x-ray and electron microscopy analysis 中文意思是什麼

x-ray and electron microscopy analysis 解釋
射線和電鏡分析
  • x : X2＝ （羅馬數字）10 XX ＝ 20 IX ＝ 9 XV ＝ 15 XL ＝ 40 LX ＝ 60 XC ＝ 90 DXL ＝ 540 MX ＝ 1010 ＝...
  • ray : n 雷〈姓氏，男子名， Raymond 的昵稱〉。n 1 光線，射線，熱線；〈詩〉光輝，閃爍，曙光，一線光明。2 ...
  • and : n. 1. 附加條件。2. 〈常 pl. 〉附加細節。
  • electron : n. 【物理學】電子。 the electron beam 電子束。 the electron theory 電子（學）說。
  • microscopy : n. 顯微鏡學；顯微鏡使用術。
  • analysis : n. （pl. -ses ）1. 分解，分析；【數學】解析。2. 梗概，要略。3. 〈美國〉用精神分析法治療（＝ psychoanalysis）。
  1. Chiral quaternary ammonium salts were synthesized from cinchonine in cinchona alkaloids using chloromethylated polystyrene - polyethylene glycol, diethylene glycol, triethylene glycol and glycol as polymer - supported phase transfer catalysts, finsl products were characterized by ftir, elemental analysis, scanning electron microscopy, x - ray photoelectron spectroscopy ( xps )

    摘要以金雞納生物堿中的辛可寧為原料，氯甲基化聚苯乙烯聚乙二醇、一縮二乙二醇、二縮三乙二醇、乙二醇等為載體合成了幾種聚合物負載的手性季銨鹽，並對它們的結構用紅外光譜、元素分析、掃描電鏡和x射線光電子能譜等測試手段進行了表徵。
  2. The corrosion behavior of nanocrystalline ( nc ) copper bulks with various grain sizes prepared from igc ( inert gas condemsation ) and vacuum annealing in comparison with conventional microcrystalline ( mc ) copper ( as - rolled and electrolytic ) in acid copper sulphate solution and neutral solution containing chlorides under free corrosion conditions and anodic polarizations has been studied using potentiodynamic polarization, potentiometric analysis, cyclic voltammetry and electrochemical impedance spectroscopy. x - ray diffraction was used to estimate the grain size of the annealed nc copper. field emission gun scanning electron microscopy and x - ray energy - dispersive spectroscopy was used to characterize the surface morphology and analyze the surface composition after the polarization and potentiometric test of both nc and mc copper

    本文研究了用igc （惰性氣體蒸發凝聚原位溫壓法）制備並真空退火到不同晶粒尺寸的納米晶銅和微米晶銅（冷軋紫銅、電解銅）在酸性硫酸銅溶液和中性含氯溶液中，在自腐蝕狀態和陽極極化狀態下的腐蝕性能。使用了動電勢極化、電位測定、循環伏安法（ cv ）和電化學阻抗譜（ eis ）等方法。 x -射線衍射（ xrd ）的方法用來估算納米晶銅晶粒尺寸。
  3. The properties of thin films have been investigated with modern analysis technique, such as afm ( atom force microscopy ), sem ( scanning electron microscope ), xrd ( x - ray diffraction ) and rocking curve ( - scan ). and the properties of ybco thin film and its substrate and deposition temperature have been analysed, comparing with lao substrate ' s crystallization quality, ybco thin film properties, such as morphology and degree of grain alignment, was concluded to correlate with the crystal orientation uniform of lao substrate as revealed by xrd

    本文結合afm 、 sem研究ybco薄膜的表面形貌， xrd 、 fwhm分析薄膜的結晶情況，並結合成膜溫度和基片的質量進行一系列結構與性能的對比研究，發現laalo3 （ lao ）基片的質量對ybco薄膜的結構完整性有很大影響，不僅影響了薄膜的c軸取向性，而且影響了ybco的超導性能。
  4. The morphology, composition and crystalline of the composite particles were characterized by scanning electron microscopy ( sem ), x - ray diffraction ( xrd ) and thermo - gravimetric analysis ( tga ) techniques

    利用掃描電子顯微鏡（ sem ） 、 x -射線衍射分析（ xrd ）和熱重分析（ tga ）對復合微球的形貌、無機沉積物cds的晶型和有機-無機成分相對含量等進行了表徵。
  5. The melted tungsten carbide would react with the steel matrix on the interface and the reaction zone was observed as a result. the reacting production was examined as fe3w3c by means of x - ray diffraction and scanning electron microscopy analysis. the reaction between tungsten particle and steel matrix could improve the interfacial bonding strength remarkably

