懸液計 的英文怎麼說

中文拼音 [xuányèjì]
懸液計 英文
nephelometer
  • 液 : 名詞（液體） liquid; fluid; juice
  • 計 : Ⅰ動詞1 （計算） count; compute; calculate; number 2 （設想; 打算） plan; plot Ⅱ名詞1 （測量或計算...
  1. Experimental and calculation methods for determining damping properties of the inertia track in a hydraulic engine mount

    液阻懸置慣性通道阻尼特性的實驗與計算分析
  2. Therefore, a new design of the flexible joint is herein assumed by replacing the spring / damper system by a hydropneumatic system in which a horizontal hydraulic cylinder only is needed to be fitted between the two bell cranks and the rest of the hydro - pneumatic system which are the throttle valve and the accumulator can be suspended on the vehicle frame at any convenient place

    因而，此處採用新型撓性連接設計，用液壓氣動系統替代彈簧減振器裝置，液壓氣動系統兩曲柄間只需安裝一個臥式液壓缸，而其他部件（即減壓閥和蓄能器）可懸置於車架的適當位置。
  3. Ultrasonic has being attracted much attention gradually in fuel atomization because of some specialities of cavitation and infection on liquid flow. in the course of atomization of pitchy oil, especially, does it show greatly its advantage, but its material atomizational mechanism need research ulteriorly. the primary content of this thesis is about adding cantilever reed to effervescent atomizer so as to combine ultrasonic and effervescent. this thesis has discussed ultrasonic some mechanism, ultrasonic dynamical procreator, effervescent and liquid mucosity infection on atomization, at the some time we make some experiments and discuss atomization rule following some machinery parameter and run parameter so as to find some rule about ultrasonic atomization and to rich the research of ultrasonic atomization mechanism. all that will be beneficial to the design about ultrasonic atomization atomizer

    超聲波由於其空化機理及對液體的流變性影響等特性，在燃油霧化燃燒中逐步引起人們的重視，尤其在重渣油等高粘度液體的霧化過程中逐步顯示出其優越性，但其具體的霧化機理還需要做進一步的研究在氣泡霧化噴嘴基礎加入懸臂式簧片哨，將超聲波與氣泡霧化相結合是本文討論的主要內容本文從研究超聲波的一些機理入手，討論了超聲動力發生器氣泡霧化以及液體粘度對霧化質量的影響，並通過具體的實驗，根據實驗數據來討論霧化質量隨各種結構參數運行參數的變化規律，以便找到超聲霧化的一些規律，豐富對超聲霧化機理的研究，對超聲霧化噴嘴的設計具有一定的指導意義。
  4. In this paper, several important points which include design of active damper, model of the system, computer simulation, theoretical analysis and experiment study of the theory will be explained

    本文比較系統地提出了一套全新概念的液壓半主動懸架結構，它包括建模分析、結構設計、計算機模擬、理論分析計算、實驗研究等方面的內容。
  5. The who classification states that acute lymphocytic leukemia ( all ) should be classified by the pattern of reactivity of cell to a panel of lineage - associated antibodies and, where possible, genetic abnormalities. the expression of cd antigens on leukocytes is currently determined by flow cytimertry, which is expensive and labor - intensive, requiring 5 - 20ul quantities of fluores - cently labeled antibodies and allowing concurrent analysis for a limited number of cd antigens, usually three to four. from clinical point of view, an efficient method is required for analysis of a large number of samples in a single experiment

    我們設計了一種新型的細胞晶元，其原理是充分利用玻片的硬度高，透明性好的特點，應用細胞膜表面不同的抗原物質，與包被在玻片上的不同抗體發生特異性結合，通過一次實驗可以將被測細胞懸液中不同膜表型的細胞分離、固定在同一張玻片的不同特定區域，保持了細胞的完整性及活性，又可通過簡單的操作一次將多細胞懸液進行免疫分群。
  6. In the design of loading - frame, puting forword a group of universal dimensions of three - point free - link attachment to category i and ii tractors through comparing and analysing whose scope of dimensions, thereout, working out sketch of loading framework on several different positions in the whole lift - course of hydraulic liftenafter this. analysing the case of force on loading framework when the loading force equal to 44100n and the lift - position of the hydraulic lifter is on upper limit, and giving a data table about the case of force on all these positions, consequently, completing the design of loading frame

    在加載框架的設計部分，通過對、類拖拉機的三點懸掛機構桿件尺寸范圍的比較分析，給出了一組、類拖拉機通用的三點懸掛機構桿件尺寸，由此作出了液壓提升器提升全行程中幾個不同位置的加載機構簡圖，並按44100n的加載力、以上極限位置為例對加載機構進行了受力分析，並給出了包括其它幾個位置在內的受力情況表，進而完成了加載框架的設計。
  7. The characteristic of engine exciting is analyzed. the hydraulic mount system " simulating calculation on idle working condition and high speed working condition is carried out by adams

    分析了發動機激勵的特點，運用adams進行了動力總成液壓懸置系統的怠速和高速工況下的模擬計算。
  8. A new type of automatic apocatharsis valve on settling centrifuge device was designed, so that the separation and automatic apocatharsis of the liquid and suspended substance were done continuously

    摘要設計了一種新型的自控排液閥，來實現沉降離心分離裝置中液體和懸浮物的連續分離和自動排出。
  9. This paper shows that the valve made the settling centrifuge device a little size, a simple structure, a high efficiency and a continuous work

    設計的自控排液閥可使懸浮物的分離裝置結構簡單緊湊，實現高效、可靠的連續作業。
  10. The method of indirectly measuring force exerted on ground by bucket is used to check cantilever bucket - wheel stacker / reclaimer counter - weight, working out the hydraulic cylinder force to determine the force exerted on ground by bucket and thus counterweight value

