外錐距 的英文怎麼說
中文拼音 [wàizhuījù]
外錐距
英文
outer cone distance-
By means of the optimization method - punishing function method and taking the sum of the planet gear radius and center distance as the target function, the parameters of drive are optimized. by using the optimization program, the initial serial studies of drive are completed, the best serial parameter value of the drive is given
採用外點罰函數優化方法,通過取行星輪半徑和中心距之和作為優化目標函數,對滾錐齒超環面行星蝸桿傳動進行了參數優化,運用此優化程序,初步完成了對該種傳動的系列化研究,給出了傳動系列的最佳參數取值。Domestic and abroad standard and test information of alimak co. for braking distance of antifalling safety device of construction hoist are analyzed. the writers study the application and inspection situation of safety device in our country and put forward a suggestion of reasonable range of braking distance for safety device with gear cone drum
本文分析了有關施工升降機防墜安全器制動距離的國內外標準條文和alimak公司的試驗資料,結合我國施工升降機防墜安全器的應用和檢測情況,提出了修改齒輪錐鼓形防墜安全器制動距離合格範圍的建議。As far as input coupling devices concerned, we design a feasible taper coupler by means of the theory of waveguide coupling and outside cavity waveguide laser and make decision of the sizes of the lens and the taper coupler, and the relative distance of them. the focus of the lens is 65mm and the radius is 5mm. the length of the taper coupler is 15mm, and the radiuses of the input and output ends separately are 17mm and 0. 65mm
在輸入耦合器方面,藉助于波導耦合和外腔式波導激光器的相關理論,設計了工藝上可行的錐型耦合器,確定了透鏡、耦合器的尺寸以及耦合器與透鏡的相對位置:耦合透鏡的焦距為65mm ,直徑為srnm ,耦合器的長度為15mm ,輸入端直徑為17mm ,輸出端直徑為0
分享友人