working height 中文意思是什麼

working height 解釋
工祖高度
  • working : adj 1 工作的，從事勞動的。2 操作的，作業的。3 工人的。4 （用於）實際工作的，任事的；使用（中）的...
  • height : n 1 高，高度；身高；海拔。2 〈常 pl 〉高地，山丘。3 高貴，卓越。4 絕頂，頂點；【聖經】天。5 〈罕...
  1. Based on the experiment results, the damage form of abnormal exterior joint are summarized, characteristics of hysteresis curve are studied, the effect of stirrup ratio and height of column section and beam section on anti - shear property of abnormal joint are discussed, working mechanism of abnormal exterior joint is researched, the conclusion that the anti - crack and bearing capacity of abnormal joint are studied by analyzing the minor core of abnormal exterior joint is proposed, the basic data is provided for the design formula of abnormal joints

    根據試驗結果，總結了異型邊節點的破壞形態，研究了節點滯回曲線的特徵，討論了節點核芯配箍率、樑柱截面高度變化對異型邊節點抗剪性能的影響，分析了異型邊節點的受力機理，提出應以「小核芯」為分析單元來研究此類節點抗裂和承載力的建議，為異型節點設計公式的建立提供了基礎數據。
  2. The explaining for region gravity and magnetic data is accomplished by using result of potency field transformation through level and vertical relating with level one - difference of several height and vertical two - difference and working out construct map of region geophysics

    對區域重磁資料的解釋就是利用位場變換結果，是通過不同延拓高度的水平一階導數、垂向二階導數圖的解釋，再進行水平和垂向關聯，編制區域物探構造圖的方式實現。
  3. Must have working knowledge of cmm, micro - height, hardness tester, surface gage, calipers, and additional equipment

    必須有關于cmm ，高度測量，硬度測試，表面測量，齒輪等設備知識。
  4. Tower crane has following characteristics : discontinuous working, starting & braking frequently ; there are noticeable vibration and impulsion in running ; high lifting height and extend rang, heavy lifting moment, etc. with the advent of more and more high - rise and large - scale buildings, requirements for the efficiency, lifting height, lifting moment, and safety features are becoming higher and higher

    塔式起重機具有下述工作特點:斷續工作、頻繁啟動、制動;運行過程中有明顯的振動和沖擊;起升高度和工作幅度較大，起重力矩大。隨著社會中各類高層建築和大型工程的出現，使其對塔機的工作效率、起升高度、起重力矩和安全性等工作性能提出了更高的要求。
  5. The equilibrium model is characterized by the murphree efficiency or height of equivalent to a theoretical plate ( hetp ) value since a tray is generally not working like an equilibrium stage

    實際精餾過程往往很難真正達到汽液平衡狀態，因此murphree板效率和等板高度概念常用於修正平衡模型計算中的非理想特性。
  6. The operations on safety of working - at - height and scaffold focused on the external renovation work of buildings

    在高空工作與棚架的突擊檢查行動中，我們重點巡查大廈外墻維修工程。
  7. Containers must be redelivered clean. note permissible weight limits for road and rail transport. the technical details of 1cctank container for yellow phosphorus : working pressure : 0. 4mpa test pressure : 0. 6mpa external dimensions ( lx w x h ) mm : 6058 x 2438 x 2591 maximum gross : 30480 kg stacking height : 9 x 30480 kg insulation

    這種罐箱容量大，密封性能好，使用周期長，抗振強度高，不易被損壞，操作方法實用；而我國現在使用的250l塑料桶，其回收或處理成本高，且污染環境，所以iso1cc黃磷罐式集裝箱是一種理想的替代塑料桶的貯運設備。
  8. Requirements that good image and the the height of 162cm is above, fluent mandarin speaking and relevant similar working experience is demaned

    要求：身高162以上，形象較好，普通話流利，有一定迎賓部長工作經驗者優先考慮
  9. The cas also provided basic mountain rescue training for members of the emergency services and working - at - height training for staff of government departments and the private sector. in 1998, 19 mountain rescuehiking safety courses and 10 working - at - height training sessions were conducted

    此外，民安隊也為其他緊急部隊提供基本的攀山搶救訓練，並且為各政府部門和私人機構的人員提供高空工作安全培訓課程。
  10. Require female, healthy, good image and age belowed 25 years old, the height of 1. 60m is aboved, familiar with the similar softwar system and has relevant working experience is preferred

    其他要求：女性，身體健康，五官端正，有相關收銀工作經驗， 25歲以下，身高在1 . 60米以上。熟悉西軟系統者優先考慮
  11. The traditional level measuring methods can n ' t meet our demand because the subjective investigated is in such a poor systemic condition that the temperature is a little high and there ' s so many mill dust and steam there. in this article we perform systemic discuss and research against the dynamic level measuring method under special working condition on the basis of analyzing kinds of level measuring technique in and abroad. first we establish the pressure distribution mathematic model in storage bin and then deduce the mathematic relation between level height and the uniform stress on the bottom of the bin and designed a resistance compressive stress sensor used for the special condition and put forward a resoivement according to its zero excursion existing in practical use

