共變函子 的英文怎麼說
中文拼音 [gòngbiànhánzi]
共變函子
英文
covariant functor-
Also, the author ’ s design strategy and creativity has been given in this paper. specifically, it includes : based on the feasibility analysis of the fit selection of control parameters in the aeration process, the aeration process of wastewater treatment of the joint - constructional complete - mixed activated sludge process has been aimed at in this paper. then, the state equations of the aeration process have been proposed in this paper, which is on the base of dissolved oxygen concentration ( do ) and discharge quantity of sludge ( qw ) as control variables, the concentration of bod and sludge as state variables. based on the present study on optimization control of wastewater treatment, the multivariable optimal control model with restriction factor has been presented in the paper with introducing modern control theory and system analysis into the field of activated sludge wastewater treatment,
具體包括:以完全混合、表面曝氣合建式活性污泥工藝的污水處理曝氣過程為研究對象，在闡述了曝氣過程式控制制參數選取可行性的基礎上，建立了以溶解氧濃度do和活性污泥排放量qw為控制變量，以曝氣池中有機物濃度s和微生物濃度x為狀態變量的活性污泥曝氣過程的基本狀態方程;運用現代控制理論的觀點和污水處理理論，在現有關于污水處理最優控制問題研究的基礎上，建立了有約束條件多變量能耗最小數學模型，該數學模型是以有機物排放總量和狀態變量的末值條件作為約束條件，曝氣過程的能耗最小作為目標泛函;採用增廣拉格朗日乘子法對最優控制問題進行轉化，並對應用極大值原理求解能耗最小這一最優控制問題進行了詳細的解析;引入約束運算元，應用具有控制約束的共軛梯度演算法對能耗最小這一最優控制問題進行求解，並進行模擬實驗驗證。Fluorescence power transfer function, three - dimensional point spread function ( 3d - psf ) and three - dimensional optical transfer function ( sd - otf ) for the various fluorescent wavelength of the two kinds of fluorescence confocal scanning microscopy are calculated in this paper by using fourier imaging theory. the results show that the fluorescent wavelength has influence on imaging property of confocal microscopy such as spatial cut - off frequency, resolution and 3d - otf. there is a different missing - cone in the 3 - d space of otf when the ratio of excitation wavelength to fluorescent wavelength decreases
本文在sheppard和gumin等人的理論基礎上，利用fourier光學成像理論，討論了不同熒光波長對單光子和雙光子共焦顯微鏡成像特性的影響，導出了單光子和雙光子共焦顯微鏡的熒光功率傳輸函數、三維脈沖響應函數和三維光學傳遞函數，得到了它們在不同激發波長與熒光波長比值時具體的表達式，並且通過數值計算，得到了它們的曲線圖，結果表明：隨著激發波長與熒光波長比值的增加，焦斑的橫向分佈和縱向分佈變窄，橫向解析度和縱向解析度提高，系統的成像效果變好，當激發波長與熒光波長的比值下降到一定程度時，可以看到不同程度的失錐現象。A full mathematical model of optimal flow pattern design withengineering constraints was put forward, based on modern optimal control theory. an optimal flow pattern design was presented for optimizing meridional channel of axial flow turbine. according to integral optimization of turbine stages, a full physical model and mathematical expression were put forward for proposition of optimal flow pattern, including all performance parameters in turbine stages. this problem was further recast into a typical form control to maximize specific performance index such as work or efficiency of stage with given initial state, fixed terminal condition and constraints for part of state terminal variables. the program was also worked out according penalty function method and conjugate gradient method. the optimal distribution of c1ur1 ( r1 ) was obtained according to constraint conditions and maximized objective function
把近代最優控制論方法引入軸流透平葉片的設計，在優化的軸流透平子午通道內，建立包括透平級內所有性能參量的最優流型命題的完整的物理模型及其數學表達式，並歸化為一個在給定初始狀態、自變量終端固定、部分狀態變量終端受有約束的條件下，使級的某一性能指標（如級的功率）達到最優的最優控制問題，應用「代價函數法」及「共軛梯度法」編制計算程序，計算得到符合給定約束條件、並使目標函數取極值的最優環量分佈，結果是令人滿意的。According to the relationship between material fatigue performance curve and concerned parameters in fracture mechanics, the relationship between fatigue life and crack half length is obtained, that is equivalent crack length of fatigue life. the function relationships between these two aspects are constructed. the experiment data show that this method can express the same character of fatigue life of all kinds of materials and experiment data acquired from different materials can be used each other
通過材料力學疲勞性能曲線和斷裂力學之間有關參量間的演變關系，得到了疲勞壽命與裂紋半長的關系，即疲勞壽命的折算裂紋長度，建立了兩者之間的函數關系並利用這個函數關系說明了疲勞壽命的切線模量因子法，能反映各種材料疲勞壽命的共同變化規律，試驗數據可在不同材料之間互相參考使用，具有重大意義。分享友人