噴嘴面積 的英文怎麼說

中文拼音 [pēnzuǐmiànjī]
噴嘴面積 英文
jet area
  • 噴 : 噴動詞1. （液體等受壓力而射出） spurt; spout; gush; jet 2. （噴灑） spray; sprinkle
  • 嘴 : 名詞1. （口的通稱） mouth 2. （形狀或作用像嘴的東西） anything shaped or functioning like a mouth 3. （指說話） talk; speak
  • 面 : Ⅰ名詞1 （頭的前部; 臉） face 2 （物體的表面） surface; top 3 （外露的一層或正面） outside; the ri...
  • 積 : Ⅰ動詞（積累） amass; store up; accumulate Ⅱ形容詞（長時間積累下來的） long standing; long pending...
  • 面積 : [數學] area
  1. The nozzle diameter and the ejection pressure have a great effect on the flow rate 、 droplet cone shape 、 droplet size and cover area of fluid pesticide

    噴嘴孔徑和噴出壓力在很大程度上影響著藥液的流量特性、霧錐形狀、霧滴大小和覆蓋面積。
  2. According to the experimental data of droplet size 、 particle spectrum range 、 droplet cone shape 、 flow rate 、 cover area and cover area rate which obtained through changing the pressure of power sprayer and the nozzle diameter in greenhouse ， this paper made comparative analysis on atomizing performance in same pressure and different nozzle type between same nozzle type and different pressure. the conclusion is that : the ejection rate and the droplet cone shape change with the variation of pressure and nozzle diameter ， average particle diameter decreases obviously and particle quantity increases obviously with the increase of pressure and decrease of nozzle diameter. these results will lay experimental foundation for precise spraying 、 low pollution and highly effective operation

    本文根據溫室內動力噴霧機壓力與噴嘴孔徑的變化影響霧滴大小、粒譜范圍、霧錐形狀、流量、覆蓋面積及覆蓋面積率的試驗數據，對相同壓力下不同噴嘴型號和相同噴嘴型號時壓力不同時的微粒化性能進行對比分析和研究，得到如下結論噴出量與霧錐形狀隨著壓力和噴嘴孔徑大小變化而變化；平均粒徑隨著壓力的增加和噴嘴孔徑的減小而明顯減小；粒數隨著壓力的增加和噴嘴孔徑的減小而明顯增多，為精噴量、低污染、高防效的防除作業奠定了實驗基礎。
  3. This paper has analyzed and synthesized the problems of burning heavy viscosity petroleum about injecting steam boilers in liaohe oil field. the heat balance experiments on injecting steam boilers burning heavy viscosity petroleum is made first. the main causes of low thermal efficiency and heat lose of flue gas are the poor effect of atomization and burning with old - fashioned oil nozzles, worse ash gathered on. heat exchange surface and high temperature of flue gas

    本論文在分析綜述了遼河油田注汽鍋爐燃用高粘度稠油時存在的問題的基礎上，首先對燃用稠油的注汽鍋爐進行了正、反熱平衡試驗，分析了注汽爐熱效率偏低、排煙熱損失偏高的主要原因是原噴油嘴改燒高粘度稠油時霧化和燃燒效果差、換熱面積灰嚴重、排煙溫度太高。
  4. This unit utilizes a unique spray nozzle and a high - speed rotary plate ( centrifugal model ) to granulate fluid ( starchy materials ), and sprays hot air to instantly dry the granules as their surface areas are being increased

    利用特殊噴嘴或者是高速旋轉圓盤（離心式）將漿料球粒化，並再它表面積增大時，施以連續熱風，使其與熱風接觸后瞬間乾燥。
  5. A laboratory - scale gasoline injector deposit simulator was developed to simulate deposit formation, and the fourier transform infrared ( ftir ) technique was used to analyze the deposit formation mechanism under various wall temperature

    摘要建立了實驗室尺度的沉積物生成模擬裝置，並嘗試以ftir傅里葉轉換紅外線光譜法分析沉積物生成的化學機理，以探討不同壁面溫度下的噴嘴沉積物生成過程。
分享友人
分享到 Line

分享到臉書