better wear resistance, friction - reducing and extreme pressure than the oil containing common mos2

    將上述制備得到的納米二硫化鉬顆粒和普通二硫化鉬粉末( 1 . 5 m )以不同濃度分散在n46機械油中,在mq - 800四球摩擦磨損試驗機上考察它們的最大無卡咬負荷( p _ b值) 、耐磨性能和摩擦系數;並在mm - 200摩擦磨損試驗機上,通過環?塊摩擦副,比較和分析了它們的摩擦學特性。
  3. She wear a wedding ring to show that she ' s married

    她戴一枚結婚戒指,表示她已婚。
  4. Double ring tractor chains feature case hardened rotating cross chain rings, providing consistent wear and superior traction in the most difficult mud and snow condition

    雙圓環拖拉機鏈以能轉動的、表面經硬化處理的過渡鏈為特色,在泥濘和有雪條件下防滑性能出色。
  5. Why must we wear the ring on the fourth finger

    為什麼婚戒要帶在無名指上
  6. The degrees of crystallinity of pure ptfe under the different conditions of water cooling, air cooling and furnace - varying cooling were made comparison by xrd. the thermal stability of pure ptfe and solid lubricant was analyzed by dsc - tg ; the composition and valence state of elements in the surface of carbon fiber, solid lubricant before and after friction test and lubricant transfer film were characterized by xps ; the frictional property of solid lubricant was tested by pin and disk test rig. the frictional wear property of solid lubricant between embedded bearing sleeve and steel axle friction pair ring was tested by special simulate test machine, the hardness of solid lubricant was tested by pm ; the compression strength of solid lubricant was tested by material test machine

    用sem表徵原料微觀結構、摩擦表面及潤滑轉移膜表面形貌:用xrd進行原料物相分析,及比較水冷卻、空氣冷卻、隨爐冷卻三種工藝條件下的純聚四氟乙烯樹脂的結晶度;用dsc - tg分析純聚四氟乙烯樹脂及固體潤滑劑的熱穩定性;用xps表徵碳纖維表面、固體潤滑劑摩擦前後表面、潤滑轉移膜表面的元素組成、價態變化;用銷盤式摩擦磨損試驗機對固體潤滑劑進行摩擦性能測試;採用專用的臺架模擬試驗機對固體潤滑劑鑲嵌軸承套與鋼軸摩擦副間的摩擦磨損性能進行測定;用萊次偏光顯微鏡( pm )測試固體潤滑劑的硬度;用材料試驗機測試固體潤滑劑的抗壓強度等。
  7. Standard test method for ranking resistance of plastic materials to sliding wear using a block - on - ring configuration

    用環形結構塊料給塑料材料的抗滑動磨損特性分等的標準試驗方法
  8. Stationary ring enclosure is made out of concentrated carbon graphite, anti - wear - out, waterproof, and suitable for dry operation

    固定環封閉物是特殊的材料,是抗磨損碳精石墨所製造的,不透水和乾式運轉。
  9. Metallic materials - wear tests block - on - ring wear test

    金屬磨損試驗方法環塊型磨損試驗
  10. Metallic materials - wear tests - block - on - ring wear test

    環塊型磨損試驗
  11. Standard test method for calibration and operation of the falex block - on - ring friction and wear testing machine

    法列克司環塊磨擦試驗機和磨損試驗機的校準和操作標準試驗方法
  12. I am afraid the gilt of the ring will wear off before long

    恐怕戒指的鍍金層不久就會磨掉。
  13. I know someday that she ' ll wear my ring

    我知道有一天她會帶上我送的指環
  14. The friction and wear behavior of the nanocomposites sliding against aisi - 1045 steel under water - lubricated condition and dry condition was examined on an m - 200 test rig in a ring - on - block configuration

    採用m - 200型環-塊摩擦磨損試驗機研究了復合材料在水潤滑與干摩擦條件下的摩擦磨損行為,對摩材料為45 ~ #鋼。
  15. Thereby measures for improvement are put forward : ( 1 ) adopting a small wheel to replace the steel ball of the ball type unit to ensure more reliable motion of the creeping device ; ( 2 ) applying expansible metallic ring replacing the step - by - step teeth on tooth type unit ; ( 3 ) fixing a sensor in the reversing device for obtaining the information of motion and wear of the creeping device

    為此,提出改進措施: 1 .對球型步進式清蠟器採用帶穿軸的小輪代替鋼球,可使爬行器運動更可靠; 2 .對齒型步進式清蠟器,採用可脹緊金屬環代替步進齒,金屬環依靠抽油機的沖程力脹大后使爬行器固定,反沖程力使金屬環縮小; 3 .將傳感器裝在換向器內,根據信號的時間間隔判斷爬行器的運行速度及磨損等情況。
  16. Model - c design, with an energizer o - ring beneath the seat - carrier, enables the valve to automatically adjust for seat wear

    型號c結構,在閥座支架下配置增能器o形環,使得閥門能夠根據閥座磨損狀況自動進行調整。
  17. Abrasion resistant radial wear ring is standard on model 6123 and smaller. hardened ss wear rings optional on all models

    耐磨的徑向磨損環。配置在6123型號和更小的泵上。
  18. Instead of buying an expensive engagement ring that just ends up in a drawer, couples are buying things they can wear all the time such as brand - name watches

    與其高價購買一隻僅僅標識承諾的訂婚戒指,不如買一件可以隨時佩戴的東西,比如名表。
  19. Based on an experiment performed on the piston ring - cylinder bore wear tester, liquid - solid lubrication is investigated in this thesis. the wear of the samples under different lubrication conditions ( the solid concentrations are 0 %, 0. 02 % and 0. 1 % by weight ) are discussed. the variations of the surface topography, especially the statistical parameters and functional parameters are studied, and the reasons that cause the variations are analysed

    本研究基於活塞環-缸套摩擦磨損臺架實驗研究了液-固二相流體潤滑的問題,探討了潤滑油中不含固體顆粒、含有0 . 02和0 . 1納米顆粒三種潤滑狀態下的磨損情況,並進一步研究了液-固二相流體潤滑狀態下試件表面形貌特性的變化,主要是統計參數和功能參數的變化,並探討了引起變化的原因,為更深入的液-固二相流體潤滑問題的研究以及表面形貌設計提供理論上的參考。
  20. The signal processing software was developed by vc + + tools. the modules of the software including board controlling, signal input, data saving, figure display, statistic computing, filter design, spectrum analysis, etc. based on the experiment performed on the piston ring - cylinder bore wear tester, the friction force and max scuffing load under different liquid - solid lubrication ( the solid concentrations are 0 %, 0. 02 % and 0. 1 % by weight, the type of particles are mos2 and udp ) is investigated in this thesis

    然後,以內燃機中的活塞環-缸套摩擦副為目標,在活塞環-缸套摩擦副實驗臺架上進行模擬實驗,考察在不同二相流潤滑(潤滑油分別為純潤滑油、含納米級金剛石粉( udp ) 、二硫化鉬粉( mos _ 2 )的濃度為0 . 02和0 . 1的液-固二相潤滑油)條件下摩擦副的摩擦力及極限擦傷載荷的變化。
分享友人