均方根電流 的英文怎麼說

中文拼音 [jūnfānggēndiànliú]
均方根電流 英文
rms current
  • 均 : Ⅰ形容詞（均勻） equal; even Ⅱ副詞（都; 全） without exception; all
  • 方 : Ⅰ名詞1 （方形; 方體） square 2 [數學] （乘方） involution; power 3 （方向） direction 4 （方面） ...
  • 根 : Ⅰ名詞1 （植物的營養器官） root （of a plant） 2 （比喻子孫後代） descendants; posterity 3 [數學] ...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 方根 : nth root
  • 電流 : current; galvanic current; electric current; electricity; current flow電流保護裝置 current protec...
  1. Static ir drop analysis is based on the average current of the devices. according to different ways of current extraction, static ir drop analysis can be categorized into two major types : area based ir drop analysis and activity based ir drop analysis

    靜態irdrop分析是以器件的平均電流為基礎的，根據器件電流提取方式的不同又可分為基於面積的irdrop分析和基於活動率的irdrop分析兩種。
  2. A method of fuzzy optimization design based on genetic algorithm is presented as a new method of parameter optimization design for dc double closed loop speed adjusting system. the method covers three steps. firstly, speed overshoot rate and settling time are chosen as performance indice according to the demand of engineering. these indice are normalized by using fuzzy membership function and then weighted to form objective function of optimization model of the system. secondly, the dynamic response curve of the system with corresponding parameters and peoformance indice are obtained by computerized numerical calculation and simulation. finally, parameters of engineering design are expanded as searching space ; and parameters of speed regulator and current regulator are taken as genes in chromosome. these genes in searching space are optimized to get best solution by way of genetic algorithm. as shown by experimental results, the parameters designed by this method are capable of significantly improving performance indice of the system, which proves that it is a practical and effective method

    提出一種基於遺傳演算法的直流雙閉環調速系統參數優化設計方法.根據工程技術的要求，選用速度超調量和過渡時間作為參數優化性能指標.將該指標用模糊隸屬度函數歸一化，再加權平均形成系統優化模型的目標函數.採用計算機數值計算方法，通過模擬獲得系統對應參數的動態響應曲線及其性能指標.最後以工程設計的參數為搜索范圍，以速度調節器和電流調節器的參數為染色體中的基因，通過遺傳演算法在搜索范圍中優化這些基因，獲得優化解.實驗結果表明，所設計的參數能使系統性能指標有顯著提高
  3. In order to make the sensitivity of 2 - demension accelerometer along the two main arbors almost identical, symmetric four - beam structure that embeds a double - sides interdigitated differential capacitive with puckered beam in two directions was used as sensitive component. in addition, the differential capacitive accelerometer fabricated by bulky silicon micromechanical technique has high sensitivity, wide measurement scope, less nonlinear error, and simple converting circuit. then, the structure parameters of the sensitive component were calculated and stimulated, which results in a set of the optimized structure design parameters, main fabrication procedure and several key fabrication technology

    為使二維振動傳感器在兩主軸方向的靈敏度大致相同，敏感元件採用高度對稱的四梁結構，其中每個軸向上均採用帶折疊梁的雙側叉指電容結構，採用體硅微機械工藝製作的高深寬比叉指電容式敏感元件，具有高靈敏度、寬量程、非線性誤差小、外圍電路簡單等優點;對設計的敏感元件結構參數進行了計算，並利用有限元法進行了模擬分析，根據模擬結果得出了優化參數;在確定敏感結構的基礎上，研究了敏感元件採用體硅微機械加工工藝製作的工藝流程和關鍵工藝技術;對敏感晶元內部的c - v介面電路進行了原理設計與分析，利用差動測量技術得到由振動引起的微小電容變化量，經c - v介面電路進行相位調制處理，然後通過解調輸出與加速度成正比的電壓信號。
  4. The design adopts ac sample method to get 3 - phase voltage and current samples. the design computes three basic electric parameters according the sample values and monitors the voltage and current of pumping machine with keyboard and lcd

    對抽油機工作電壓、電流進行數據採集，用方均根值法由交流采樣值計算三個基本電參數，並通過lcd和鍵盤進行隨時的監測。
  5. The main work and conclusion for this paper is as following : according to the flashover test results of several kinds of iced insulators under positive voltage and negative voltage, this paper obtained : for the single porcelain insulator, the single glass insulator and the composite insulator bridged completely by icicle, the metal cathode ' s strong ability of emission electron is the primary reason that results in the lower negative flashover voltage ; the position difference of the high resistance district in method anode side results in that porcelain insulator cluster and glass insulator cluster have an evident effect of polarity ; when less ice and no icicle at the brim of the sheds, due to numerous non - polar arcs on the composite surface, the effects of polarity of composite insulator was lost using the test method of the average flashover voltage in the freezing period, dc flashover performances were investigated of several insulators with some typical structures and different material