    摘要針對懸臂斗輪堆取料機配重的校核提出了1種間接測定接地力的方法，即通過懸臂升降液壓缸上下油腔壓力計算出液壓缸受力，進一步推算出堆取料機的接地力，從而確定配重安裝量。
  11. Test method for determining the sieving performance of a fluid filter medium employing an aqueous suspension of microspheres and a spectrophometer

    用微球體的含水懸浮液體和分光光度計測定液體過濾器篩分性能的測試方法
  12. Abstract : a continuity wave model is put forward for the dispersion processof liquid - liquid two - phase system, by coupling mass and momentum conservation equations of two - fluid model. the conditions that result in a dispersion choke and the weak instability of a dispersion process are derived from the model. the phenomena of catastrophic inversion and transitional inversion are explained. the effect of drop size distribution on the maximum volume concentration of a emulsion is predicted using the model. according to the theory herein, emulsion inversion is the regime transition of liquid - liquid system due to the instablity of a dispersion process. the effect of drop size distribution on the maximum volume concentration of a liquid - liquid emulsion only occurs in a certain range of weber numbers

    文摘:以雙流體模型為基礎，通過質量守恆方程和動量守恆方程的耦合，提出了液-液兩相系中彌散傳質的連續波模型.由該模型得到彌散傳質過程阻塞和彌散傳質過程弱不穩定性產生的條件，計算了液滴尺寸及其分佈對乳化液極大堆砌分數的影響，解釋了劇變型乳化逆變和漸變型乳化逆變現象.研究結果表明，乳化逆變是由於彌散傳質過程的不穩定性而引起的懸浮體型態的改變，隨液滴尺寸多分散性的增大，極大堆砌分數增大；隨液滴平均尺寸的增大，多分散性對極大堆砌分數的影響減弱；當韋伯數足夠大時，液滴尺寸及其分佈對乳化液極大堆砌分數無影響
  13. Particle size analysis in an electrolytic suspension using a resistance variation counter

    粒度測定.用電阻變化計數器對電解液中懸浮物的粒度分析
  14. In view of the fact that the power of the nano technology and its many potential application in thermal science, the thesis mainly discussed the potential application of the nano technology in micro scale heat transfer, the stability of the nano particle suspension. experimental facility was designed and built up to study flow and heat transfer performance of cuo nano particle suspension and water in mini tubes

    鑒于納米技術表現出的強大生命力和在熱科學領域中潛在的廣闊應用前景，本文探討了納米懸浮液的穩定性，設計和建立了實驗系統，實驗研究了細圓管內氧化銅納米顆粒懸浮液流動及換熱特性，包括流動阻力特性，流動的轉捩和換熱特性。
  15. Analytical model for the transmembrane voltage induced on a permeabilized cell membrane in suspensions exposed to dc pulse fields

    直流脈沖場作用下穿孔懸液細胞跨膜電壓計算模型
  16. Abstract : this paper mainly introduces the composition of the powerplantmodule hydraulic loop of the combinable full trailer, analyzes the pressure distribution and calculates the pressure of hydraulic suspension system with fullload, and on the basis of the above analysis, we have chosen the model of hydraulic pump and diesel engine

    文摘:主要介紹組合式全掛車動力機組液壓迴路組成，對滿載時的液壓懸掛進行受力分析和工作壓力計算，並以此為依據對液壓泵和柴油機進行選型。
  17. This series of ball valve products is specially and developed on the basis of foreign advanced technologies. with compact structure and reliable seal performance, it is widely applied in occasions of suspending liquid containing small particles and fiber in petroleum, chemical and electric power industries. it is especially popular in dcs, qcs and plc control systems in production processes of waste paper deinking, alkali recovery, pulping and sewage processing in paper making industry

    該系列產品是在國內外先進技術的基礎上進行特殊設計，精心研製開發的球閥系列產品以其緊湊的結構，可靠的性能，被廣泛應用於石油、化工、電力等行業含有纖維或微小固體顆粒的懸浮液的場合。
  18. In this dissertation, on the basis of researches on the mechanisms of electrorheological effect and the change in microstructure of composite dispersion under the applied electric field. the theoretical analysis to rheo - optic characteristics of an electrorheological fluid under an electric field is first conducted systematically. the light - controlling properties of an electrorheological fluid is ev aluated and an intelligent structure of electrorheological fluids - based smart windows ( erfsw ) is proposed and designed at the first time

    本論文在研究雙相復合懸浮液電流變效應機理，及場致微結構變化特徵的基礎上，首次對電流變體流變光學特性進行了較深入的理論分析，並對電流變體的光學調控特性進行測試，從而首次提出並設計了光學特性動態可調的電流變體靈巧窗（ electrorheologicalfluids - basedsmartwindow ， erfsw ）智能結構，為電流變體應用研究提出了一條新思路，開拓了電流變體在靈巧窗智能結構等方面的應用。
  19. The outstanding benefit of this construction is the straight liquid passage which is - from a fluidic point of view - especially advantageous for suspensions, viscous or abrasive fluids as well as such not being allowed to be exposed to gravity or containing solids

    這種泵的設計上的顯著優點是其直線的流通通道，從流體的角度看，這一點在處理懸浮液、粘性流體或有磨蝕性流體，以及不能暴露在重力下或含有固體的的流體時特別有利。
  20. Standard test method for automated analyses of cells - the electrical sensing zone method of enumerating and sizing single cell suspensions

    細胞自動分析的標準試驗方法.單細胞懸浮液計數和分級的電敏域法
分享友人
分享到 Line

分享到臉書