函式運行時間 的英文怎麼說

中文拼音 [hánshìyùnhángshíjiān]
函式運行時間 英文
function timing
  • 函 : 名詞1. [書面語] （匣; 封套） case; envelope 2. （信件） letter 3. （姓氏） a surname
  • 式 : 名詞1 （樣式） type; style 2 （格式） pattern; form 3 （儀式; 典禮） ceremony; ritual 4 （自然科...
  • 運 : Ⅰ動詞1 （物體位置不斷變化） move; revolve 2 （搬運; 運輸） carry; transport 3 （運用） use; wield...
  • 行 : 行Ⅰ名詞1 （行列） line; row 2 （排行） seniority among brothers and sisters:你行幾? 我行三。where...
  • 時 : shí］Ⅰ名1 （比較長的一段時間）time; times; days:當時at that time; in those days; 古時 ancient tim...
  • 間 : 間Ⅰ名詞1 （中間） between; among 2 （一定的空間或時間里） with a definite time or space 3 （一間...
  • 運行 : move; be in motion; run; working; machine run; operation; corotation; propulsion （影片）
  • 時間 : time; hour; 北京時間十九點整19 hours beijing time; 上課時間school hours; 時間與空間 time and spac...
  1. This text completely and systematically studies the status and the development of the pyrolysis and the fluidization of biomass, which distill the bio - oil in the domestic and international area, as well as the existing problems. this thesis primarily include following aspects : ( l ), by experimenting and measuring the energy ( heat value ) and the content of c, h, n chemical element of right 20 kinds of common biomass, on the base of the experimental result, and respectively established the biomass energy predict experiment formula with the element of h and c is from change, and passed the ro. os examination, which provides the basis and convenience for flash pyrolysis fluidization device energy to convert the rate to compute with biomass energy utilization calculation ; ( 2 ), proceeded the tg and dtg experimentation equal velocity ( 10 ? / min, 20 ? / min, 40 ? / min, 60 ? / min ) heating and constant temperature heating by studying on eight kinds of biomass samples, according to the experimental data and arrhenius formula, we established the dynamics model of pyrolysis of, then, using the goast - redfern and p function, we also solved the dynamics parameters and analyze out every kind of biomass ' s frequency factor and parameters of activation energy, and established the every kind of dynamics model of pyrolysis of biomass, all of these provide the theories and basis to make sure the reactor ' s flash pyrolysis work temperature scope design and the describing of pyrolysis reactor dynamics ; ( 3 ), in order to study and ascertain the process of heat completely getting to pyrolysis time of varied size biomass particles, we observed and measured the ratio of length and diameter ( l / d ) with the varied biomass through electron microscope, we concluded the l / d ratios usually is from 5. 0 to 6. 0, the average is 5. 3 ; ( 4 ), we studied the process of biomass transiting and the theory of complete pyrolysis time with the theory of complicated heat field, we got the time ( t ) of the varied size biomass particles arriving to complete pyrolysis, and we knew that the complete pyrolysis time and the time which get to the biggest production ratio are identical, all of these studies provide the theory base for design and forecasting the flash pyrolysis reactor solid state resort time ; ( 5 ), according to the above experiment result, synthesize to make use of the engineering the mechanics, engineering the material, machine the design to learn the principle, deduce, establish the theory of rotation cone flash pyrolysis reactor material resort time ( t ) and reasonable rotation velocity ( or frequency ) relation theory ; and ( 6 ), we gave the reactor ' s smallest cone angle certain, reactor cone wall strength design theory, the reactor production ability theory, the power design method and the critical rotation velocity theory

    本文較全面、系統地綜述了國內外生物質熱解液化制取生物燃油技術研究發展現狀及存在的問題，主要研究內容有： （ 1 ）實驗、測定了20種常見生物質的能量（發熱量）和c 、 h 、 n元素含量，根據實驗結果分別建立了以h和c為自變量的生物質能量預測經驗公式，並通過r _ （ 0 . 05 ）檢驗；為閃速熱解液化裝置能量轉化率計算和生物質能量利用率計算提供了依據和方便； （ 2 ）選擇了8種生物質試樣作了等加熱速率（ 10 min 、 20 min 、 40 min 、 60 min ）和恆溫加熱的tg和dtg實驗，根據實驗數據和阿倫尼烏斯公式建立了生物質熱解反應動力學微分方程，並採用goast - redfem積分法和p函數對其動力學參數進行了求解，解析出各種生物質的頻率因子和活化能參數，進而建立了各種生物質的熱解動力學模型，為科學確定反應器的閃速熱解工作溫度范圍及熱解反應動力學描述，提供了理論和依據； （ 3 ）為研究和確定不同尺度的生物質顆粒中心達到全熱解的時間，在體視顯微鏡下對不同粒度的生物質顆粒的長徑比進行了實驗觀察和測定，得出生物質的長徑比（ l d ）一般在5 . 0 6 . 0之間，平均為5 . 3的結果； （ 4 ）採用復雜溫度場傳熱學理論對生物質傳熱過程及充分熱解時間理論進行了研究，解析推導出了不同尺寸生物質顆粒中心溫度達到充分熱解溫度的時間（ t ） ，得出了理論推導的充分熱解時間與最大產油率的熱解時間相一致的結果，為閃速熱解反應器固相滯留時間設計和預測提供了理論依據； （ 5 ）根據上述實驗結果，綜合運用工程力學、工程材料、機械設計學原理，推導、建立了轉錐式閃速熱解反應器物料滯留時間（ ）與轉速（或頻率）合理匹配理論； （ 6 ）提出了轉錐式閃速熱解反應器的最小錐角設計、錐壁強度設計、生產能力設計理論和功率計算方法及臨界轉速理論等。
  2. The engendering source of traffic volumes and their general influential factors have been presented, and the situation of nowadays highway transportation has been discussed. according to the introduction of traffic distribution theory and classical assignment method, analysis of traffic flow path selection among cities and that of special influential factors for traffic flow on toll highways, initial analysis to the forming mechanism of traffic volume on road sections has been made, and a probability model for path selection has been set up with the maximum - utility theory and disaggregating model. detailed analysis to impedances on road sections and their functions ( especially to three main composing factors of the impedances as cost of time, transport and toll and to the functional relations with traffic loads ) was made, at the same time, the relative cost calculating model was set up on the basis of the state - of - art achievements in both international and national researches

