恆壓的 的英文怎麼說

中文拼音 [héngde]
恆壓的 英文
isobarically
  • : Ⅰ形容詞1 (永久; 持久) permanent; lasting 2 (平常; 經常) usual; common; constant Ⅱ名詞1 (恆心...
  • : 壓構詞成分。
  • : 4次方是 The fourth power of 2 is direction
  1. In this model, the resulting implosion and ensuing explosion would blow off the outer envelope of the star and leave behind the core as a neutron star.

    按此模型,引起突然縮和隨后爆發會把外部包層吹跑,留下核成為一顆中子星。
  2. Multi - mode isobaric water supply system consist of fuji vp inverter and pod

    觸摸屏多模式供水系統
  3. The life history of any star truly represents a titanic struggle between the force of gravity, and the force of gas pressure.

    任何生命史,就是一場引力和氣體力之間嚴重斗爭。
  4. For a given media, and at a constant total pressure and temperature, the partial pressure of oxygen is proportional to oxygen mole fraction

    對一個給定媒介,在和溫度下,局部力與氧克分子數成比例。
  5. Soakage of concrete and penetration length at different water pressure and pressure maintaining time are tested, and the results show that soakage at a water pressure is not linear relation with time. water soaking rate of concrete is reducing with time, and soaking mainly happens within original one hour and increases slowly in subsequent 6 hours

    通過對水法下混凝土吸水量及滲透高度與時間及水關系研究發現:混凝土在一定水力下吸水量與時間並不是線性關系,而是隨著時間變化,吸水量增長率減小,吸水量主要取決於前1h ,而在6h后增長極為緩慢。
  6. The hurricane blast of stellar winds and blistering ultravioletradiation within the cavity is now compressing the surrounding walls ofcold hydrogen. this is triggering a second stage of new star formation

    空穴中星風擊波和熾熱紫外線輻射正在縮周圍冷氫氣形成墻。由此觸發了第二階段新形成。
  7. Study on the unvarying pressure mechanism of anti - dripping valve

    防滴閥系統機理研究
  8. The fault that the series resistor has high value can be avoided by using the constant current amplifier, and the fault that the dividing resistor reduces the working voltage of the speaker can be avoided by using the constant voltage amplifier

    使用流功放,可以避免傳統方法中串聯電阻取值過大缺點;使用功放,可以消除分電阻降低揚聲器工作電不足。
  9. It is based on a constant pressure.

    它是根據得到
  10. The li - ion or li - polymer battery ic use cc / cv charging mode which includes the 3 charging stages : the trickle charging, large constant current charging and constant voltage charging

    本文設計鋰電池充電器晶元採用了恆壓的充電方法,並在此基礎上將充電過程分為三個階段:預充電、流充電和充電。
  11. In the end, the main content of this dissertation is addressed. in chapter 2, based on the analysis of present vibrator ' s principle and structure, two kinds of transfer functions and frequency response curves of the vibrator, driven by voltage feedback power amplifier and current feedback amplifier, are given separately. and turnover frequencies between different frequency rangs are also given

    第二章分析了標準振動臺工作原理和結構,在此基礎上,建立了標準振動臺機械和電氣方程,給出了源和流源功放激勵下振動臺傳遞函數及幅頻、相頻特性曲線,列出了不同頻段間轉折頻率。
  12. This paper introduces a power controlling system for electrosurgical generator based on thyristor, and proposes a power compensating method to maintain the output power invariable when the ac voltage fluctuates

    介紹了基於可控硅整流電路高頻電刀控制系統,並針對該類型電刀輸出功率隨電網電波動而發生漂移問題,採用了一種功率補償方法,實現輸出功率在不同電網電波動下保持定。
  13. This paper introduces a power controlling system for electrosurgical generator baaed on thyristor, and proposes a power compensating method to maintain the output power invariable when the ac voltage fluctuates

    摘要介紹了基於可控硅整流電路高頻電刀控制系統,並針對該類型電刀輸出功率隨電網電波動而發生漂移問題,採用了一種功率補償方法,實現輸出功率在不同電網電波動下保持定。
  14. The effects of the fabrication conditions on the crystal structure, grain size, micromorphology and electrochemical performance of these materials have been studied in depth. the reaction mechanism of the low - heating solid - state reaction method has also been investigated. in addition, a novel electrochemical method ( rpg method ) based on the concept of " ratio of potentio - galvano - charge capacity " has been for the first time developed to determine the diffusion coefficient of lithium - ion within insertion - host materials on the basis of the spherical diffusion model

    本論文較系統地考察了低熱固相反應法合成鋰離子電池正極材料可行性問題,研究了工藝條件對材料晶體結構、晶粒尺寸、微觀形貌及電化學性能等影響,探討了低熱固相反應機理,並通過引進「-流充電容量比」概念,給出了一種測定鋰離子嵌入脫出固相擴散系數新方法。
  15. The electron degenerate pressure does not come from the burning of any nuclear fuel and can therefore support the star from further gravitational contraction forever

    電子簡並力並非來自任何核反應所以它能永遠抵抗引力。
  16. Can stop the star from further collapsing. note : again, neutron degenerate pressure does not come from nuclear burning. it can support a neutron star from further gravitational contraction forever

    則足以防止星進一步收縮同電子簡並力一樣中子簡並力並非來自核子反應它可永遠?抗引力收縮。
  17. Regarding the hysteretic properties and time - varying of the system, the scan round performance of the controller, adopt incremental pid algorithm in constant - pressure controlling and combine it with the integral - separated dead - zone algorithm as appropriate for the situation of the measuring system and applies fuzzy self - tuning to control pid controller parameters

    由於系統滯后時變性和控制器循環掃描工作方式,控制採用增量式pid控制演算法,結合測量系統實際情況加入積分分離帶死區改進演算法,並對pid參數進行模糊自整定控制,設計了一種參數自整定模糊pid控制器。
  18. To tune up the frequency of power supply by the transducer in the system, this adjusting make the speed of electromotor and performance curve of pump change. at last, it make the status of a pump alter

    在變頻調速供水系統中,單臺水泵工況調節是通過變頻器來改變電源頻率f來改變電機轉速n ,從而改變水泵性能曲線得以實現
  19. Through analyzing the figure of energy wasting of pump, the quality in pipes is direct proportion of the speed of pump if the speed of pump is reduced. the power of electromotor fell the cube of the speed of pump. so the energy wasting of constant pressure water supply based on variable frequency speed regulating technology is envident less than the traditional mode is used throttle to supply water

    分析水泵工況能耗比較圖,可以看出利用變頻調速實現供水,當轉速降低時,流量與轉速成正比,功率以轉速三次方下降,與傳統供水方式中用閥門節流方式相比,在一定程度上可以減少能量損耗,能夠明顯節能。
  20. The generator is verified to be of well performances by experiment. the third part concerns the control system of pm generator in vehicle application by commutating and inversion. considering the development of future power supply of auto electric system and the economizing on energy, the multi - voltage power supply system for future autos power supply system is introduced, and the design is given in detail

    最後,結合現代電力電子技術,利用整流橋、逆變器、 mosfet等元器件設計並實現了車用永磁發電機輸出控制;從未來汽車電氣系統發展方向和高效節能方面考慮,提出未來汽車多電供電系統典型配電模型,並對該模型進行具體設計,實現多電供電功能,並給出了控制線路中各主要部分波形。
分享友人