坡口組對 的英文怎麼說
中文拼音 [pōkǒuzǔduì]
坡口組對
英文
fit-up-
As one kind of key equipment in piping work of large - scale turbo - generator set in power plant, the machine is especially applicable to various welding bevels, flat end and angle of outer & inner diameter of ascending pipe, elbow pipe, bend, flange and etc., which greatly meets demands in pipe processing of construction site and manufacturers
本機床是電站大型汽輪發電機組的管道施工的關鍵設備,對直管、彎管、彎頭、法蘭等管體的各種型式焊接坡口,端平面,內外徑過緩斜度及直口,能滿足施工現場和製造廠家對各種管件的加工要求。3 ) the combination of alike corners, radiuses and bottoms with different border coefficients. 4 ) the contrast between the conditions with exit incline ridge and the one without it. 5 ) the contrast between the conditions with entrance ridge and the one without it
L )不同轉角,曲率半徑和底坡組合; 2 )相同轉角和曲率半徑,不同底坡的組合; 3 )才目同轉角,曲率半徑和底坡,不同邊坡系數的組合; 4 )有無出口斜坎的對比; 5 )有無進口坎的對比; 6 )不同坎高的對比。The geomorphological instantaneous unit hydrograph ( giuh ) is viewed as the frequency distribution of the times of arrival of individual water deoplets at the catchment outlet. the travel path, for a typical hillslope cell. consists of a hillslope fraction, corresponding to overland flow and a stream fraction, corresponding to concentrated channeled flow. to obtain the time of travel, velocities must be defined. hillslope and stream velocities vary with location and must be strongly correlated with slope, and therefore a spatial distribution of velocities and hence of travel times could be obtained. the present methods of giuh neglect any time delays associated with overland flow pathways
地貌單位線被看作是流域上各水質點在弱相互作用下,到達流域出口匯流時間的頻率分佈。對於一個典型的山坡型網格單元,匯流路徑由兩部分組成,即坡地部分和河道部分,為了得到匯流時間,必須首先確定匯流速度。坡地和河道的匯流速度隨著區域位置而變,並且必然與坡度有關,因此,可首先計算流速的空間分佈,進而得到匯流時間的空間分佈。“ subcontractor will be responsible for weld mapping all pressure boundary welds and attachment welds to pressure boundary pipe 。
「分包商負責將管端切削至合適的尺寸、坡口加工和組對焊接。 」Subcontractor is responsible for trimming the random ends to the correct size ( dimensions ) final fit - up, end preparation and welding
「分包商負責將管端切削至合適的尺寸、坡口加工和組對焊接。 」分享友人