拔管 的英文怎麼說

中文拼音 [báguǎn]
拔管 英文
tube drawing拔管 （用）夾鉗 plyer
  • 拔 : Ⅰ動詞1 （拉出; 抽出） pluck; pull out; pull up; draw; move 2 （吸出） draw; suck out 3 （選取 提...
  • 管 : Ⅰ名詞1 （管子） pipe; tube 2 （吹奏的樂器） wind musical instrument 3 （形狀似管的電器件） valve;...
  1. Rightly based on this fact and closely surrounding the links of the selective and appointive mechanism of operators, this paper analyzes the current situation, problems and causes of the selective and appointive mechanism of the stateowned business, combines the concrete practice of the selective and appointive mechanism of operators in the developed countries, uses the relative theories and methods of modern management science and psychology, and puts forward the countermeasure of the selective and appoinitive mechanism of the stateowned operators which reflects the virtuous and talented information of operators and adpts to modern enterprise system

    本文正是立足於這一現實，緊緊圍繞經營者選拔任用機制的各個環節，通過對當前國有企業經營者選拔任用機制的現狀、問題及原因進行分析，並結合發達國家國有企業經營者選拔任用機制的具體實踐，運用現代管理學和心理學的相關理論與方法，提出能夠反映經營者德才信息並與現代企業制度相適應的國有企業經營者選拔任用機制的對策。
  2. It summarized research progress on recovery of automatic micturition in postoperative uterine cervix cancer patients from aspects of pelvic floor muscular training before and after suprapubic cystotomy, individual bladder training, prevention of urinary tract infection, physiotherapy, hip bath after extubation, and relieving anxiety and tension for patients

    從恥骨上膀胱造瘺、手術前後盆底肌肉鍛煉、個體化放尿訓練、預防泌尿道感染、物理療法、個體化排尿及拔管后坐浴、緩解病人的焦慮和緊張等方面對宮頸癌術后恢復自主排尿的研究進展進行綜述。
  3. Appraisal of unplanned endotracheal extubation in artificial airway patient

    人工氣道患者非計劃拔管事件的評價
  4. Stud, screw and pipe extractors : safety requirements

    螺柱螺釘和拔管器:安全要求
  5. Effect of sheng - fu injection on the time from the discontinuation of anesthetic drugs to the extubation of the trachea for the patients with chronic bronchitis

    參附註射液對慢性支氣管炎病人全麻后拔管時間的影響
  6. Results : four patients with laryngostenosis after vertical partial laryngectomy were extubated ; 2 patients with decompensation were cured ; 1 patient with decompensation caused by laryngeal trauma was cured too

    結果： 4例因喉癌術后喉功能不良者術后能順利拔管； 2例呼吸困難者， 1例喉外傷患者呼吸困難術后均得到緩解。
  7. It concluded improved method for use is a good method of nursing and deserve to spead

    改良的拔管方法是一種值得護理推廣應用的好方法。
  8. Development study on model wy multi - functional thoracic cavity closed drainage system

    自發性氣胸行胸腔閉式引流術后最適宜拔管時間的探討
  9. The wire rope laying mechanism design of the lifting system of the vibrating drawing pipe pile engine

    振拔管式打樁機提升系統排繩機構設計
  10. I had a feeling that the doctor wanted to pull off the plug on the life support system

    我有種感覺，覺得醫生會要我拔管，摘除他的生命維持器。
  11. Relevant experiments and long - term operation practice of the mill have shown he echnologieally reliability of the mill

    通過試驗及長期的生產實踐，證明了該冷拔管機技術可靠。
  12. Aluminium and aluminium alloys. cold drawn rod bar and tube. part 8 : porthole tubes, tolerances on dimensions and form

    鋁及鋁合金.冷拔棒材條材和管材.第8部分:多孔拉拔管尺寸和形狀公差
  13. Clinical observation of cardiovascular reaction in the period of removing trachea cannula using small dosage of propofol for prevention

    小劑量異丙酚預防老年人氣管導管拔管期心血管反應臨床觀察
  14. It surprised me when rinpoche told me that i should resuscitate tm at least two times and make sure that the doctor does not pull off the plug

    令我驚訝的是，仁波切告訴我應該至少急救tm兩次，且確定要醫生不要拔管！
  15. Feb at the national conference for selecting and sponsoring candidates for overseas studies, former state education commission made the decision to conduct, in the name of the csc secretariat under preparation of the state education commission, an experiment in jiangsu and jilin provinces in accord with the principle of open selection, equal opportunity to compete, expert evaluation, sponsorships based on academic excellence, signing a legal agreement before departure for study abroad, and compensation upon violation fo the signed agreement issued principles for the

    2月在全國出國留學人員選派工作會議上，遠國家教委提出了改革國家公費出國留學選拔管理方法的方案，決定實行「公開選拔平等競爭專家評審擇優錄取簽約派出違約賠償」的方法，以「國家教委留學基金管理委員會秘書處籌備」的名義負責實施，並在江蘇吉林兩省先行試點。
  16. To produce specialty tubing, this procedure uses a drawbench to pull tubing through a die and over a mandrel, allowing excellent control of the inside diameter and wall thickness

    為了製造出更精密的管子，本工藝通過拔管機使管子經過鋼型和心軸的拉制，這樣管子的內徑和壁厚精密度就能控制的很好。
  17. Abstract : described here are the structure and features of the prestrssed, high - rigidity, hydraulically - operated cold - drawing pipe mill as well as the mechanical analysis of the mill during pipe drawing operation

    文摘:介紹了預應力高剛性液壓冷拔管機的結構、特徵，進行了拔管時的力學分析。
  18. Aluminium and aluminium alloys extruded tubes and cold - drawn tubes

    鋁和鋁合金擠壓管材和冷拔管材
  19. The calculation results show that the stress distributing of the plug drawing tube is different because of different dies, the drawing force and pulling force are lager in arc die and the diameter and wall thickness are closer to the designing value in cone die

    計算結果表明，不同的模具，芯拔管的應力分佈不同，弧形模成型的拔制力與芯棒后拉力較大，錐形模成型后鋼管的直徑與壁厚更接近設計值。
  20. In order to obtain the stress distributing rules of the forming process of short plug drawing tube and the differences of drawing force, pulling force and dimension precision under different dies, fe method was used and fe model of the plug drawing tube under different dies was built

    摘要為了獲得不同的模具下短芯棒拔管成型過程中的應力分佈規律以及不同模具對短芯棒拔管拔制力、芯棒后拉力和尺寸精度的影響規律，利用有限元的方法，建立了不同模具下短芯棒拔管成型的有限元模型。
分享友人
分享到 Line

分享到臉書