側滑軸 的英文怎麼說

中文拼音 [zhāizhóu]
側滑軸 英文
axis of sideslip
  • : 側形容詞[方言] (傾斜; 不正) slant; sloping
  • : Ⅰ形容詞1 (光滑; 滑溜) slippery; smooth 2 (油滑; 狡詐) cunning; crafty; slippery Ⅱ動詞(貼著物...
  • : 軸Ⅰ名詞1. (圓柱形的零件) axle; shaft 2. (對稱部分的直線) axis 3. (圓柱形的纏繞器物) roller; spool Ⅱ量詞(用於纏在軸上的線以及裝裱帶軸子的字畫)
  1. Two joint ouboard slip drive shaft

    兩萬向節外動傳動
  2. The influence of such parameters as axial load index, aspect ratio and percentages of lateral reinforcement, on seismic performance of reinforced concrete frame column in hong kong and analyses the distribution relationships of flexural deformation, shear deformation and slippage of longitudinal reinforcement in joint zone

    根據試驗結果,討論了壓比、配箍率、剪跨比等參數對其抗震性能的影響,分析了水平荷載作用時塑性鉸區的彎曲變形、剪切變形和縱向鋼筋粘結移變形所產生的位移在框架柱總水平移中所佔的比例及其變化規律。
  3. Lastly, two axially loaded bored piles in some building site near xichang city was calculated with the method and some useful data and curves including load - settlement curves and distribution of friction resistance etc. are presented. the accordance between the results of calculation and in - situ test verifies the validity of the method developed in the paper

    通過計算,得到相應的荷載?沉降曲線、力圖、樁阻力圖、塑性區、土的豎向位移等值線、樁的移過程等結果,並與現場試驗結果吻合較好,說明用本文方法計算分析樁基的工作特性是可行和有效的。
  4. Based on the improved codog power plant experiment rig of harbin engineering university, the thesis has set up the displacement measurement system of the middle slippage of the synchronous self shifting ( s. s. s. ) clutch at the first time, and obtained the curve which follows the time variability of the axial displacement when engaging or disengaging and reflects the dynamic change of the s. s. s. clutch for the main engine changeover of codog power plant experiment rig

    本文的研究是建立在對我校原有codog物理模擬實驗臺改進的基礎上進行的,首次建立了三s離合器中間移件位移測量系統,獲得了三s離合器中間移件在嚙合及脫開過程中的向位移隨時間的動態變化曲線,該曲線從一個面反映了切換過程中三s離合器的動態變化。
  5. Pedestal plain bearings - specification for side flange bearings

    托架承.邊法蘭承規范
  6. L - shovels were made by stainless steel, their opening / closing action was aetuated by pneumatic cylinders. precision linear bearing were adopted for sliding parts

    堆垛機兩l形料鏟採用不? ? ? ,料鏟開合均由氣缸帶動,其動部位採用精密直線承。
分享友人