空氣凝汽器 的英文怎麼說

中文拼音 [kōngníng]
空氣凝汽器 英文
air condenser
  • : 空Ⅰ形容詞(不包含什麼; 裏面沒有東西或沒有內容; 不切實際的) empty; hollow; void Ⅱ名詞1 (天空) s...
  • : Ⅰ名詞1 (氣體) gas 2 (空氣) air 3 (氣息) breath 4 (自然界冷熱陰晴等現象) weather 5 (氣味...
  • : 動詞1. (凝結) congeal; curdle; coagulate 2. (注意力集中) fix
  • : 名詞1. (由液體或某些固體變成的氣體) vapour2. (水蒸氣) steam
  • : 名詞1. (器具) implement; utensil; ware 2. (器官) organ 3. (度量; 才能) capacity; talent 4. (姓氏) a surname
  • 空氣 : 1 (大氣) air; atmosphere 2 (氣氛) atmosphere 3 (氣閘) air brake4 pneum ; pneumo ; pneumat ;...
  1. These manifolds are connected to the vacuum system through air take - off lines in order to remove the non - condensable gases from the condenser

    這些集管通過管線與抽真系統相連,以便從內抽走不可冷體。
  2. When “ holding ” ( during normal operation ), non condensable, which are coming from air ingress and oxygen content in steam and condensate, must also be extracted normally by main ejectors

    當「建立真」 (正常操作下)時,入口處的不可結物和蒸中的氧含量以及結水必須由主抽排出。
  3. Our main products are micro barometer low pressure gauge low pressure capsule gauge vacuum pressure with low pressure gauge pressure gauge with electrical contact shock - proof electric contact gauge stainless steel pressure gauge dry and glycerin filled pressure gauge normal pressure gauge freon pressure gauge oxygen - acetylene pressure gauge stainless steel vacuum pressure gauges series diaphragm seal pressure gauge diaphragm pressure gauge with electrical contact pp diaphragm seal pressure gauge shock - proof pressure gauge with electrical contact diaphragm seal pressure gauge explosion - proof electric contact pressure gauge minitype pressure gauge accurate pressure gauge test pressure gauges as well as pressure gauge switch pressure separator tube pressure gauge radiator double - metal thermometer all the products can meet both national and international stands,

    一般壓力表壓表抗震壓力表充油壓力表全不銹鋼壓力表膜盒微壓表電接點壓力表冷媒壓力表真壓力表壓力真表隔膜壓力表微型壓力表差壓表微差壓表絕壓表精密壓力表耐高溫壓力表蒸壓力表車燃壓力表醫用壓力表遠傳壓力表衛生型壓力表壓力表緩沖管壓力表冷散熱壓力表翅片散熱壓力表開關不銹鋼連接彎管不銹鋼連接軟管轉換接頭油壓連接頭壓力表針閥節流閥及過壓保護附件濾油網加油口油溫油麵計雙金屬溫度計等。
  4. The air - cooled steam condenser ( acc ) condenses the turbine exhaust steam or the de - superheated steam from the turbine bypass by rejecting the heat to the atmosphere

    ( acc )通過向大釋放熱量對機排機旁路的減溫過熱蒸進行冷
  5. With the introduction of world leading molds and technology for 134a layer evaporators, shanghai shuanghua automotive air conditioning parts is a professional manufacturer of layer evaporators for all models, machine oil coolers and pressurized air coolers with an annual output of over 2 million pieces ( sets )

    上海雙樺調配件有限公司引進具有世界領先水平的134a層疊式蒸發製造模具和生產技術,專業生產世界上各種車型的層疊式蒸發和平行流冷、機沒冷卻、增壓冷卻,年產量可達200多萬臺(套) 。
  6. The flow passage of intermediate - pressure cylinder, as well as the condenser and the vacuum extraction system had also been retrofitted in 2004, the safety and economic behavior of said unit being further enhanced

    2004年又對7號機中壓缸通流部分及、真系統進行了改造,機組的安全性及經濟性均有了進一步提高。
  7. The dried material is put into the middle of shell, mixing by the rake teeth and the material shaft works back and forth. the indirect heating, equal agitation of rake teeth and grinding of breaking stick makes water in material evaporation. under the effect of vacuum system, the water in the dried material and apparent water are discharged and the vapor water is discharged from outlet of vacuum pump passing dry dust collector, wet dust collector and condenser