    本文的主要工作和結論如下：在人工氣候室內，根據不同覆冰絕緣子正、負極性下的閃絡試驗結果，得出負極性電弧金屬陰極的強電子發射能力造成了單片瓷、玻璃絕緣子及被冰凌橋接的合成絕緣子有較低負極性冰閃電壓；正極性電弧金屬陽極側產生高電阻區所處位置的差異使得瓷和玻璃絕緣子串具有明顯的極性效應；覆冰較少時，合成絕緣子表面出現數量較多的非極性電弧使合成絕緣子無極性效應。利用覆冰期內平均閃絡電壓的試驗方法，對不同材質和結構的絕緣子在覆冰、低氣壓和污穢共存環境中的直流閃絡特性進行了研究。試驗結果表明，直流平均閃絡電壓隨著海拔的升高、覆冰量的增加以及污穢度的增加而降低，且其特徵指數與絕緣子結構、覆冰量、覆冰狀態、污穢度等有關。
  6. Ratio of peak lamp current to rms or average lamp operating current

    燈電流峰值與rms （均方根值）或平均工作電流的比值。
  7. Organic - inorganic nanocomposite, which are the complex of inorganic nanopraticles with organic compound, is a popular study subject in nanoscale composite. the nanocomposite can not only take advantage of several advantage, but also produce new properties. in this thesis, taking account of the problems in electrorheological fluids such as high leakage current, low yield stress and stability, the pan - batio3 nanocomposite with different structure are prepared by in - situ complex technology and modified sol - gel method

    根據目前電流變液中出現的問題（如屈服應力不夠高，漏電流密度不夠低，穩定性不夠好等問題） ，基於聚苯胺有較高的熱穩定性，且密度又小，特別是聚苯胺的介電常數和電導率均可按需調整，此外，鈦酸鋇無機納米粒子作為一種無機鐵電體，在電場作用下具有自發極化的能力，一方面可以為體系提供高的介電常數，另一方面又可保證體系的絕緣性能。
  8. The material ways are to model the honeycomb wall as an impredence surface, to express the infinite honeycomb by using periodic green ' s function, and using method of moment to establish the mathematic model, in applying the methods of moments, we choose the roof function as basic function and choose the razor function as test function ; by equating the incident field to sum of the scattering field and impledance field ; we will set up the integral equation for the surface current, solving it by mom equation. then gain it ' s reflected coefficient ' s numerical result. and we propose first the definition of the equivalent electromagnetic parameters and present a method to calculate them from the gained reflection coefficient

    具體方法就是將浸漬吸收劑的蜂窩壁用表面阻抗表示，將無限大的周期結構的電場用周期格林函數來表示，選取有耗蜂窩結構中具有代表性的基本計算單元應用矩量法建立數學模型，在運用矩量法時用屋頂函數作為基函數，刀片函數作為檢驗函數，根據蜂窩壁表面電場必須滿足入射電場等於散射電場和阻抗電場之和的規律，推導表面電場積分方程，求解蜂窩結構的表面電流，利用蜂窩的周期規律得到無限大均勻周期陣列的散射電場。
  9. Withstanding voltage testers the laboratory offers calibration for withstanding voltage testers with sinusoidal output voltages ( 50 hz ) not exceeding 11 kv ( r. m. s

    本所為輸出正弦電壓50hz不超過11kv均方根值的交流耐壓測試器提供校正服務。
  10. Such a motor can produce a transient overvoltage, reaching many thousands of volts, when the normal rms current is interrupted

    當通常的均方根電流被打斷，這樣的一個電機可以產生一個可達幾千伏的電涌過壓。
  11. These transient amplitudes depend on the rms current interrupted, the point on the sine wave when the interruption occurred, the speed of the disconnection etc

    這些電涌的幅值取決于中斷電流的均方根值、中斷發生時在正弦波上所處的點、中斷的速度等。
  12. Based on experimental results, this paper came up with a method to estimate the average dynamic power supply current by counting the weighting logical transitions in the circuit

    根據實驗結果，本文提出一種根據cmos電路中加權邏輯跳變數來估計整個電路平均動態電流大小的方法。
  13. Considering the unsymmetrical distribution of interface states induced by hot - carrier effects along the channel, the quasi - two - dimensional analysis methods are used to deduced the drain current, threshold voltage and electrical field in channel after hot - carrier degradation and the theoretical results are fully verified with the experimental data and m1ntmos6. 0 simulation output. the degradations of device output conductance, subthreshold conduction and rf characteristics are also analyzed

    針對mos器件熱載流子退化所引入的界面態，根據其沿溝道非均勻分佈的模型，採用準二維分析方法對退化后器件的漏源電流、閾值電壓和飽和區溝道電場作了詳細的理論推導，並與實驗結果和器件二維數值模擬軟體minimos6 . 0的計算結果進行了驗證比較。
  14. The visualization of representative day ( root mean square current, average current and equivalence resistance algorithms ) and allot load according to transform capacity method are realized

    實現了代表日方法（包括均方根電流法、平均電流法和等值電阻法等演算法）和按配變容量比例分配負荷的方法的可視化。
  15. Constant current rms

    固定電流均方根
  16. True rms ac voltage

    交流均方根電壓
分享友人
分享到 Line

分享到臉書