拉伸應變紋 的英文怎麼說
中文拼音 [lāshēnyīngbiànwén]
拉伸應變紋
英文
stretcher strain-
The studies expressed that the tensile - strength declined with the growth of dose rate after the radiation treatment, and at the same time, the gel content had extreme value with the change of the dose rate. the surface of uhmwpe fibers showed some irregular micro - pits and dents after radiation treatment, narnely rough degree increasing. their number and deepness increased with increase of dose. and this phenomenon is the most obvious when the dose rate was 8. 5kgy / s and the dose was 400kgy. at the same time some containing oxygen groups, including hydroxyl group, carbonyl group and carboxyl group, were introduced into the fiber surface which was exposed to the air
研究表明， uhmwpe纖維經電子束輻照處理后，纖維的拉伸斷裂強度隨劑量率的增加呈下降趨勢，凝膠含量隨著劑量率的變化存在極值。纖維表面出現了不規則的微裂紋和凹痕，隨著劑量的增大，電子束對纖維表面的刻蝕程度增加，在本研究中以劑量為400kgy劑量率為8 . 5kgy s時刻蝕效應最為明顯。同時，在空氣中進行輻照時，纖維表面被引入了一些含氧基團，包括羥基、羰基和羧基。The achievements and conclusions are listed as follows : 1, basing on the single - axes stretching experiment result of pmma sample with holes and pmma sample without holes under creep, using non - linearity regress analysis, after non - linearity imitating the experiment data, we may get the crazing damage density evolvement curve of pmma sample with holes and pmma sample without holes follow the time and stress under different stress level
本文通過實驗研究得到如下成果： 1 、基於有孔洞pmma試件和無孔洞pmma試件的蠕變條件下單軸拉伸實驗結果，採用非線性回歸分析，對所得數據進行非線性擬合，得到不同應力水平下，有孔洞pmma試件和無孔洞pmma試件銀紋損傷密度值隨應力及時間演化的曲線。If there are high temperature gradient between cool liner and hot liner, compressive plastic strain appear at that transient time, which lead to gas film wall bearing high tensile stress at high temperature. high tensile stress is one of main reasons which destroy combustor
分析表明，起動過程中由於熱傳導滯后引發的溫度梯度可以導致火焰筒氣膜唇邊在起動瞬間發生較大的壓縮塑性應變，進而使得該區域在工作時承受較高水平的拉伸應力，高的拉應力會導致火焰筒萌生裂紋。
分享友人