    由於本研究系統被測對象環境溫度較高且潮濕，同時料倉中有大量粉塵及蒸汽，因此傳統的料位檢測方法不能滿足本測試要求。本文在分析國內外各種物位檢測技術的基礎上，針對特殊工況下動態物料高度的檢測進行了系統的探討與研究。首先建立了料倉中的壓力分佈數學模型，推導出料位高度與倉底均布壓力間的數學關系式，並據此設計了中溫電阻應變式壓力傳感器，同時對它在實際應用中存在的零點漂移等問題提出了改進措施，提高了傳感器性能，解決了上述特殊工況下動態物料檢測的技術難題。
  12. Visual numeric simulation of the height of fractured zone in no. 2 northern working area in donghuantuo mine, kailuan

    開灤東歡坨礦北二采區冒裂帶高度可視化數值模擬
  13. Ensure credible working platforms when working at height

    高處作業有可靠的操作平臺。
  14. There is no thoroughly rounded theory about displacement ventilation system in our country at present and our research begins recently. the study work of this paper will be useful for further optimization design of displacement ventilation system. this dissertation includes five parts. the first part introduces the development of the displacement ventilation and the background of research in domestic and oversea. in the second part, it gives working principle of displacement ventilation system and it ’ s advantages to the mixture ventilation. the study also gives a series of indexes to evaluate displacement ventilation system and specifies air supply terminal device and so on. it is needed to simulate and analyse the velocity field, temperature field and distribution of flow field. this is the third part. the forth part specifies the simulative method for thermal stratification of displacement ventilation system. it gives some factors affecting thermal stratification height such as inlet temperature, inlet velocity, heat transfer of wall body, distance of heat source and so on

    本文的研究工作主要包括以下幾個方面的內容: （ 1 ）綜述了國內外相關的研究現狀和研究背景; （ 2 ）簡介了置換通風的工作原理，並分析了它相對于混合通風的優良特性及評價指標、末端裝置等; （ 3 ）對採用置換通風方式房間的溫度場、速度場和氣流分佈進行了模擬計算與分析; （ 4 ）對採用置換通風方式房間的熱力分層高度進行了模擬計算，並分析其影響因素，如:送風溫度、送風速度、圍護結構傳熱和熱源分佈等; （ 5 ）擬合了無量綱熱力分層高度相應于送風溫度t 、送風速度v 、熱源間距離l和圍護結構傳熱q的經驗公式。
  15. Gold gets the stratum that estate is concentration of social elite height, the age comes 45 years old in 25 years old between, had gotten good education, ability of the working experience with have certain, management plan, professional skill and resource of certain human relations in society, income yearly salary is in 150 thousand to 400 thousand between

    金領階層是社會精英高度集中的階層，年齡在25歲至45歲之間，受過良好的教育，有一定的工作經驗、經營策劃能力、專業技能和一定社會關系資源，收入年薪在15萬到40萬之間。
  16. During the year, 70 mountain rescue and hiking safety courses and three working - at - height training sessions were organised

    二零零零年舉辦的攀山搶救及遠足安全訓練共有70項；而高空工作安全培訓課程則有三項。
  17. The cas also provided basic mountain rescue training for members of the emergency services and working - at - height training for staff of government departments and the private sector

    此外，民安隊也為其他緊急服務部隊提供基本的攀山搶救訓練，並且為各政府部門和私人機構的人員提供高空工作安全培訓課程。
  18. A number of special blitz operations were also organised on safety of working - at - height, scaffold, container handling, gas welding and flame cutting, fire and chemical, and plant and machinery

    我們亦組織了多次突擊檢查行動，以檢查高空工作、棚架、貨櫃處理、氣體焊接及火焰切割、防火和化學品，以及工業裝置及機械的安全。
  19. Bearing capacity and displacement are two main problems in the application of geotechnical engineering. based on a series of pull - out tests using three kinds of paper and a sort of window screening as geogrid, twenty - seven in limit and several in working - stress geogrid - reinforced slope model tests designed through orthogonal principle have been conducted to have obtained the relationship between the bearing capacity and four factors ( i. e. reinforcement, angle of reinforced slope, the designed - length of reinforcement and the distance between layers of reinforcement ). the law of slope lateral ( horizontal ) displacement versus to the height of slope vary with external - load was derived from the model test data, and the main factor affecting the lateral and vertical displacement of geogrid - reinforced slope was obtained through analysis

    承載力（強度）和變形是巖土工程應用領域的兩大主要問題，本文以紙和窗紗布模擬加筋土邊坡的土工格柵，在一系列拉拔試驗的基礎上，以正交設計理論分別安排27個極限應力狀態和若干個工作應力狀態加筋土邊坡模型試驗，並以模型試驗獲得的數據為依據，採用誤差、極差及回歸分析方法，探討了加筋土邊坡承載力與筋類、筋長、層間距、坡角4因素的相關關系，獲得了在外荷載作用下加筋土邊坡的側向位移隨坡高的變化規律（並進行了定性解釋）和坡頂的豎向位移特性，並分析其主要控制因素。
  20. In crane choosing, three parameters should be taken into consideration : payload capacity ( q ), lifting height ( h ) and working radius ( r ). and three parameters should meet design requirements at the same time

    選擇起重機的型號原則是所選起重機的三個工作參數，即起重量q ，起重高度h和工作幅度（回轉半徑） r均需要滿足班組結構吊裝要求。
分享友人
分享到 Line

分享到臉書