wrist-joint 中文意思是什麼

wrist-joint 解釋
機構手的腕關節
  • wrist : n. 1. 腕；（衣袖等的）腕部；【解剖學】腕關節；【機械工程】肘節；肘桿；軸；樞軸；耳軸；銷軸。2. 腕部能力[技巧]，腕力；〈比喻〉手腕。vt. 用腕力移動[送出、拋擲等]。
  • joint : n 1 接合，榫接合處，接合點。2 【解剖學】關節。3 【植物；植物學】節。4 【電學】接頭。5 【建築】接...
  1. Treatment of pigmented villonodular synovitis of wrist joint : a report of 1 case

    腕關節色素絨毛結節性滑膜炎1例
  2. Effect of wrist joint angle

    征檢查結果的影響
  3. Right wrist joint ap lat

    雙腕關節正位成人
  4. Left wrist joint ap lat

    右側腕關節正側位
  5. Radiocarpal joint wrist joint

    橈腕關節
  6. Dual wrist joint ap

    雙腕關節正位兒童
  7. He also accumulated copious experiences in the field of peripheral nerve injury, wrist joint injury and disease, reconstruction of the hand and the fingers, et al

    在周圍神經損傷與疾患，腕關節損傷與疾患，手指再植與再造，先天性手畸形等領域均有一定造詣。
  8. Each of the 17 volunteers had a vibrating device attached to their wrist to stimulate a tendon, which created the false sensation that the wrist joint was flexing

    17位志願者的每一位都有振動儀器皆在他們的腰上刺激一個腱，以製造一個腕關節正在收縮的錯誤感覺。
  9. The blow is struck with the side of the hand, all the force being concentrated in one small area, approximately half way between the base of the little finger and the wrist joint

    該技術以手掌外側進行打擊，全部力量集中在一個狹小區域，約在小指根部到腕關節的正中間。
  10. Among them, operating with the power from the tip of the thumb is called finger - tip pushing ; in which the interphalangeal joint of the thumb is fixed at the back - stretching position, operating with the force from the whorled surface is shao - shang point at the side of the thumb - radius is called lateral pushing, in this operation, the operator slightly flexes his wrist joint with index finger, middle finfer, ring finger and little finger naturally stretching forward in the finger - separating pattern

    以拇指端峰為著力點操作的稱指峰推；操作時，拇指之間關節固定在背伸位，以羅紋面為著力點的稱羅紋推；以拇指橈側少商處為著力面的又叫偏峰推，此法操作時腕關節略屈，食、中、無名、小指向前自然伸開，成散手狀。
  11. The common sites of osteoporotic fracture include the spine vertebrae, the forearm near the wrist and the thigh bone near the hip joint

    常見骨折處有脊椎骨前臂骨及股骨。如脊椎骨因骨質疏鬆而漸漸塌陷，背部會變得彎曲，形成駝背及變得矮小。
  12. The common sites of osteoporotic fracture include the spine ( vertebrae ), the forearm near the wrist and the thigh bone near the hip joint

    常見骨折處有脊椎骨、前臂骨及股骨。如脊椎骨因骨質疏鬆而漸漸塌陷，背部會變得彎曲，形成駝背及變得矮小。
  13. If the error of structural parameters of the spherical - wrist and the error of movement variables of every joint were comparatively big, there will produce rather big deviation in searching the posture error of end executor by the use of existed method

    如果球腕的結構參數誤差與各關節的運動變量誤差比較大，則應用現有的方法求取末端執行器的位姿誤差會產生較大的偏差。
  14. One key component of the flexible wrist is joint and the research of it is very important

    其中，柔性機械手的關節構件是影響其運動的關鍵，對柔性機械手腕關節的研究具有十分重要的意義。
  15. The disadvantages of the methods are : robot had to be disintegrated in some methods, that is, these methods cannot perform on - line ; or, obtained the combination value of the robot ' s inertial parameters only by the other methods. and the common problem of the four methods is that the joint ' s characteristics of robot cannot be included. then, author developments a new method for on - line identification robot end - effector ' s inertial parameters based on robot ' s wrist force sensor, theoretic analyses of the method are given in details

    第五章首先明確機器人連桿的慣性參數並不是機器人單個連桿的慣性參數，機器人連桿的慣性參數必須考慮機器人關節的關節特性；針對目前對機器人的關節特性建模還沒有一個切實和行之有效方法的現狀，提出了一種基於機器人基座力傳感器的機器人連桿慣性參數識別方法，該方法不需對機器人的關節特性建模，可以獲得機器人連桿獨立的慣性參數值（而不是慣性參數的組合值） 。
  16. The aim is to get the rotation angles of left and right hands ' shoulder joints, elbow joints, wrist joints, sternoclavicular joint and the trunk when there is the longest horizontal distance between the center of gravity and the finish position

    主要目的在於利用創建的模式求解重心與沖線位置生成最大水平距離時，左右手之肩關節、肘關節、腕關節及頸關節與軀干扭轉的角度。
  17. The joint forces are usually sense using strain gauges arranged in the robot wrist assembly

    關節受力通常是用安裝在機器人手腕組合件處各種張力傳感器來檢測。
分享友人
分享到 Line

分享到臉書