按位值 的英文怎麼說

中文拼音 [ànwèizhí]
按位值 英文
positional value
  • 按 : Ⅰ動詞1 （用手或手指壓） press; push down 2 （壓住; 擱下） leave aside; shelve 3 （抑制） restrain...
  • 位 : Ⅰ名詞1 （所在或所佔的地方） place; location 2 （職位; 地位） position; post; status 3 （特指皇帝...
  1. The bonds, which were introduced in 1956, are in units of one pound and are redeemable at face value on demand.

    這種債券始於1956年，以一英鎊為單位，需要時可按面值兌現。
  2. We can work out positions of a harmonic oscillator by numerical methods.

    我們可以按數值方法計算簡諧振子的位置。
  3. Abstract : in this paper ， the problems in collecting data of earth pressure are discussed on the basis of some real projects according to the author ， the present way ， in which earth pressure data are calculated completely from classics theory ， is not practical a nonlinear method of row pile design ， in which the cooperative action of ring beam are taken into account and the lateral pressure is calculated on the basis of the pressure of displacement earth are proposed

    文摘:本文從實例著手，分析了在土壓力取值上存在的問題，目前工程中完全按經典理論進行套算是不確切的;提出了排樁設計中應定量考慮圈樑的協同作用，側壓力按位移土壓力進行計算的非線形方法。
  4. Though the water levels cross one section are almost equal, the velocities differ greatly. at the some cross - section, the velocity in the in the quirk may be double as that on the floodplain. the water surface will rise hi the southern branch because of the improper diffluence ratio, if using the designed diffluence col

    淮河入海水道河口段水位值橫向分佈相差無幾，而流速的橫向變化較大，泓灘平均流速差最大可達一倍以上，在現有的分流口設計條件下，若按設計的南北汊分流比，南分流口有壅水現象發生，如果南汊分流增大到800m ~ 3 / s左右時，則水流較為通暢。
  5. The detail is clarified as follows : l ) based on the chaotic technology and contemporary encryption approach the paper put forward a new chaotic sequence, which introduced the m - sequence and the method of shrink key - the stream generator. the complexity of the sequence was promoted as the random alteration of the parameters of chaotic mapping, and at the same time, the shrinking key was used to enhance the security further more ; 2 ) the performance of one - way hash function was improved and new hash function construction methods are proposed through a novel hash method based on chaotic mapping and the aes - the rijndael algorithm. the algorithm of hashing messages of arbitrary length into 256 bits hash values was designed

    按照這種方法，輸出序列的周期性得以大大提高，理論分析和計算機模擬結果表明，該方法可以產生具有良好統計特性的密鑰流，而且易於軟硬體實現： 2 ）實現了一種基於混沌映射和分組密碼rijndael演算法的單向hash函數的構造方法，即使用logistic混沌映射產生混沌二值序列，序列的分組與明文序列分組進行按位異或后，進入rijndael加密模塊，所得的結果再加入到反饋端，參與下一分組輸入的異或運算，迭代結束時的rijndael加密結果即為所求的hash函數值。
  6. A bitwise combination of these values may be used

    可以使用這些值的按位組合。
  7. Values representing the attributes for the method

    值的按位組合，表示方法的屬性。
  8. Bitwise operations evaluate two integral values in binary base 2 form

    按位運算採用二進制（以2為基）形式計算兩個整數值。
  9. Floating - point values must be converted to integral types before bitwise operation can proceed

    浮點值必須轉換為整型后，才能執行按位運算。
  10. Function and the value of the individual file attribute you want

    函數返回的值以及您想要的個別文件屬性值執行按位比較。
  11. And operator to perform a bitwise comparison of the value returned by the

    函數所返回的值與要確定的各個文件屬性的值進行按位比較。
  12. Simple enumerations contain values that are not combined or used in bitwise comparisons

    簡單枚舉包含的值不用於組合，也不用於按位比較。
  13. Operator performs a bitwise comparison of identically positioned bits in two numeric expressions and sets the corresponding bit in

    運算符對兩個數值表達式中的位置相同的位執行按位比較，並且按下表設置
  14. And operator performs a bitwise comparison of identically positioned bits in two numeric expressions and sets the corresponding bit in

    運算符對兩個數值表達式中位置相同的位執行按位比較，並且按下表設置
  15. Computes the bitwise xor of two integer values and returns an integer

    計算兩個整數值的按位異或，並且返回一個整數。
  16. Instruction computes the bitwise xor of the top two values on the stack and leaves the result on the stack

    指令計算位於堆棧頂部的兩個值的按位異或，並且將結果留在堆棧上。
  17. Is a numeric value representing the bitwise exclusion exclusive bitwise disjunction of two numeric bit patterns

    是代表兩個數值位組合模式的按位異或運算（互斥按位析取）的數值。
  18. Computes the bitwise xor of the top two values on the evaluation stack, pushing the result onto the evaluation stack

    計算位於計算堆棧頂部的兩個值的按位異或，並且將結果推送到計算堆棧上。
  19. And finally, the complement operator inverts the value of each bit of the operand : if the operand bit is 1 the result is 0 and if the operand bit is 0 the result is 1

    最後，上面的互補運算符（按位異或）對兩個操作數的每個比特位進行值的轉化:操作數比特位是1的（另一個為0 ）運算后的（比特位）結果為1 ，比特位為0 （而另一個操作數為1的） ，計算后結果為1
  20. Warning c6313 : incorrect operator : zero - valued flag cannot be tested with bitwise - and

    警告c6313 ：運算符不正確:不能使用按位與來測試零值標志。
分享友人
分享到 Line

分享到臉書