    Wc鋼復合材料的制備過程中， wc顆粒在高溫下發生了局部溶解並在wc顆粒和鋼基體界面處發生了界面反應； x射線衍射和電子衍射花樣分析表明，反應產物為高穩定性的fe _ 3w _ 3c ，界面反應有效地改善了wc顆粒與鋼基體的界面結合。
  6. Worn surfaces of sliding pairs were characterized by scanning electron microscopy ( sem ). chemical compositons on the worn surfaces were analyzed by energy dispersion x - ray analysis ( edax ), and profiles and suface roughness of the worn surfaces were measured by stylus profilmetry

    用掃描電子顯微鏡（ sem ）對磨痕表面形貌進行了分析，用能量色散x射線分析（ edax ）對磨痕表面進行化學成分分析，並用表面輪廓儀測定了磨痕表面粗糙度和磨痕表面輪廓曲線。
  7. Sem, transmission electron microscopy ( tem ), x - ray energy - dispersion analysis ( edax ), xrd, electron diffraction ( ed ) and high - resolution electron microscopy ( hrem ) were used to investigate the morphology, atomic composition and crystal structure of the nanowires. the hexagonal cdse nanowires with single crystal structure have been obtained in dmso under 140. ( 3 ) semiconductor te and cdte nanowires embedded in aao templates were fabricated for the first time by dc < wp = 7 > electrodeposition in ethylene glycol

    Sem 、 tem 、 edax 、 xrd 、 ed 、 hrem分析的結果表明，所得cdse納米線為六方晶型，晶體的（ 001 ）晶面沿平行於基底的方向擇優生長，且隨沉積溫度的降低，這種擇優生長的趨勢越來越強；納米線晶體在生長時，由於受aao模板孔徑的限制，形成c軸方向拉長的晶粒，其長徑比達5 1以上；晶體的大小和完善程度隨沉積溫度的降低而增大， 185沉積得到多晶六方cdse納米線，而140沉積時可得到六方cdse單晶納米線。
  8. Current researches, applications, preparation and structure of si3n4 are summarized in this paper. a new conclusion is drawn that silicon wafer can react with nitrogen at the temperature higher than 1100 and in super - pure nitrogen by direct - nitridation of silicon at the temperature from 800 to 1200. the prepared silicon nitride samples are tested by xps ( x - ray photoelectron spectroscopy ), sem ( scanning electron microscopy ), optical microscopy, xrd ( x - ray diffraction ) and edx ( energy dispersive x - ray analysis )

    通過矽片在800到1200各個溫度和各種氮氣氣氛下的氮化處理的實驗結果，報道了不同與其他研究者的氮化條件，矽片在氮氣保護的熱處理中的氮化條件為：高於1100的溫度和高純氮的氣氛條件，同時對該氮化硅薄膜進行了金相顯微鏡、掃描電鏡（ sem ） 、 x射線衍射儀（ xrd ） 、 x射線光電子譜（ xps ） 、 x射線能譜儀（ edx ）和抗氧化性等測試和分析。
  9. Encapsulating materials of epoxy resin are modified with hgh, nano - sio2 and organophilic montmorillonite, in the present investigation, the microstructue, some properties and influence factors about nano - sio2 and organophilic montmorillonite modified encapsulatig materials have been systematically studied using x - ray diffraction, electron microscopy and differential thermal analysis measurement techniques

    隨著航空、電子等事業的發展，灌封器件的高性能化對灌封材料提出了越來越高的要求。探索制備環氧灌封材料的新方法，尋求提高其使用性能的有效途徑是該領域研究的重要課題。
  10. Furthermore, in vitro studies including x - ray powder diffraction ( xrd ), scanning electron microscopy ( sem ), surface area analysis ( bet ), and dissolution were performed to determine differences between low potency ( completely miscible ) and high potency ( partially miscible ) compositions

    此外，通過粉末x -射線衍射（ xrd ） ，電子顯微鏡掃描檢查，表面積分析（ bet ）和溶出度等體外實驗來確定低效（完全混合）和高效（部分混合）組分間的差異。
  11. According to the significant improvement in properties of ions and particles doped perovskite, tb and cnt doped pt materials were prepared, and the properties studied. tb and cnt doped pt powders and films were successfully prepared by sol - gel method. by differential thermal analysis ( dta ), scanning electron microscopy ( sem ), transmission electron microscopy ( tem ), x - ray diffraction ( xrd ), fluorescent analysis and dielectric constant analysis, the morphology and phase transformation, crystalline properties, fluorescent properties and dielectric properties of the materials were studied

    本研究中採用溶膠凝膠法制備了具有優良結晶性能的稀土離子tb及納米碳管摻雜的鈦酸鉛（ pt ）超細粉末和（ 100 ）取向生長的薄膜，並利用差熱分析、掃描電子顯微鏡、透射電子顯微鏡、 x射線衍射、熒光分析和介電常數等多種分析測試手段對摻雜后的pt薄膜及超細粉末的相結構、光學性能、結晶性能以及介電常數等進行了研究。
分享友人
分享到 Line

分享到臉書