恆壓調節器 的英文怎麼說

中文拼音 [héngyādiàojiéqì]
恆壓調節器 英文
co tant voltage regulator
  • 恆 : Ⅰ形容詞1 （永久; 持久） permanent; lasting 2 （平常; 經常） usual; common; constant Ⅱ名詞1 （恆心...
  • 壓 : 壓構詞成分。
  • 調 : Ⅰ動詞1 （配合得均勻合適） harmonize; suit well; fit in perfectly 2 （使配合得均勻合適） mix; adju...
  • 節 : 節構詞成分。
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 調節器 : regulator; adjuster; governor; controller; conditioner; actuator; phaser
  • 調節 : regulate; adjust; monitor; measure; take care of; condition; regulation; adjustment; conditioning...
  1. A white led driver circuit is presented in this paper. the circuit drives up to four white leds with regulated constant current for uniform intensity. by utilizing proprietary adaptive 1x / 1. 5x modes and ultra - low - dropout current regulators, it maintains the highest possible efficiency over the full 1 - cell li + battery input voltage range

    整體電路以恆定電流驅動4隻白光led ，利用1倍/ 1 . 5倍分數型電荷泵和低壓差電流調節器，在整個鋰電池供電電壓范圍內保持最高的效率，並使四個白光led獲得均勻的亮度。
  2. A precision pressure regulator maintains the carrier-gas pressure constant.

    精密壓力調節器可以維持載汽壓力恆定。
  3. To tune up the frequency of power supply by the transducer in the system, this adjusting make the speed of electromotor and performance curve of pump change. at last, it make the status of a pump alter

    在變頻調速恆壓供水系統中，單臺水泵工況的調節是通過變頻器來改變電源的頻率f來改變電機的轉速n ，從而改變水泵性能曲線得以實現的。
  4. The system is based on the inner pid regulate function of frequency converter to regulate the living water stress with low constant stress, and the stress signal is sensed by the stress translator as feedback signal and the construction is sent by the computer as the given signal. the water stress is regulated to high constant stress when the fire happens

    本論文基於變頻器內置pid調節系統，以管網的壓力變送器壓力信號作為反饋信號，由上位機發出的當前狀態作為給定輸出，調節生活供水壓力使其保持低恆壓狀態；當火災發生時，調節系統管網壓力為高恆壓狀態。
  5. They will short down the working life of air compressor because they are always started or stopped when we want to make the railway carriage stay in a fixed temperature. now, automatic and intelligent control systems are being applying in bus air - conditions control. in this way, computers control the work of air compressor, the turnaround speed of fan, the open degrees of wind controlled doors and so on

    我國大多數客車空調仍然採用簡單的壓縮機開關控制及循環離合控制系統，如：離合器?熱力膨脹閥系統（ cctxv ）和離合器?節流管系統（ ccot ） ，這些控制方式的精度低，當進行恆溫控制時壓縮機處于頻繁的開、停狀態，縮短了壓縮機的工作壽命。
  6. In addition, in order to make the pumps realize constant injection pressure, the expert tuning pid vfvs constant injection pressure control sub - system for pumps is established and relevant software module is developed. the sub - system can control automatically the quantity and rotate speed of the pumps running to realize the pumps optimum run according to the seawater injection plan of the oil field, which realizes constant injection pressure, energy saving and decreases the consumption to a large degree

    此外，為平臺注水泵機組的優化運行構建了基於專家整定pid控制的變頻調速恆壓注水控制子系統，並開發了相應的軟體模塊，完全省卻了pid控制器的硬體設備，使得注水泵機組可以根據油田注水量的配注方案優化運行，自動控制注水泵的轉速和運轉臺數，既能實現平穩增壓注水，又能在很大程度上節能降耗。
  7. This thesis comes from the technological innovation project 2002 in xi ' an. the research is focused on the adaptive hybrid excitation synchronous generator system with constant output voltage. in order to keep the output voltage constant, the adaptive control is introduced in the digital voltage regulator of the generator system

    本課題來源於2002年西安市重大技術創新工程計劃?自適應復合勵磁恆壓同步發電機系統的研究，通過採用數字電壓調節器對復合勵磁同步發電機的自適應控制，實現發電機的恆壓發電輸出。
  8. In the dissertation, a novel hybrid excitation constant voltage synchronous generator is adopted to improve the system performance, which takes the advantages of both electrical excitation and permanent magnet machines. a parted configuration is presented in order to design the structure of the generator. the adaptive digital adjustment is settled in principle using the single chip microcomputer 80c31 as the control core of the voltage regulator and adopting the proportion - integral - differential control as the control arithmetic, then a sample is made