    被乾燥物料從殼體上方正中間加入,在不斷正反轉動的耙的攪拌下,物料軸向來回走動,與殼體內壁接觸的表面不斷更新,受到蒸的間接加熱,耙的均勻攪拌,粉碎棒的粉碎,使物料內的水份化,在真系統的作用下,使被乾燥物料內部水份和表面水份更有利的排出,化的水份經乾式除塵濕式除塵,從真泵出口處放
  8. Measurements were made of system pressure, mass flow rate of steam, air, and cooling water, temperatures of condensing flow and cooling flow, and the water level of boiler. the major phenomena observed in the present experiment are similar to those by other investigators. the mass flow rate of steam, the system pressure and air content are the most important factors affecting steam condensation

    實驗結果表明,維持二次側冷卻水流量不變,無論對于純凈蒸還是含有的蒸,隨著蒸發生加熱功率的增大(即蒸流量增大) ,有效冷段長度將加長;當蒸中含有少量,有效冷段長度也會明顯加長;提高系統壓力,有效冷段長度將縮短。
  9. A tropical cyclone is akin to a travelling heat engine. it feeds on an incessant supply of latent heat released from condensation in ascending moist air

    熱帶旋類似一臺會走動的熱能機,它的能量來自濕上升時水結而釋放的潛熱。
  10. The condensation heat - exchange characteristic of a separate - type heat - pipe was studied on a 1 : 1 model. the heat pipe is heated by electricity, and working fluid is distilled water, and it is cooled by air. the experimental results show that, ( 1 ) when charging liquid ratio is 45 %, condensation heat - exchange coefficient reaches to maxium ; ( 2 ) when there is not non - condensing gas, the coeffcient decreases a little with the increase of vapour pressure, and it decreases by 9. 5 % when the pressure increases from 0. 16mpa to 0. 36mpa ; ( 3 ) when there is non - condensing gas, the coefficient decreases a little, but when the gas is discharged by an exhaust value, it can be improved, when the volume content of the gas is 2. 5 %, it can increased by 22 % ; ( 4 ) the effect of the non - condensing gas on the coefficient decreases with the increase of the pressure, and when the volume content of the gas is 5 % and the pressure increases from 0. 16mpa to 0. 36mpa, the coefficient increases by 6 %. the relative curves are given between condensation heat - exchange coefficient and air flowrate, charging liquid ratio and vapour pressure

    建立了冷卻實驗臺,熱管的加熱方式為電加熱,工質為蒸餾水.在1 1模型上對分離式熱管管內結換熱特性、不體對結換熱的影響及不體的擴散規律進行了試驗,得出分離式熱管有一最佳充液率,其值為45 %左右;結換熱系數隨著蒸壓力的增加略有降低,在實驗的壓力范圍內,降低了9 . 5 % ;不體對分離式熱管的結換熱僅影響冷段下部較小部分,通過排閥排出不體可有效地改善冷段下部的結換熱;隨著壓力的增加,不體對分離式熱管冷段的影響減少.這些結論可用於分離式熱管換熱的工程設計和控制
  11. Abstract : the condensation heat - exchange characteristic of a separate - type heat - pipe was studied on a 1 : 1 model. the heat pipe is heated by electricity, and working fluid is distilled water, and it is cooled by air. the experimental results show that, ( 1 ) when charging liquid ratio is 45 %, condensation heat - exchange coefficient reaches to maxium ; ( 2 ) when there is not non - condensing gas, the coeffcient decreases a little with the increase of vapour pressure, and it decreases by 9. 5 % when the pressure increases from 0. 16mpa to 0. 36mpa ; ( 3 ) when there is non - condensing gas, the coefficient decreases a little, but when the gas is discharged by an exhaust value, it can be improved, when the volume content of the gas is 2. 5 %, it can increased by 22 % ; ( 4 ) the effect of the non - condensing gas on the coefficient decreases with the increase of the pressure, and when the volume content of the gas is 5 % and the pressure increases from 0. 16mpa to 0. 36mpa, the coefficient increases by 6 %. the relative curves are given between condensation heat - exchange coefficient and air flowrate, charging liquid ratio and vapour pressure

    文摘:建立了冷卻實驗臺,熱管的加熱方式為電加熱,工質為蒸餾水.在1 1模型上對分離式熱管管內結換熱特性、不體對結換熱的影響及不體的擴散規律進行了試驗,得出分離式熱管有一最佳充液率,其值為45 %左右;結換熱系數隨著蒸壓力的增加略有降低,在實驗的壓力范圍內,降低了9 . 5 % ;不體對分離式熱管的結換熱僅影響冷段下部較小部分,通過排閥排出不體可有效地改善冷段下部的結換熱;隨著壓力的增加,不體對分離式熱管冷段的影響減少.這些結論可用於分離式熱管換熱的工程設計和控制
分享友人