    主要研究內容包括：交通量的產生根源及一般影響因素分析和當前公路運輸地位討論；從交通分配理論及經典配流方法著手，通過分析城市間交通流路徑選擇行為和收費公路路段交通量特殊影響因素，初步提出路段交通量的形成機理，並採用效用極大原理和非集結模型理論（ disaggregationmodel ） ，建立用戶出行路徑選擇概率模型；對路段阻抗及路阻函數（尤其對行程時間費用、車輛營運費用和道路收費這三個構成路段阻抗的主要因素及其與交通負荷間的函數關系）進行較為詳盡的分析，並以現階段國內外較為先進的研究成果為依據建立相應的成本測算模型，其中，特別提出了兩種確定客貨車輛時間價值的分析方法；離散分析法和時間-費率轉換法，後者是在目前基礎調查、統計數據資料不夠齊全的現實下提出的一種確定道路系統內務車型時間價值的較為實用的新方法；對我國公路收費政策的背景和理論、實踐依據及費率的各種影響因素進行重點分析；從數學的角度證明合理費率的存在性，並以最優化理論為基礎，建立在普通收費公路和擁擠路段交通調控型收費公路兩種模式下合理費率的計算模型等。
  3. Existent automatic grading model of programs can not deal with the programs with structural body. in this paper, we study the syntax and concept of structural body based on an existed model, and improve the original model in the following aspects : increasing the middle representation form of structural body in analysis of morphology and syntax and system dependence graph and abstract syntax tree, adding standardization rules, mainly including type definition, nesting structure, initialization, function invocation, renaming and sequence of program sentence, besides standardization rules of bit operation and program with enumeration, enhancing the function of inspecting syntax error and improving matching strategies

    本文在原有的編程題自動評分模型的基礎上，對結構體的語法結構和實現原理進行研究，並在以下幾個方面完善原有模型:在詞法和語法分析、程序的系統依賴圖建立和抽象語法樹生成三個方面增加結構體類型的中間表示形式;擴充程序的標準化規則，主要包括類型定義標準化、結構體嵌套結構標準化、結構體初始化的標準化、結構體作為函數參數時函數調用標準化、結構體變量名稱標準化、結構體語句排列順序標準化等等;另外，還增加了位運算標準化、枚舉標準化以及文件的處理;增強學生程序中語法錯誤的檢測和改進程序匹配策略。
  4. Furthermore, combined the execution rule of petri nets and the search algorithms of tree, an innovative scheduling method is proposed by applying a heuristic search to the state space of petri nets. specially, by introducing heuristic function, depth - first and width - first is mixed in the search course ; thereby a feasible solution can be generated in a reasonable amount of time

    其次，在所得柔性製造系統petri網模型的基礎上，通過把樹的遍歷演算法與petri網的運行規則相結合，提出了一種啟發式調度演算法，通過在演算法中引入反映問題特徵的啟發函數，把廣度優先和深度優先搜索有機地結合，使得該演算法能夠在合理的時間復雜度內得到滿足精度要求的優化調度。
  5. Layout input pole length ' s locus when the mechanism follows kadang movement in two ways. one is multinomial curve locus and the other is linearity intermixed by parabola curve locus. we study the displacement > velocity and acceleration curve consulting time under variety velocity characters, and get the best curve and the best velocity character, which will have a very important significance for kadang movement ' s input control of this mechanism

    對卡當運動輸入桿件的伸長進行了軌跡規劃，採用了多項式與混有拋物線的線性函數作為規劃軌跡，研究了不同速度參數條件下的位移、速度、加速度的時間變化曲線，給出了最優曲線和最優速度，這對于機構卡當運動輸入控制的實現和優化具有重要意義。
  6. Date and time functions are evaluated at run time and provide the updated values to property expressions

    日期和時間函數在運行時計算，並將更新后的值提供給屬性表達式。
分享友人
分享到 Line

分享到臉書