    論文對同步發電機的工作原理、性能特點、電機本體以及電壓調節器的硬體和軟體設計進行了研究，針對稀土永磁同步發電機變載、變轉速情況下輸出電壓不可調的不足之處，採用一種新穎的電機型式? ?自適應復合勵磁恆壓同步發電機，綜合了永磁發電機和電勵磁發電機的優點，提出一種磁路分開的結構進行電機本體的設計，並選用單片機80c31作為電壓調節器的控制核心，比例?積分?微分控制（ pid ）作為其控制演算法，從原理上較好地解決了其電壓的自動數字調節，並試制了一臺樣機。
  9. Aiming at the problems of the k190jik rail welding machine, that the parameter modification is difficult, the welding process is not enough stability and the welding machine has no on - line diagnosis function, in this paper, the control system of the welding machine was promoted completely adopting the fx2n - 64mr programmable logic controller and the pcl - 1800 data acquisition card, the das ( data acquisition system ) was set up by using labview and visual basic software, the functions of welding voltage stabilizing and adjusting, current controlling and intellectual modification was improved, welding quality diagnosis system was built up, and the assembling and debugging of the control system was completed, including the process experiments

    本文針對k190jik鋼軌焊機控制系統存在參數修改困難、焊接過程不夠穩定、無焊接質量在線診斷功能等問題，採用日本三菱公司fx2n - 64mr可編程序控制器、研華工控pcl ? 1800數據採集卡等為核心控制部件，對焊機的整機控制系統進行了全面升級。運用軟體labview和vb開發了數據採集系統，完善了焊接穩壓、調壓、電流恆值控制與智能調節功能，利用vb建立了焊接質量在線診斷系統，並完成了系統組裝調試與工藝試驗研究工作。
  10. The system maintains the pressure constant through continuous sampling to pressure, and pid adjuster operating and obtaining control parameter to control the system implementing part

    該系統通過對壓力進行連續采樣，由pid調節器運算得出控制參數，對系統執行機構進行控制，從而維持壓力恆定。
  11. With the application of real - time multi - tasks mechanism and modulization software structure, the controller can set and modify the parameters on - line, collect and process the real - time data of the four - battery charge / discharge devices, termly and digitally regulate the closed loop and monitor the real - time faults, so that the system can control different styles of charging and discharging operate mode such as in constant current style, constant voltage with limited current style and static style

    控制器軟體採用實時多任務機制和模塊化的設計思想，通過對蓄電池化成充放電過程中工藝參數的在線設定修改、實時數據的採集處理、定時的數字閉環調節和故障的監測，實現對蓄電池靜電、恆流、恆壓限流等多種充放電工作方式的控制。
  12. Based on the experience of regulating frequency according to different valve ' s angle, a reasonable controlling tactic is proposed. when the situation changes to a small degree, electromotor makes fan running at a constant rate ; when the situation changes to the limiting range, the discharge header pressure is automatically adjusted by the rate of fan

    制定合理的控制策略，採用基於閥門開度的變頻調節策略，即工況變化較小的情況下，電機帶動鼓風機恆速運行，通過控制閥門開度自動調節集氣管壓力；當閥門開度到達極限值，還不能達到控制要求時，再通過變頻器改變鼓風機轉速，以自動調節集氣管壓力。
  13. Thermostatic evaporator pressure regulator

    蒸發器恆溫壓力調節閥
  14. This constant - pressure hydraulic power adopts plvc4 programmable logical controller for valve to control the electro - hydraulic proportional relief valve to adjust the pressure at the entrance of the servo valve and makes it change with the pressure change at the exit thus to keep the pressure difference constant

    此恆壓油源採用閥用可編程式控制制器plvc4控制電液比例溢流閥調節伺服閥入口壓力，使其跟隨伺服閥出口壓力變化，達到入出口壓力差值恆定的目的。
  15. Abstract : the multifunctional inverter power sourcethe handy inverter welding, plating & charging manchine, developed with advanced inverter and micro - electronics control techniques, adopts “ half - bridge power expansion supply midpoint voltage autocontrol setting ”, and technically and effectively having solved inverter subvision of inverter power expansion circuit for leaning magnetism, reliability of high - power inverter setting, achives combination of constantcurrent and constantvoltage export, and realizes low - voltage dc and high - voltage ac double power supply

    文摘:運用先進的高頻逆變技術和微電子控制技術設計研製的逆變式多功能電源便攜式逆變焊鍍充電多用機，採用「半橋式功放級供電中點電壓自動控制調節裝置」 ，在技術上解決了逆變功放電路因偏磁而造成的逆變顛覆，有效地解決了大功率逆變器的可靠性問題；進行多種外特性的綜合設定，實現了恆流與恆壓輸出的合一；與傳統焊機相比，實現了開環和閉環狀態下都互不影響的低壓直流電瓶和高壓交流雙供電
  16. Constant voltage regulator

    恆壓調節器
  17. The new constant pressure controlle r for irrigation system is used to control the terminal pressure ( at the terminals of the branch pipes ), and it can more effectively convert the frequencies of the moters. thus energy can be saved

    新型的恆壓噴灌控制器採用的是末端控制（即分干管末端） ，這種控制方式可使噴頭獲得更好的噴水壓力，並且使電機可進行更有效的調速，從而獲得更好的節能效果。
分享友人
分享到 Line

分享到臉書