互阻放大器 的英文怎麼說

中文拼音 [hùzǔfàngdàqì]
互阻放大器 英文
tia
  • 互 : 代詞（相互;彼此） each other; mutual
  • 阻 : 動詞（阻擋; 阻礙） block; hinder; impede; obstruct
  • 放 : releaseset freelet go
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 放大器 : amplifier; pantograph; lawnmower; enlarger; magnifier
  • 放大 : amplify; magnify; boost; enlarge; blow up; gain; amplification; enhancement; multiplication; magn...
  1. The exportation resistance of a device work device with what link after loading the resistance s the certain connections for should satisfying, in order to prevent mount to load the appearance produce the obvious influence. with each other connect to say to electronics equipments, for example after signal connect the enlarger, ex - class to connect class, only behind first - degree importation resistance before larger than first - degree exportation resistance 5 - 10 times are above, can think the resistance to match good ; connect the box come saying, electronics tube the machine should choose to use with for the enlarger its output to carry the mark to call the resistance the box for, but transistor enlarger then have noing this restrict, can take officing why resistance of equal or approximate box

    一件器材的輸出阻抗和所連接的負載阻抗之間所應滿足的某種關系，以免接上負載后對器材本身的工作狀態產生明顯的影響。對電子設備互連來說，例如信號源連放大器，前級連后級，只要后一級的輸入阻抗大於前一級的輸出阻抗5 - 10倍以上，就可認為阻抗匹配良好對于放大器連接音箱來說，電子管機應選用與其輸出端標稱阻抗相等或接近的音箱，而晶體管放大器則無此限制，可以接任何阻抗的音箱。
  2. The basic principle, main properties, typical parameters, technical characteristics and general situation of klystron are introduced. the electron beam prebunching in the modulated cavity and shift tube of relativistic klystron amplifer ( rka ) is studied analytically, a self - consistent equation of radiation generated by the prebunched electron beam in the radiation cavity is derived using the field method of particle ? wave interaction instead of the electrical circuit method, and in terms of it, the gain in the linear regime calculated, a field analysis method is proposed. the theory analysis shows that the characteristic parameters, such as resonance frequency, real part of gap - impedance, external quality fadtor in all kinds of klystron output circuits including single - beam, multi - beam, single - gap, multi - gap, single - beammulti - gap, multi - beam multi - gap klystron output circuit, can be calculated by the field analysis method

    本文系統的介紹了速調管的工作原理、主要特點、發展概況、主要性能指標和技術特點，解析的研究了電子束在相對論速調管放大器的調制腔和漂移管中的預群聚;用粒子波互作用的場方法導出了在輻射腔中預群聚電子束產生輻射的自洽方程，同時對線性區的增益進行了計算。理論分析表明，場分析法可用於計算單注單間隙、多注多間隙、單注多間隙和多注多間隙速調管輸出迴路的諧振頻率、間隙阻抗實部和外觀品質因數等特性參數。
  3. The thesis has done the widespread investigation and study to the domestic and foreign ’ s technologies of analogy low voltage and low power, and analyzes the principles of work, merts and shortcomings of these technologies, based on the absorption of these technologies, it designs a 1. 5v low power rail - to - rail cmos operational amplifier. when designing input stage, in order to enable the input common mode voltage range to achieve rail - to - rail, it does not use the traditional differential input pair, but use the nmos tube and the pmos tube parallel supplementary differential input pair to the structure, and uses the proportional current mirror technology to realize the constant transconductance of input stage. in the middle gain stage design, the current mirror load does not use the traditional standard cascode structure, but uses the low voltage, wide - swing casecode structure which is suitable to work in low voltage. when designing output stage, in order to enhance the efficiency, it uses the push - pull common source stage amplifier as the output stage, the output voltage swing basically reached rail - to - rail. the thesis changes the design of the traditional normal source based on the operational amplifier, uses the differential amplifier with current mirror load to design a normal current source. the normal current source provides the stable bias current and the bias voltage to the operational amplifier, so the stability of operational amplifier is guaranteed. the thesis uses the miller compensate technology with a adjusting zero resistance to compensate the operational amplifier

    本論文對國內外的模擬低電壓低功耗技術做了廣泛的調查研究，分析了這些技術的工作原理和優缺點，在吸收這些技術成果基礎上設計了一個1 . 5v低功耗軌至軌cmos運算放大器。在設計輸入級時，為了使輸入共模電壓范圍達到軌至軌，不是採用傳統的差動輸入結構，而是採用了nmos管和pmos管並聯的互補差動輸入對結構，並採用成比例的電流鏡技術實現了輸入級跨導的恆定;在中間增益級設計中，電流鏡負載並不是採用傳統的標準共源共柵結構，而是採用了適合在低壓工作的低壓寬擺幅共源共柵結構;在輸出級設計時，為了提高效率，採用了推挽共源級放大器作為輸出級，輸出電壓擺幅基本上達到了軌至軌;本論文改變傳統基準源基於運放的設計，採用了帶電流鏡負載的差分放大器設計了一個基準電流源，給運放提供穩定的偏置電流和偏置電壓，保證了運放的穩定性;並採用了帶調零電阻的密勒補償技術對運放進行頻率補償。
  4. A nearly ideal cmos transresistance amplifier

    互阻放大器
  5. The complementary high impedance iutputs are suitable for driving transmission lines directly or connecting a omp to bring low impedance outputs

    互補的高阻抗電流輸出適合直接驅動傳輸線或帶一個外部運算放大器以產生低阻抗輸出電壓。
分享友人
分享到 Line

分享到臉書